Evaluating recovery, cost, and throughput of different concentration methods for SARS-CoV-2 wastewater-based epidemiology

Making waves: Plausible lead time for wastewater based epidemiology as an early warning system for COVID-19

Wastewater-based epidemiology (WBE) has emerged as a useful tool in the fight to track and contain COVID-19 spread within communities. One of the motives behind COVID-19 WBE efforts is the potential for 'early warning' of either the onset of disease in a new setting or changes in trends in communities where disease is endemic. Many initial reports of the early warning potential of WBE have relied upon retrospective sample analysis, and delays in WBE analysis and reporting should be considered when evaluating the early warning potential of WBE that enable public health action. Our purpose in this manuscript is to establish a framework to critique the potential of WBE to serve as an early warning system, with special attention to the onset of viral shedding and the differential between results reporting for WBE and clinical testing. While many uncertainties remain regarding both COVID-19 clinical presentation and technical factors influencing WBE results, our analysis suggests at most a modest lead time interval ranging from six days for clinical testing to four days for WBE during community-level wastewater surveillance where clinical testing is accessible on-demand with a rapid time to results. This potential lead time for WBE subsequently increases in settings with limited clinical testing capacity or utilization. Care should be taken when reporting 'early detection' of COVID-19 disease trends via WBE to consider underlying causes (e.g., clinical testing lag or delayed result reporting) to avoid misrepresenting WBE potential.

A rapid and simple protocol for concentration of SARS-CoV-2 from sewage

The aim of this study was to set up a simple protocol to concentrate SARS-CoV-2 from sewage, which can be implemented in laboratories with minimal equipment resources. The method avoids the need for extensive purification steps and reduces the concentration of potential inhibitors of RT-qPCR contained in sewage. The concentration method consists of a single step, in which a small volume (40 mL) of sewage sample is incubated with polyaluminum chloride (PAC)(0.00045 N Al³⁺ final concentration). Virus particles adsorbed to the precipitate are collected by low-speed centrifugation, after which the recovered pellet is resuspended with a saline buffer. PAC-concentrated samples are stable for at least one week at 4 °C. Therefore, they may be sent refrigerated to a diagnosis center for RNA extraction and RT-qPCR for SARS-CoV-2 RNA detection if the lab does not have such capabilities. The PAC concentration method produced an average shift of 4.5-units in quantification cycle (Cq) values compared to non-concentrated samples, indicating a 25-fold increase in detection sensitivity. The lower detection limit corresponded approximately to 100 viral copies per ml. Kappa index indicated substantial agreement between PAC and polyethylene glycol (PEG) precipitation protocols (k = 0.688, CI 0.457-0.919). This low-cost concentration protocol could be useful to aid in the monitoring of community circulation of SARS-CoV-2, especially in low- and middle-income countries, which do not have massive access to support from specialized labs for sewage surveillance.