Oscillatory Lorentz-force-driven flows during potentiostatic current oscillations in magnetic fields

The effect of magnetic field on the dynamics of gas bubbles in water electrolysis

This study determines the effect of the configuration of the magnetic field on the movement of gas bubbles that evolve from platinum electrodes. Oxygen and hydrogen bubbles respectively evolve from the surface of the anode and cathode and behave differently in the presence of a magnetic field due to their paramagnetic and diamagnetic characteristics. A magnetic field perpendicular to the surface of the horizontal electrode causes the bubbles to revolve. Oxygen and hydrogen bubbles revolve in opposite directions to create a swirling flow and spread the bubbles between the electrodes, which increases conductivity and the effectiveness of electrolysis. For vertical electrodes under the influence of a parallel magnetic field, a horizontal Lorentz force effectively detaches the bubbles and increases the conductivity and the effectiveness of electrolysis. However, if the layout of the electrodes and magnetic field results in upward or downward Lorentz forces that counter the buoyancy force, a sluggish flow in the duct inhibits the movement of the bubbles and decreases the conductivity and the charging performance. The results in this study determine the optimal layout for an electrode and a magnetic field to increase the conductivity and the effectiveness of water electrolysis, which is applicable to various fields including energy conversion, biotechnology, and magnetohydrodynamic thruster used in seawater.

Oscillatory Copper Deposition on Conical Iron Electrodes in a Nonuniform Magnetic Field

We report the effect of a magnetic field on the deposition of copper ions on a conically shaped iron probe. In our setup, the magnetic forces and buoyancy are the key factors influencing the electrolyte flow and the mass transfer. Without external current, a spontaneous reduction of copper on the iron cone occurs, known as electroless deposition. Mach–Zehnder and differential interferometry indicate a variation in the concentration of copper ions near the cone. After an initial transient of about 60 s, temporal oscillations in the copper concentration are found under the effect of a magnetic field. In galvanostatic conditions, a similar oscillatory behavior of the concentration of the electrolyte is observed. Numerical simulations show that the oscillations are caused by the magnetic gradient, Lorentz force, and buoyancy force counteracting one another, and the oscillation frequency is estimated analytically based on this mechanism. Furthermore, we present a study on the oscillation frequency for both electroless and galvanostatic conditions with different current densities. The results of this study may stimulate future research aimed at the local control of the deposition rate and the realization of miniaturized, regularly structured deposits using magnetic fields.

Magnetic field effects on copper metal deposition from copper sulfate aqueous solution

Effects of a magnetic field (≤0.5 T) on electroless copper metal deposition from the reaction of a copper sulfate aqueous solution and a zinc thin plate were examined in this study. In a zero field, a smooth copper thin film grew steadily on the plate. In a 0.38 T field, a smooth copper thin film deposited on a zinc plate within about 1 min. Then, it peeled off repeatedly from the plate. The yield of consumed copper ions increased about 2.1 times compared with that in a zero field. Mechanism of this magnetic field effect was discussed in terms of Lorentz force- and magnetic force-induced convection and local volta cell formation.