Effects of hypochlorite exposure on flux through polyethersulphone ultrafiltration membranes

Effect of Methacrylic Acid Monomer on UV-Grafted Polyethersulfone Forward Osmosis Membrane

UV irradiation is one of the procedures that has been considered for membrane surface graft polymerization. It is commonly utilized for enhancing the wettability of polyethersulfone (PES) membranes. In this research study, the monomer methacrylic acid (MAA) was used for the UV grafting process of a commercial NF2 PES membrane for the preparation of a forward osmosis (FO) membrane. Three different monomer concentrations and three different UV irradiation times were considered. The intrinsic characteristics of both the surface-modified and pristine membranes were determined via a non-pressurized test method. Compared to the NF2 PES, the surface of the modified membranes was rendered more hydrophilic, as the measured water contact angle was reduced considerably from 65° to 32-58°. The membrane surface modification was also confirmed by the data collected from other techniques, such as atomic force microscopy (AFM), field emission-scanning electron microscope (FESEM) and Fourier-transform infrared spectroscopy-attenuated total reflectance (FTIR-ATR). Additionally, the modified membranes exhibited a greater water permeate flux (J_w) compared to the NF2 PES membrane. In this study, the water permeability (A), solute permeability (B) and structural parameter (S) were determined via a two-stage FO non-pressurized test method, changing the membrane orientation. Compared to the FO pressurized test, smaller S values were obtained with significantly high A and B values for the two non-pressurized tests. The adopted method in the current study is more adequate for determining the intrinsic characteristics of FO membranes.

Comparison between a Conventional Anti-Biofouling Compound and a Novel Modified Low-Fouling Polyethersulfone Ultrafiltration Membrane: Bacterial Anti-Attachment, Water Quality and Productivity

In this work, the efficiency of a conventional chlorination pretreatment is compared with a novel modified low-fouling polyethersulfone (PES) ultrafiltration (UF) membrane, in terms of bacteria attachment and membrane biofouling reduction. This study highlights the use of membrane modification as an effective strategy to reduce bacterial attachment, which is the initial step of biofilm formation, rather than using antimicrobial agents that can enhance bacterial regrowth. The obtained results revealed that the filtration of pretreated, inoculated seawater using the modified PES UF membrane without the pre-chlorination step maintained the highest initial flux (3.27 ± 0.13 m³·m⁻²·h⁻¹) in the membrane, as well as having one and a half times higher water productivity than the unmodified membrane. The highest removal of bacterial cells was achieved by the modified membrane without chlorination, in which about 12.07 × 10⁴ and 8.9 × 10⁴ colony-forming unit (CFU) m⁻² bacterial cells were retained on the unmodified and modified membrane surfaces, respectively, while 29.4 × 10⁶ and 0.42 × 10⁶ CFU mL⁻¹ reached the filtrate for the unmodified and modified membranes, respectively. The use of chlorine disinfectant resulted in significant bacterial regrowth.

How microwaves can help to study membrane ageing

This paper studies original protocols of rapid PES/PVP membrane NaOCl degradation allowing at reaching ageing states that are representative of industrial ageing. The long term objective is to propose basis for further fundamental studies aiming at the improvement of the impact of membrane ageing on behaviour in UF (fouling and cleaning mastering). The key of several protocols is the use of ageing acceleration thanks to microwave irradiation, either continuous or pulsed ones, that can be further associated (or not) with short ageing time in UF conditions. To evaluate the representativeness of obtained aged membranes, comparisons are achieved between pristine, voluntary laboratory aged membranes and an industrial membrane at the end of its service-life. Several physico-chemical analyses were used (ATR-FTIR, SEM-EDX, contact angle, SEC-HPLC). Evaluation of UF performances were made in UF of a model protein (Lysozyme, 14,300 g.mol^-1). Finally, the proof of concept is done that conditions using MW exist to reach ageing state representative of industrial ageing.

