The use of the 4.5 mm 90° titanium cannulated LC-angled blade plate in tibiotalocalcaneal and complex ankle arthrodesis

Tibiotalocalcaneal Arthrodesis in Severe Hindfoot Deformities

Tibiotalocalcaneal arthrodesis (TTCA) is the most common and reliable procedure in the treatment of patients with end-stage ankle arthritis combined with severe deformity. Many of these patients present with difficult previous sequelae that include nonunion, malunion, broken implants, vascular deficiencies, skin problems, or a combination of the previous. In that complex scenario, sometimes the only alternative treatment is a below-the-knee amputation. Image studies--weightbearing X-rays, tomography, and magnetic resonance - are fundamental to evaluate alignment and bone stock. When all conservative treatments fail to alleviate pain and dysfunction, the combination of osteotomies and arthrodesis is the procedure of choice. Surgical planning needs to be very detailed and thorough with a special focus on bone loss after debridement of non-healthy tissue and removal of metalwork. TTCA with grafting allows for the preservation of the limb in more than 80% of cases but at the expense of many complications with nonunion rates of approximately 20% of cases. There is controversy about the use of a retrograde nail versus specific TTCA plate and screws but results from biomechanical studies do not show a clear superiority of one specific construct. Amputation rates are close to 5% of cases after repeated failed surgeries. Bulk allografts increase the rate of nonunions but apparently do not have an influence on postoperative infections. Valgus positioning of the ankle/hindfoot is paramount to allow for maximal sagittal plane compensation from the midtarsal joints. Most patients are satisfied with the results of these salvage operations. The studies presented in this article have a considerable wide array of different scenarios that obviously bias some of the results, complications, and outcomes but together they present a persuasive pattern toward considering TTC with grafting and nail or plate fixation as a good salvage procedure that may help the patients to maintain their foot and ankle with a better alignment, function, and pain relief.

Osteogenic properties of bioactive sodium titanate/titanium oxide composite coating prepared by anodic oxidation in NaOH electrolyte

Our sodium titanate/titanium oxide coating has excellent osteogenic performance and has potential to be used as a bone repair material.

Conversion of painful tibiotalocalcaneal arthrodesis to total ankle replacement using a 3-component mobile bearing prosthesis

BACKGROUND

The aim of this study was to assess the short-term clinical and radiographic outcomes in patients who underwent conversion of a painful tibiotalocalcaneal arthrodesis to a total ankle replacement.

METHODS

Six patients with painful ankle arthrodesis after tibiotalocalcaneal arthrodesis were included in this study. In all patients, conversion to total ankle replacement was performed using a 3^rd-generation, non-constrained, cementless three-component prosthesis. The outcomes were analyzed at a mean follow-up of 3.4±1.9years (range 1.0-6.5).

RESULTS

One patient with painful arthrofibrosis underwent two open arthrolysis procedures at 1.2 and 5.6 years post index surgery, respectively. No revision of tibial or talar prosthesis components was necessary in this study. All patients reported significant pain relief and significant improvement in functional status.

CONCLUSION

In the present study, the conversion of a painful ankle arthrodesis following tibiotalocalcaneal arthrodesis to a total ankle replacement was a reliable surgical treatment.