A new salicylate ISFET for the determination of salicylic and acetylsalicylic acid in drugs

Salicylic acid determination in cow urine and drugs using a bienzymatic sensor

An enzymatic biosensor was developed for salicylic acid (salicylate ion) determined using a Clark type gas diffusion electrode and two enzymes (tyrosinase and salicylate hydroxylase) entrapped in a cellulose triacetate membrane. After optimization, the method was applied to the determination of salicylic acid in cow urine. Relatively good recoveries were achieved, between about 83% and 109%, using the calibration curve, and acceptable precision (R.S.D. about 8%). The method is now being tested for the determination of salicylic acid contained in commercially available drug specialities or galenic products. So far agreement with nominal values has been found to be between 75% and 110% with a R.S.D. of less than 8%.

Potentiometric determination of acetylsalicylic acid by sequential injection analysis (SIA) using a tubular salicylate-selective electrode

This paper deals with the development of an automated procedure for formulation assays and dissolution tests based on a sequential injection analysis (SIA) system involving an ion-selective electrode as sensing device. Construction of a tubular salicylate (Sal) selective electrode suitable for potentiometric determination of acetylsalicylic acid (Asa) in pharmaceutical formulations is described. The flow-through electrode is formed by a PVC membrane containing 29.2% (w/w) PVC, 5.8% (w/w) tetraoctylammonium salicylate (ionic sensor), 58.5% o-nitrophenyloctylether (plasticizer) and 6.5% (w/w) p-tert-octylphenol (stabilising additive which increases electrode selectivity). The calibration range is 0.05--10 mM Sal, the limit of detection (LOD) is 0.05 mM Sal, the slope is 56.0 mV per decade at 22 degrees C. The R.S.D. is 0.20% (15 readings) when determining 2.5 mM Sal in standard solution. The electrode is used for sensing Asa after its on-line chemical hydrolysis to Sal in a SIA system. The sampling rate is 6 h(-1) but for the dissolution tests the frequency is increased to 20 h(-1). The SIA set-up is employed for the assay of Asa in plain tablets, composed tablets and effervescent tablets and for performing dissolution tests of normal and sustained release tablets. Results obtained by this technique compare well with those required by the US Pharmacopoeia XXIV.