Active streaming in human thrombosthenin solutions

Mesoscopic analysis of motion and conformation of cross-bridges

The orientation of a cross-bridge is widely used as a parameter in determining the state of muscle. The conventional measurements of orientation, such as that made by wide-field fluorescence microscopy, electron paramagnetic resonance (EPR) or X-ray diffraction or scattering, report the average orientation of 10¹²-10⁹ myosin cross-bridges. Under conditions where all the cross-bridges are immobile and assume the same orientation, for example in normal skeletal muscle in rigor, it is possible to determine the average orientation from such global measurements. But in actively contracting muscle, where a parameter indicating orientation fluctuates in time, the measurements of the average value provide no information about cross-bridge kinetics. To avoid problems associated with averaging information from trillions of cross-bridges, it is necessary to decrease the number of observed cross-bridges to a mesoscopic value (i.e. the value affected by fluctuations around the average). In such mesoscopic regimes, the averaging of the signal is minimal and dynamic behavior can be examined in great detail. Examples of mesoscopic analysis on skeletal and cardiac muscle are provided.

Translational motion of actin filaments in the presence of heavy meromyosin and MgATP as measured by Doppler broadening of laser light scattering

Intensity fluctuations of laser light scattering were utilized in order to follow enhancement of translational motion of the actin-heavy meromyosin (HMM) complex in extremely dilute solutions accompanied by the hydrolysis of MgATP. Such enhancement was anticipated on the basis of the idea that active streaming along actin filaments should be associated with their mechanochemical reactivity. Native tropomyosin was added in order to stabilize actin in its filamentous form, thus allowing the reduction of actin concentration below 50 micrograms/ml to enable free movement of neighboring filaments and yet give a reliable signal. Analysis of the data in terms of Doppler broadening led to an approximate evaluation of the average velocity of translation of the mobile filaments. This velocity was found to increase with increasing HMM concentration up to a maximum attained at a molar ratio HMM/actin of 1:2, and then decreased. Total intensity measurements indicate that the mobile scatterer is actually a complex of HMM with an isolated actin filament. HMM subfragment-1 was found to be ineffective. These results suggest that cooperation between the two myosin heads is necessary for efficient induction of active streaming along isolated actin filaments.

Tension development in skinned glycerinated rabbit psoas fiber segments irrigated with soluble myosin fragments

Single glycerinated rabbit psoas muscle fibers were skinned by splitting them lengthwise. The fiber segments thus obtained were more easily accessible to solutes in the surrounding medium than the intact fibers. Using such segments, active tension could be fully abolished by adding N-ethylmaleimide under conditions which lead to inhibition of actin activation of the ATPase activity of myosin. Such muscles could, however, develop tension after irrigation with myosin or with the water-soluble active myosin fragments heavy meromyosin (HMM) or its subfragment 1 (HMM-S1). The induced tensions increased with increasing protein concentration in the irrigating solution. At any given protein concentration, the tension generated by myosin was larger than that produced by HMM which was, in turn, greater than that induced by HMM-S1 e.g. at 15 mg/ml protein the tensions produced by these three myosin moieties were 44.0, 14.0 and 2.8 g/cm2, respectively. The tension was found to be intimately associated with ATP splitting; thus, HMM and HMM-S1 which have been treated with reagents abolishing actin-activated ATPase failed to induce tension development. A contractile force may thus be generated through the interaction with actin of the water-soluble, enzymatically active, myosin subfragments involving the splitting of ATP.

Fibrin-blood platelet interaction in a contracting clot

The interaction of fibrin and blood platelets was studied by measuring tension development in clots containing different ratios of these two components. Isometric tension attained a saturation value (MT) when plotted as a function of the concentration of either component at a constant concentration of the other. The value of MT increases linearly with the minimal platelet concentration (Ps) required in order to reach saturation at various different fibrin concentrations. A linear relationship also holds in a plot of Ps versus the logarithm of the corresponding fibrin concentration. When the cylindrical clots contracted isotonically, the velocity, normalized with respect to the momentary length, was found to be constant. This velocity decreased in an hyperbolic manner with increasing fibrin concentration at a constant concentration of blood platelets. The results are interpreted in terms of a three-dimensional network in which the blood platelets serve as contractile cross-bridges connecting fibrin fibres. Tension development is assumed to be accompanied by the reduction of the angle between fibrin fibres. An attempt was made to calculate the isometric tension developed by a platelet.