Hydrogen sulfide removal by copper sulfate circulation method

Regenerative one-stage catalytic absorption process with cupric ions for removal of reduced sulfur compounds in polluted air

Reduced volatile sulfur compounds emitted from e.g. livestock production and biogas production facilities contribute to general air pollution and local odour nuisance. Improved technologies are required to mitigate the emissions of both hydrogen sulfide and organic sulfur compounds. The present study examines the oxidative absorption of reduced sulfur compounds, i.e. hydrogen sulfide, methanethiol and dimethyl sulfide in a wet oxidation process with cupric chloride. It was found that this process efficiently removes both hydrogen sulfide and methanethiol with removal efficiencies >94% under all process conditions tested, while the removal of dimethyl sulfide was in the range 20-40%. The main products determined were dimethyl disulfide, dimethyl trisulfide and elemental sulfur. It was shown that the process was more efficient than the similar process with ferric ions and higher removal could be obtained with lower residence times. Furthermore, though employing cupric ion as metal catalysts results in the production of gaseous sulfur compounds, it is estimated that this process is efficient for deodorization due to the higher odour threshold values of the product compounds and the pH range is optimal for gas streams containing CO2.

Copper Adsorption on Lignin for the Removal of Hydrogen Sulfide

Lignin is currently an underutilized part of biomass; thus, further research into lignin could benefit both scientific and commercial endeavors. The present study investigated the potential of kraft lignin as a support material for the removal of hydrogen sulfide (H2S) from gaseous streams, such as biogas. The removal of H2S was enabled by copper ions that were previously adsorbed on kraft lignin. Copper adsorption was based on two different strategies: either directly on lignin particles or by precipitating lignin from a solution in the presence of copper. The H2S concentration after the adsorption column was studied using proton-transfer-reaction mass spectrometry, while the mechanisms involved in the H2S adsorption were studied with X-ray photoelectron spectroscopy. It was determined that elemental sulfur was obtained during the H2S adsorption in the presence of kraft lignin and the differences relative to the adsorption on porous silica as a control are discussed. For kraft lignin, only a relatively low removal capacity of 2 mg of H2S per gram was identified, but certain possibilities to increase the removal capacity are discussed.