Controlled Experimental Study on Removing Diesel Oil Spillages Using Agricultural Waste Products

Development of oil-spill sorbent from straw biomass waste: Experiments and modeling studies

The recovery of oil spilled on land or water has become an important issue due to environmental regulations. Canadian biomasses as fibrous materials are naturally renewable and have the potential to absorb oil-spills at different ranges. In this work, four Canadian biomasses were examined in order to evaluate their oil affinities and study parameters that could affect oil affinity when used as sorbent, such as average particle size, surface coating and reusability. Moreover, one oil sorption model was adopted and coupled with another developed model to approximate and verify the experimental findings of the oil sorbent biomasses. At an average particle size of 150-1000 μm, results showed that barley straw biomass had the highest absorbency value at 6.07 g/g, while flax straw had the lowest value at 3.69 g/g. Wheat and oat straws had oil absorbency values of 5.49 and 5.00 g/g, respectively. An average particle size of 425-600 μm indicated better absorbency values for oat and wheat straws. Furthermore, the thermal stability study revealed major weight recovery for two flame retardant coatings at hemicellulose and lignocellulose degradation temperature ranges. It was also found that oat straw biomass could be regenerated and used for many sorption/desorption cycles, as the reusability experiment showed only a 18.45% reduction in the oil absorbency value after six consecutive cycles. The developed penetration absorbency (PA) model showed oat straw adsorbed oil at the inter-particle level; and, the results of the sorption capacity model coupled with the PA model excellently predicted the oil sorption of raw and coated oat straws.

Poly(alkoxysilane) reusable organogels for removal of oil/organic solvents from water surface

Novel poly(alkoxysilane)s with high oil and organic solvent absorbencies were prepared by a bulk polymerization technique via the condensation of 1,3-benzenedimethanol with different lengths of alkoxysilanes at 160 °C without using a catalyst. The influence of the length of the alkoxysilane on the polymer properties and swelling ratios was investigated. Swelling experiments in various solvents indicated that these cross-linked poly(alkoxysilane)s can be used as absorbents for oils and oil-derived organic solvents. The swelling features of the poly(alkoxysilane)s were determined by solvent absorption tests, swelling kinetics experiments, and desorption kinetics measurements. The absorption capacities of the poly(alkoxysilane)s were 50-725% for various organic solvents and oil derivatives such as gasoline and diesel. The structural and thermal properties of the cross-linked poly(alkoxysilane) polymers were determined by FTIR, solid-state (13)C and (29)Si cross-polarization magic angle spinning (CP-MAS) NMR, and thermal gravimetric analysis (TGA).