Ultra-fast liquid chromatography with tandem mass spectrometry determination of ochratoxin A in traditional Chinese medicines based on vortex-assisted solid-liquid microextraction and aptamer-affinity column clean-up

Determination of ochratoxin A in licorice extract based on modified immunoaffinity column clean-up and HPLC analysis

Contamination of ochratoxin A (OTA) is a common concern for the quality and safety of licorice and its derivatives, while their complex sample matrices always restrict the monitoring and regulation of OTA. Taking the much more concentrated and complicated licorice extract as the representative, a modified analysis method was established for OTA by HPLC. Parameters were comprehensively investigated based on liquid-liquid extraction and immunoaffinity column clean-up. In comparison to other methods, the developed method achieved effective clean-up efficiency and selectivity without tedious procedures and specialized instrumentation. Good linearity (R2 ≥0.9995), low LOD/LOQ (0.10 μg/kg/0.33 μg/kg), and satisfactory recovery (90.0%-96.4%, RSDs <7.0%) indicated the satisfactory sensitivity and reliability of the method. In addition, the applicability and robustness of the method was demonstrated by the analysis of large numbers of licorice extract samples. It is noteworthy that 66.5% of 176 samples were contaminated with OTA, while the concentrations of 9.1% of samples exceeded the maximum limit (ML, 80 μg/kg) defined by the EU. On account of the high contamination frequency and broad concentration range of OTA, the daily intake limit of licorice extract was preliminarily determined to be 123.18-123.93 g/day (chronic exposure) and 24.24 g/day (acute exposure), indicating a potential of acute risk through daily exposure. This calls for improved supervision and regulation for OTA contamination in licorice samples. This study suggests a prospective option for the efficient determination and routine monitoring of OTA in licorice and its derivatives, simultaneously providing a valuable data base for its health risk assessment.

Solid-phase extraction techniques based on nanomaterials for mycotoxin analysis: An overview for food and agricultural products

Mycotoxin contamination is a globally concerned problem for food and agricultural products since it may directly or indirectly induce severe threats to human health. Sensitive and selective screening is an efficient strategy to prevent or reduce human and animal exposure to mycotoxins. However, enormous challenges exist in the determination of mycotoxins, arising from complex sample matrices, trace-level analytes, and the co-occurrence of diverse mycotoxins. Appropriate sample preparation is essential to isolate, purify, and enrich mycotoxins from complicated matrices, thus decreasing sample matrix effects and lowering detection limits. With the cross-disciplinary development, new solid-phase extraction strategies have been exploited and integrated with nanotechnology to meet the challenges of mycotoxin analysis. This review summarizes the advance and progress of solid-phase extraction techniques as the methodological solutions for mycotoxin analysis. Emphases are paid on nanomaterials fabricated as trapping media of SPE techniques, including carbonaceous nanoparticles, metal/metal oxide-based nanoparticles, and nanoporous materials. Advantages and limitations are discussed, along with the potential prospects. This article is protected by copyright. All rights reserved.

A facile "turn-on" fluorescent aptasensor for simultaneous detection of dual mycotoxins in traditional Chinese medicine based on graphene oxide and FRET

Mycotoxin is a common sort of harmful contaminant in traditional Chinese medicine (TCM), which is in a great demand of controlling. On this account, a facile "turn-on" fluorescent aptasensor based on fluorescence resonance energy transfer (FRET) for simultaneous detection of patulin (PAT) and zearalenone (ZEN) was developed. In this study, the aptamers of PAT and ZEN were labeled by FAM and Cy3, respectively, serving as fluorescence probes. Both aptamers could adsorb on the surface of graphene oxide (GO) via π-π stacking, which will consequently result in the occurrence of FRET between the fluorophores and GO. In the absence of the targets, the fluorescence would be quenched "off". In the presence of any of the dual mycotoxins, the corresponding aptamers would interact with the targets and release from GO due to the conformational variation, leading to a fluorescence "turn-on" effect. The limit of detection of this difunctional aptasensor was 2.29 nM for PAT and 0.037 nM for ZEN, respectively. This aptasensing platform exhibited satisfactory selectivity against interferents and reliability in real TCM sample detection. To our knowledge, it is the first aptasensor based on GO and FRET that realizes simultaneous detection of dual mycotoxin in TCM. Moreover, the measurement takes merely ∼60 min, does not need complicated pretreatment, and uses only inexpensive aptamer and GO as consuming materials. To sum up, this aptasensor exhibits great potential in fast, cost-effective and reliable simultaneous detection of multiple targets, and is expected to contribute to the quality and safety control of TCM.

