Radical Anions, Radical‐Anion Salts, and Anionic Complexes of 2,1,3‐Benzochalcogenadiazoles

Photophysical and redox properties of new donor-acceptor-donor (DAD) compounds containing benzothiadiazole (A) and dimethyldihydroacridine (D) units: a combined experimental and theoretical study

Four donor-acceptor-donor compounds consisting of 9,9-dimethyl-9,10-dihydroacridine donors differently linked to a benzothiadiazole acceptor were designed using DFT calculations and synthesized, namely 4,7-bis(4-(9,9-dimethyl-9,10-dihydroacridine)phenyl)benzo[c][1,2,5]thiadiazole (1), 4,7-bis(2,5-dimethyl-4-(9,9-dimethyl-9,10-dihydroacridine)phenyl)benzo[c][1,2,5]thiadiazole (2), 4,7-bis(3,5-di(9,9-dimethyl-9,10-dihydroacridine)phenyl)benzo[c][1,2,5]thiadiazole (3), and 4-(3,5-di(9,9-dimethyl-9,10-dihydroacridine)phenyl)-7-(thiophen-2-yl)benzo[c][1,2,5]thiadiazole (4). As predicted theoretically, all studied compounds were electrochemically active both in the reduction as well as in the oxidation modes. They underwent one electron quasi-reversible reduction. Oxidation of 1 and 2 involved a two electron process transforming them into dications and carrying out, in parallel, their dimerization. Oxidation of 3 and 4 resulted in their oligomerization (polymerization). The electrochemically determined ionisation potentials (IP) of 1-4 were similar, covering a narrow range of 5.28-5.33 eV and were consistent with DFT calculations. Larger differences were found for experimentally determined electron affinity (EA) values, being significantly lower for 2 (|EA| = 2.59 eV) as compared to 1, 3 and 4 whose |EA| values were higher by 0.15-0.25 eV, again consistent with DFT calculations. DFT calculations predict positive values of ΔE(S1-T1) for all compounds i.e. in the range of 0.18 eV to 0.43 eV for 1, 3 and 4 and a significantly lower value for 2 (0.06 eV), indicating a possible RISC process in this case. DFT calculations of ΔE(S1-T2) lead to negative and very small values for 2-4 implying a possible involvement of higher lying triplets in the generation of singlet excitons. The investigated derivatives exhibited fluorescence in the orange-red spectral range (550-770 nm) and were strongly dependent on the solvent polarity. The highest PLQY value of 37% was measured for 1 in toluene. The PLQY values significantly improved upon deoxygenation of the studied solutions. Solid state samples also exhibited higher PLQY values as compared to those determined for DCM solutions. These findings were rationalized by partial suppression of the vibrationally induced emission quenching in the solid state due to the intermolecular interaction confinement.

Halide Complexes of 5,6-Dicyano-2,1,3-Benzoselenadiazole with 1 : 4 Stoichiometry: Cooperativity between Chalcogen and Hydrogen Bonding

The [M4 -Hal]- (M=the title compound; Hal=Cl, Br, and I) complexes were isolated in the form of salts of [Et4 N]+ cation and characterized by XRD, NMR, UV-Vis, DFT, QTAIM, EDD, and EDA. Their stoichiometry is caused by a cooperative interplay of σ-hole-driven chalcogen (ChB) and hydrogen (HB) bondings. In the crystal, [M4 -Hal]- are connected by the π-hole-driven ChB; overall, each [Hal]- is six-coordinated. In the ChB, the electrostatic interaction dominates over orbital and dispersion interactions. In UV-Vis spectra of the M+[Hal]- solutions, ChB-typical and [Hal]- -dependent charge-transfer bands are present; they reflect orbital interactions and allow identification of the individual [Hal]- . However, the structural situation in the solutions is not entirely clear. Particularly, the UV-Vis spectra of the solutions are different from the solid-state spectra of the [Et4 N]+ [M4 -Hal]- ; very tentatively, species in the solutions are assigned [M-Hal]- . It is supposed that the formation of the [M4 -Hal]- proceeds during the crystallization of the [Et4 N]+ [M4 -Hal]- . Overall, M can be considered as a chromogenic receptor and prototype sensor of [Hal]- . The findings are also useful for crystal engineering and supramolecular chemistry.

Tuning Molecular Electron Affinities against Atomic Electronegativities by Spatial Expansion of a π-System

2,1,3-Benzochalcogenadiazoles C₆ R₄ N₂ E (E/R; E=S, Se, Te; R=H, F, Cl, Br, I) and C₆ H₂ R₂ N₂ E (E/R'; E=S, Se, Te; R=Br, I) are 10π-electron hetarenes. By CV/EPR measurements, DFT calculations, and QTAIM and ELI-D analyses, it is shown that their molecular electron affinities (EAs) increase with decreasing Allen electronegativities and electron affinities of the E and non-hydrogen R (except Cl) atoms. DFT calculations for E/R+e⋅^- →[E/R]⋅^- electron capture reveal negative ΔG values numerically increasing with increasing atomic numbers of the E and R atoms; positive ΔS has a minor influence. It is suggested that the EA increase is caused by more effective charge/spin delocalization in the radical anions of heavier derivatives due to contributions from diffuse (a real-space expanded) p-AOs of the heavier E and R atoms; and that this counterintuitive effect might be of the general character.

