Feasibility of Homodigital Flexor Digitorum Superficialis transposition, a new technique for A2-C1 pulleys reconstruction: A kinematic cadaver study

Prevalence, diagnosis and management of musculoskeletal disorders in elite athletes: A mini-review

Musculoskeletal injuries in elite sports are ones of the most impact issue because their remarkable impact on performance caused by drastic absence of training and competition and a progressive deterioration in physical health, emotional and social athletes' dimensions. Also, the prevalence of epidemiologic research found an incidence of musculoskeletal disorders vary within sports and in elite athletes which is even higher as a consequence of higher demand physical performance. This way, the loss of physical performance due to an sport injury impacts not only the individual economic sphere of the professional but also that ofsports entities, reaching, according to some studies, a loss estimated in the range of 74.7 million pounds. Thus, the purpose of this article is to review and to provide an overview of the most common musculoskeletal injuries in elite sports precipitating factors, clinical presentation, evidence-based diagnostic evaluation, and treatment recommendations with a view to preventing medical conditions or musculoskeletal injuries that may alter performance and general health in the elite athletes.

Dynamic Tendon Grip (DTG™) novel knot array compared to traditional sutures for zone two flexor tendon injury - a biomechanical feasibility study

BACKGROUND

Flexor tendon injuries pose many challenges for the treating surgeon, the principal of which is creating a strong enough repair to allow early active motion, preserving a low-profile of the repair to prevent buckling and subsequent pulley venting. A main concern is that a low-profile repair is prone to gap formation and repair failure. The Dynamic Tendon Grip (DTG™) all suture staple device claims to allow a strong and low-profile repair of the flexor tendon. The purpose of this study is to test the effects of the DTG™ device in early active motion simulation on range of motion, load to failure and gap formation and to compare it to traditional suturing technique.

METHODS

Twelve fresh-frozen cadaveric fingers were assigned to two groups: DTG™ device (n = 9) and traditional suturing (double Kessler 4-core suture and a peripheral suture, n = 3). The deep flexor was incised and repaired in zone 2, and active motion simulation was carried out with a cyclic flexion-extension machine. Finger range of motion and gap formation were measured, as well as load to failure and method of repair failure.

RESULTS

Following motion simulation, ROM decreased from 244.0 ± 9.9° to 234.5 ± 5.8° for the DTG™ device compared to 234.67 ± 6.51° to 211.67 ± 10.50° for traditional suturing. The DTG™ repair demonstrated gap formation of 0.93 ± 0.18 mm in 3 of 8 specimens after applying 1 kg load, which negated after load removal. Load to failure averaged 76.51 ± 23.15 N for DTG™ and 66.31 ± 40.22 N for the traditional repair. Repair failure occurred as the suture material broke for the DTG™ array and at the knot level for the traditional repair.

CONCLUSIONS

The DTG™ all-suture stapling concept achieved a strong low-profile repair in zone 2 flexor tendon injury after active motion simulation. Further clinical studies will be needed to determine the effectiveness of this device compared to traditional techniques.