Immunoaffinity Extraction and Alternative Approaches for the Analysis of Toxins in Environmental, Food or Biological Matrices

The evolution of instrumentation in terms of separation and detection allowed a real improvement of the sensitivity and analysis time. However, the analysis of ultra-traces of toxins in complex samples requires often a step of purification and even preconcentration before their chromatographic analysis. Therefore, immunoaffinity sorbents based on specific antibodies thus providing a molecular recognition mechanism appear as powerful tools for the selective extraction of a target molecule and its structural analogs to obtain more reliable and sensitive quantitative analysis in environmental, food or biological matrices. This review focuses on immunosorbents that have proven their efficiency in selectively extracting various types of toxins of various sizes (from small mycotoxins to large proteins) and physicochemical properties. Immunosorbents are now commercially available, and their use has been validated for numerous applications. The wide variety of samples to be analyzed, as well as extraction conditions and their impact on extraction yields, is discussed. In addition, their potential for purification and thus suppression of matrix effects, responsible for quantification problems especially in mass spectrometry, is presented. Due to their similar properties, molecularly imprinted polymers and aptamer-based sorbents that appear to be an interesting alternative to antibodies are also briefly addressed by comparing their potential with that of immunosorbents.

A double-recognized aptamer-molecularly imprinted monolithic column for high-specificity recognition of ochratoxin A

In this study, a double-recognized aptamer-molecularly imprinted monolithic column (Apt-MIP monolithic column) was prepared by introducing both aptamer and MIP to reduce non-specific adsorption. Its preparation parameters such as the time of photo-initiation, the dosage of photo-initiator and the concentration of aptamer were investigated in detail. The recovery ratios of ochratoxin A (OTA) to ochratoxin B (OTB) on Apt-MIP monolithic column, Apt monolithic column and MIP monolithic column were 116.1, 40.8 and 69, respectively. Even if the concentration of OTB was 10 times that of OTA, the recovery of OTB was only about 2.9%. Applied to beer samples, the prepared Apt-MIP monolithic column drastically resisted background adsorption and the high-specificity recognition for OTA was obtained with the recoveries of 95.5-105.9%. This work provided a simple and effective method to selectively identify OTA from complex samples.

Regeneration and Reuse of Immunoaffinity Column for Highly Efficient Clean-Up and Economic Detection of Ochratoxin A in Malt and Ginger

Immunoaffinity columns (IACs) are most popularly used for mycotoxin clean-up in complex matrices prior to chromatographic analysis. But, their high cost has limited their wide application and the regeneration of IACs for multiple instances of reuse is important. This study aimed to investigate the feasibility of regeneration and reuse of IACs for purification of ochratoxin A (OTA) in spiked raw malt and dried ginger samples followed by high performance liquid chromatography-fluorescence detection. After each use, the IACs were filled with phosphate buffer saline (PBS) as the preservation solution and stored at 8 °C overnight for regeneration and reuse until the recovery rate was <70%. The results showed that matrix type, preparation procedure, and pH value of sample extraction exhibited major effects on the reuse of IACs for OTA clean-up. While, after modifying the sample preparation procedure using water as the diluent and the solution at a pH of 7 to 8, the IACs could be used eight and three times for the spiked raw malt and dried ginger samples with OTA after regeneration. Regarding the traditional procedure recommended in Chinese Pharmacopoeia (2015 edition), the IACs could be used for three and two times for the spiked raw malt and dried ginger samples with OTA, respectively. Therefore, the corresponding experimental cost could be reduced to one-eighth and one-third of the original cost. This is the first study on the regeneration and reuse of IACs for OTA clean-up in complex Chinese herbal medicines, providing a green and economical tool for a large number of samples analysis with low cost.