Disclosing Cyclic(Alkyl)(Amino)Carbenes as One-Electron Reductants: Synthesis of Acyclic(Amino)(Aryl)Carbene-Based Kekulé Diradicaloids

Herein, we disclose cyclic(alkyl)(amino)carbenes (CAACs) to be one-electron reductants under the formation of a transient radical cation as indicated by EPR spectroscopy. The disclosed CAAC reducing reactivity was used to synthesize acyclic(amino)(aryl)carbene-based Thiele and Chichibabin hydrocarbons, a new class of Kekulé diradicaloids. The results demonstrate CAACs to be potent organic reductants. Notably, the acyclic(amino)(aryl)carbene-based Chichibabin's hydrocarbon shows an appreciable population of the triplet state at room temperature, as evidenced by both variable-temperature NMR and EPR spectroscopy.

Acid-Base and Anion Binding Properties of Tetrafluorinated 1,3-Benzodiazole, 1,2,3-Benzotriazole and 2,1,3-Benzoselenadiazole

The influence of fluorination on the acid-base properties and the capacity of structurally related 6-5 bicyclic compounds - 1,3-benzodiazole 1, 1,2,3-benzotriazole 2 and 2,1,3-benzoselenadiazole 3 to σ-hole interactions, i. e. hydrogen (1 and 2) and chalcogen (3) bondings, is studied experimentally and computationally. The tetrafluorination increases the Brønsted acidity of the diazole and triazole scaffolds and the Lewis acidity of selenadiazole scaffold decreases the basicity. Increased Brønsted acidity facilitates anion binding via the formation of hydrogen bonds; particularly, tetrafluorinated derivative of 1 (compound 4) binds Cl^- . Increased Lewis acidity of tetrafluorinated derivative of 3 (compound 10), however, is not enough for binding with Cl^- and F^- via chalcogen bonds in contrast to previously studied Te analog of 10. It is suggested that the maximum positive values of molecular electrostatic potential at the σ-holes, V_S,max , can be a reasonable metric for design and synthesis of new anion receptors with selenadiazole-diazole/triazole hybrids as a special target. Related chlorinated compounds are also discussed.

1,2,5-Thiadiazole 1,1-dioxides and Their Radical Anions: Structure, Properties, Reactivity, and Potential Use in the Construction of Functional Molecular Materials

This work provides a summary of the preparation, structure, reactivity, physicochemical properties, and main uses of 1,2,5-thiadiazole 1,1-dioxides in chemistry and material sciences. An overview of all currently known structures containing the 1,2,5-thiadiazole 1,1-dioxide motif (including the anions radical species) is provided according to the Cambridge Structural Database search. The analysis of the bond lengths typical for neutral and anion radical species is performed, providing a useful tool for unambiguous assessment of the valence state of the dioxothiadiazole-based compounds based solely on the structural data. Theoretical methodologies used in the literature to describe the dioxothiadiazoles are also shortly discussed, together with the typical 'fingerprint' of the dioxothiadiazole ring reported by means of various spectroscopic techniques (NMR, IR, UV-Vis). The second part describes the synthetic strategies leading to 1,2,5-thiadiazole 1,1-dioxides followed by the discussion of their electrochemistry and reactivity including mainly the chemical methods for the successful reduction of dioxothiadiazoles to their anion radical forms and the ability to form coordination compounds. Finally, the magnetic properties of dioxothiadiazole radical anions and the metal complexes involving dioxothiadiazoles as ligands are discussed, including simple alkali metal salts and d-block coordination compounds. The last section is a prospect of other uses of dioxothiadiazole-containing molecules reported in the literature followed by the perspectives and possible future research directions involving these compounds.

A Sterically Hindered Derivative of 2,1,3-Benzotelluradiazole: A Way to the First Structurally Characterised Monomeric Tellurium-Nitrogen Radical Anion

Interaction of the tetradentate redox-active 6,6'-[1,2-phenylenebis(azanediyl)]bis(2,4-di-tert-butylphenol) (H₄ L) with TeCl₄ leads to neutral diamagnetic compound TeL (1) in high yield. The molecule of 1 has a nearly planar TeN₂ O₂ fragment, which suggests the formulation of 1 as Te^II L^2- , in agreement with the results of DFT calculations and QTAIM and NBO analyses. Reduction of 1 with one equivalent of [CoCp₂ ] leads to quantitative formation of the paramagnetic salt [CoCp₂ ]⁺ [1]^.- , which was characterised by single-crystal XRD. The solution EPR spectrum of [CoCp₂ ]⁺ [1]^.- at room temperature features a quintet due to splitting on two equivalent ¹⁴ N nuclei. Below 150 K it turns into a broad singlet line with two weak satellites due to the splitting on the ¹²⁵ Te nucleus. Two-component relativistic DFT calculations perfectly reproduce the a(¹⁴ N) HFI constants and A_∥ (¹²⁵ Te) value responsible for the low-temperature satellite splitting. Calculations predict that the additional electron in 1^.- is localised mainly on L, while the spin density is delocalised over the whole molecule with significant localisation on the Te atom (≥30 %). All these data suggest that 1^.- can be regarded as the first example of a structurally characterised monomeric tellurium-nitrogen radical anion.

Bis(2,1,3-benzotelluradiazolidyl)2,1,3-benzotelluradiazole: a pair of radical anions coupled by TeN chalcogen bonding

Reduction of 2,1,3-benzotelluradiazole (3) yielded a crystalline solid that features a trimeric dianion formally composed of two [3]˙- and one 3 bridged by unusually asymmetric TeN chalcogen bonds. The solid is diamagnetic due to strong antiferromagnetic coupling, as revealed by CASSCF/CASPT2 and BS-DFT.

Design, synthesis and isolation of a new 1,2,5-selenadiazolidyl and structural and magnetic characterization of its alkali-metal salts

A new electron acceptor is synthesized and reduced into its radical-anion isolated in the form of two salts with different structures and magnetic properties.