Impacts of sodium hydroxide and sodium hypochlorite aging on polyvinylidene fluoride membranes fabricated with different methods

This study compared the effects of chemical aging on the polyvinylidene fluoride (PVDF) membranes fabricated with the methods of non-solvent induced phase separation (NIPS) (named NIPS-PVDF) and thermally induced phase separation (TIPS) (named TIPS-PVDF). The chemical solutions of sodium hypochlorite (NaClO) and sodium hydroxide (NaOH) were chosen at the concentration of 5000mg/L. The equivalence of 5 and 10years was respectively selected as the time of aging. The physicochemical evolutions of membrane aging are characterized on the base of morphology analysis, chemical components, permeation ability and mechanical properties. The aging of NIPS-PVDF membrane led to the elimination of surface hydrophilic additives, while NaOH focused on the dehydrofluorination process resulting in the formation of conjugated chains of polyene on the skeleton structure. The chemical components of the surface of TIPS-PVDF membrane were removed continuously during the aging processes of both NaClO and NaOH, which was caused by the saponification of surface additives and the chain scissions of skeleton structure, but without producing any obvious conjugated chains of polyene. All the aging processes led to the increase of contact angle and the decrease of mechanical properties, and the permeability was reduced first and increased later due to the enlargement of surface membrane pores and membrane block. With the influence of membrane aging, selectivity of membrane was decreased (except coliform bacteria). At the beginning of filtration, the turbidity and particle count were at relatively high levels and declined with the filtration process.

Unveiling the Susceptibility of Functional Groups of Poly(ether sulfone)/Polyvinylpyrrolidone Membranes to NaOCl: A Two-Dimensional Correlation Spectroscopic Study

A clear understanding of membrane aging process is essential for the optimization of chemical cleaning in membrane-based facilities. In this study, two-dimensional (2D) Fourier transformation infrared (FTIR) correlation spectroscopy (CoS) analysis was first used to decipher the sequential order of functional group changes of NaOCl-aged poly(ether sulfone)/polyvinylpyrrolidone (PES/PVP) membranes. The synchronous maps showed 12 major autopeaks in total. Based on the asynchronous maps, a similar aging sequence of membrane groups was clearly identified at three pHs (i.e., 6, 8, and 10): 1463, 1440, and 1410 (cyclic C-H structures) > 1662 (amide groups) > 1700 (succinimide groups) > 1320, 1292 (S═O asymmetric) > 1486, 1580 (aromatic structures) > 1241 (aromatic ether bands) > 1105, 1150 cm^-1 (O═S═O symmetric). Among them, membrane chlorination occurred at 1241, 1410, and 1440 cm^-1. Moreover, the initial degradation of PVP and the subsequent transformation of PES could be highly responsible for the increased water permeability and the enlargement of membrane pores, respectively, both leading to serious fouling with humic acid filtration. In summary, the 2D-FTIR-CoS analysis is a powerful approach to reveal the interaction mechanisms of NaOCl-membrane and could be also useful to probe the process of membrane fouling and chemical cleaning.

A comparison study: The different impacts of sodium hypochlorite on PVDF and PSF ultrafiltration (UF) membranes

Chemical ageing of ultrafiltration membranes related to drinking water operation is not a new problem, but literature documenting sieving properties and fouling behaviors of aged membranes are scarce. This paper shows how the surface chemistry evolution of polysulfone (PSF) and polyvinylidene fluoride (PVDF) membranes can lead to the formation of distinct membrane properties when exposed to sodium hypochlorite solutions. The surface physicochemical evolutions of aged membranes are characterized based on chemical composition (ATR-FTIR and XPS), water contact angle analysis, and surface zeta potential test. The results indicate the ageing mechanism and evolutions between PSF and PVDF membranes are totally different. In addition, the retention ability and fouling propensity of the aged membrane are also investigated by three different kinds of foulant (Dextran/HA/BSA). Surface hydrophilization of aged PVDF membrane enhanced its retention toward neutral (Dextran) and hydrophilic charged foulant (BSA), but the fouling type of aged PVDF membranes remained the same, in spite of the initial flux increasing greatly. In terms of PSF membranes, pore enlargement could be verified by a seemingly inconsistent result of dextran sieving experiments and the decreased HA rejection rate. Moreover, the increased negative charge on aged PSF membrane surface have a great impact on its sieving property and fouling propensity, especially for the charged and hydrophilic BSA. With the regression data of Hermia's model, the main fouling type of aged PSF membranes was proven changed to pore blocking, and the changes can ascribe to its altered surface chemical characteristic and pore diameter.