A Review of Current Methods for Analysis of Mycotoxins in Herbal Medicines

The presence of mycotoxins in herbal medicines is an established problem throughout the entire world. The sensitive and accurate analysis of mycotoxin in complicated matrices (e.g., herbs) typically involves challenging sample pretreatment procedures and an efficient detection instrument. However, although numerous reviews have been published regarding the occurrence of mycotoxins in herbal medicines, few of them provided a detailed summary of related analytical methods for mycotoxin determination. This review focuses on analytical techniques including sampling, extraction, cleanup, and detection for mycotoxin determination in herbal medicines established within the past ten years. Dedicated sections of this article address the significant developments in sample preparation, and highlight the importance of this procedure in the analytical technology. This review also summarizes conventional chromatographic techniques for mycotoxin qualification or quantitation, as well as recent studies regarding the development and application of screening assays such as enzyme-linked immunosorbent assays, lateral flow immunoassays, aptamer-based lateral flow assays, and cytometric bead arrays. The present work provides a good insight regarding the advanced research that has been done and closes with an indication of future demand for the emerging technologies.

Selective tools for the solid-phase extraction of Ochratoxin A from various complex samples: immunosorbents, oligosorbents, and molecularly imprinted polymers

The evolution of instrumentation in terms of separation and detection has allowed a real improvement of the sensitivity and the analysis time. However, the analysis of ultra-traces of toxins such as ochratoxin A (OTA) from complex samples (foodstuffs, biological fluids…) still requires a step of purification and of preconcentration before chromatographic determination. In this context, extraction sorbents leading to a molecular recognition mechanism appear as powerful tools for the selective extraction of OTA and of its structural analogs in order to obtain more reliable and sensitive quantitative analyses of these compounds in complex media. Indeed, immunosorbents and oligosorbents that are based on the use of immobilized antibodies and of aptamers, respectively, and that are specific to OTA allow its selective clean-up from complex samples with high enrichment factors. Similar molecular recognition mechanisms can also be obtained by developing molecularly imprinted polymers, the synthesis of which leads to the formation of cavities that are specific to OTA, thus mimicking the recognition site of the biomolecules. Therefore, the principle, the advantages, the limits of these different types of extraction tools, and their complementary behaviors will be presented. The introduction of these selective tools in miniaturized devices will also be discussed.

Man-Made Synthetic Receptors for Capture and Analysis of Ochratoxin A

Contemporary analytical methods have the sensitivity required for Ochratoxin A detection and quantification, but direct application of these methods on real samples can be rarely performed because of matrix complexity. Thus, efficient sample pre-treatment methods are needed. Recent years have seen the increasing use of artificial recognition systems as a viable alternative to natural receptors, because these materials seem to be particularly suitable for applications where selectivity for Ochratoxin A is essential. In this review, molecularly imprinted polymers, aptamers and tailor-made peptides for Ochratoxin A capture and analysis with particular attention to solid phase extraction applications will be discussed.

Nanoscaled aptasensors for multi-analyte sensing

Introduction: Nanoscaled aptamers (Aps), as short single-stranded DNA or RNA oligonucleotides, are able to bind to their specific targets with high affinity, upon which they are considered as powerful diagnostic and analytical sensing tools (the so-called "aptasensors"). Aptamers are selected from a random pool of oligonucleotides through a procedure known as "systematic evolution of ligands by exponential enrichment".

Methods: In this work, the most recent studies in the field of aptasensors are reviewed and discussed with a main focus on the potential of aptasensors for the multianalyte detection(s).

Results: Due to the specific folding capability of aptamers in the presence of analyte, aptasensors have substantially successfully been exploited for the detection of a wide range of small and large molecules (e.g., drugs and their metabolites, toxins, and associated biomarkers in various diseases) at very low concentrations in the biological fluids/samples even in presence of interfering species.

Conclusion: Biological samples are generally considered as complexes in the real biological media. Hence, the development of aptasensors with capability to determine various targets simultaneously within a biological matrix seems to be our main challenge. To this end, integration of various key scientific dominions such as bioengineering and systems biology with biomedical researches are inevitable.