Effect of polybasic acids on structure of aluminum hydroxycarbonate gel

Synthesis, biological evaluation, and quantitative structure-activity relationship analysis of new Schiff bases of hydroxysemicarbazide as potential antitumor agents

Thirty Schiff bases of hydroxysemicarbazide (Ar-CH=NNHCONHOH) have been synthesized and tested against L1210 murine leukemia cells. The IC(50) values were found to be in a range from 2.7 x 10(-6) to 9.4 x 10(-4) M. A total of 17 out of the 30 compounds had higher inhibitory activities than hydroxyurea (an anticancer drug currently used for the treatment of melanoma, leukemia, and ovarian cancer) against L1210 cells. Six compounds with IC(50) values in micromolar range were 11- to 30-fold more potent than hydroxyurea (IC(50) = 8.2 x 10(-5) M). The partition coefficient (log P) and ionization constants (pK(a)) of a model compound [1-(3-trifluoromethylbenzylidene)-4-hydroxysemicarbazide, 1] were measured by the shake-flask method, and the measured log P was used to derive Hansch-Fujita pi constant of -CH=NNHCONHOH. On the basis of the newly derived pi and those of other moieties, the partition coefficients (SlogP) of the other 29 compounds were calculated by the summation of pi values. Quantitative structure-activity relationship (QSAR) analysis showed that, besides the essential pharmacophore (-NHCONHOH), hydrophobicity (SlogP), molecular size/polarizability (calculated molar refractivity), and the presence of an oxygen-containing group at the ortho position (I) were important determinants for the antitumor activities. In conclusion, the results obtained in this study show that several Schiff bases of hydroxysemicarbazide are potent inhibitors of tumor cells and warrant further investigation as cancer chemotherapeutic agents.

Interaction of liquid aluminium phosphate and aluminium hydroxide with the gastric acid profile. Influence of food components and timing of meals

AlPO4 is generally perceived as a particularly weak antacid. Its neutralizing capacity, when evaluated with the classical Fordtran test at the pH 3 standard, is several times smaller than that of Al(OH)3, which is considered a particularly potent antacid. This difference of in vitro reactivity of the two antacids is largely due to the fact that the pKa value is considerably lower for AlPO4 than for Al(OH)3. The object of this study was to evaluate in vivo and in vitro the impact of the pKa value of these antacids on their efficacy at low pH values and the modulation of their neutralizing capacity through proteins. Since both preparations display a much closer antacid activity at pH 2, we felt it appropriate to reevaluate the comparative in vivo neutralizing capacity of the two antacids at doses matched with their in vitro reactivity at pH 2. In vivo antacid effects were measured by ambulant pH-metry in 18 healthy volunteers after randomized ingestion of carbohydrate or protein meals. Antacid or placebo medication was given 1 and 3 h after meals. At pH 3.0, the standard milieu of the Fordtran test, preparation A, composed of Al(OH)3 and a small fraction of Mg(OH)2, displayed in vitro a neutralizing capacity of 4.4 mmol/ml, whereas this was 0.18 mmol/ml for preparation B, composed solely of AlPO4 (p less than 0.001). When tested at pH 1, 1.5, and 2, however, the ratio between A and B was below 2.(ABSTRACT TRUNCATED AT 250 WORDS)

Effect of shear on the apparent viscosity of amorphous carbonate ion containing aluminum hydroxide suspensions

The application of shear to carbonate ion containing aluminum hydroxide suspensions caused a change in the apparent viscosity by two possible mechanisms: change in the surface charge because of desorption of specifically adsorbed carbonate ion, and aggregate dispersal and formation of more extensive particle networks. The desorption of specifically adsorbed carbonate ion is related to the expansion of the air-liquid interface during shear. Shear-inducing processing equipment which generates a minimal amount of new air-liquid interface was found to produce the least change in pH and, consequently, in surface charge. However, viscosity increases caused by aggregate dispersal and formation of more extensive particle networks may occur without a shear-induced change in surface charge.

Desorption of carbonate from aluminum hydroxycarbonate gel by nitrogen purging

Carbonate was completely desorbed from amorphous aluminum hydroxycarbonate gel by purging with nitrogen. The reversibility of carbonate adsorption suggests that aluminum hydroxycarbonate particles are composed of planes of aluminum hydroxide with carbonate adsorbed at edge aluminum sites. A slow-reacting phase which was identified as a precursor of gibbsite, formed when the carbonate/aluminum molar ratio was less than 0.20.

Mechanism of interaction between polyols and aluminum hydroxide gel

IR spectroscopy and changes in the rate of acid neutralization were used to study the interaction between various polyols and aluminum hydroxide. Hydrogen bonding is responsible for this interaction, although structural requirements limit the polyols that interact with aluminum hydroxide. Mannitol and sorbitol, both linear polyols, interacted with sulfate-containing aluminum hydroxide gel and aluminum hydroxycarbonate gel, while inositol, a cyclic polyol, did not interact. The adsorbed polyol has the favorable effect of inhibiting the polymerization reaction that occurs on aging and the negative effect of reducing the rate of acid neutralization. Thus, the specific polyol and concentration must be carefully selected to maximize the desired effect of stabilizing the gel structure. The presence of mannitol in the reaction medium during precipitation did not significantly enhance gel structure stability, probably because the mannitol was desorbed during the washing process as a consequence of the weak adsorption forces.