Effects of sodium hypochlorite exposure mode on PES/PVP ultrafiltration membrane degradation

Drinking water production plants using membrane filtration processes report membrane failure issues. According to the literature, membrane degradation is often induced by exposure to sodium hypochlorite, an oxidant widely used during in-place cleanings. The present study focused on quantifying the effect of membrane exposure mode to hypochlorite on properties modifications of a PES/PVP ultrafiltration membrane widely used for drinking water production. For this purpose effects of sodium hypochlorite concentration, contact duration and exposure mode (static or dynamic) were investigated. The pH of the hypochlorite solution was set to 8 as it was demonstrated in numerous previous works that the pH range 7-8 leads to the most severe modification in the membrane characteristics. Membrane degradation was monitored at molecular scale by attenuated total reflectance infrared spectroscopy and at macroscopic scale by pure water permeability and elongation at break measurements. The results obtained in static (soaking) and dynamic (filtration and filtration/backwashing cycles) hypochlorite exposure modes indicated that PES/PVP membrane degradation progress was predominantly governed by hypochlorite oxidation rate. In the tested conditions, mechanical stress (pressure differentials) did not significantly contribute to membrane ageing. The correlation between molecular and macroscopic characterizations demonstrated that PVP degradation is responsible for the membrane integrity loss. A linear relationship between the loss of ductility of the membrane and the progress of the PVP degradation was obtained whatever the exposure mode. Thanks to experiments conducted at various hypochlorite concentrations and exposure durations, the hypochlorite dose parameter (hypochlorite concentration times contact time), widely used in the literature, was demonstrated to be inappropriate to describe the degradation rate: the hypochlorite concentration impact was shown to be dominating the exposure time's one on the degradation rate.

Degradation of poly(ether sulfone)/polyvinylpyrrolidone membranes by sodium hypochlorite: insight from advanced electrokinetic characterizations

Poly(ether sulfone) (PES)/polyvinylpyrrolidone (PVP) membranes are widely used in various industrial fields such as drinking water production and in the dairy industry. However, the use of oxidants to sanitize the processing equipment is known to impair the integrity and lifespan of polymer membranes. In this work we showed how thorough electrokinetic measurements can provide essential information regarding the mechanism of degradation of PES/PVP membranes by sodium hypochlorite. Tangential streaming current measurements were performed with ultrafiltration and nanofiltration PES/PVP membranes for various aging times. The electrokinetic characterization of membranes was complemented by FTIR-ATR spectroscopy. Results confirmed that sodium hypochlorite induces the degradation of both PES and PVP. This latter is easily oxidized by sodium hypochlorite, which leads to an increase in the negative charge density of the membrane due to the formation of carboxylic acid groups. The PVP was also found to be partly released from the membrane with aging time. Thanks to the advanced electrokinetic characterization implemented in this work it was possible for the first time to demonstrate that two different mechanisms are involved in the degradation of PES. Phenol groups were first formed as a result of the oxidation of PES aromatic rings by substitution of hydrogen by hydroxyl radicals. For more severe aging conditions, this membrane degradation mechanism was followed by the formation of sulfonic acid functions, thus indicating a second degradation process through scission of PES chains.