Cobalt β-tetra(3-oxyflavone/2-(2-oxyphenyl)benzoxazole)phthalocyanines and their carbon nanotube conjugates: Formation, characterization and dopamine electrocatalysis

Immobilized TiO2/ZnO Sensitized Copper (II) Phthalocyanine Heterostructure for the Degradation of Ibuprofen under UV Irradiation

Photocatalytic coatings of TiO2/ZnO/CuPc were developed on stainless steel substrates by subsequent sol gel dip coating for TiO2, spray pyrolysis for ZnO, and spin coating for copper (ii) phthalocyanine (CuPc) deposition. The latter compound was successfully prepared using a Schiff-based process. The materials and coatings developed were characterized by X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, scanning electron microscopy with attached energy dispersive spectroscopy (SEM-EDS), UV-Vis spectroscopy, room temperature photoluminescence (RTPL) spectroscopy, H1-nuclear magnetic resonance (1H-NMR) spectroscopy, C13-nuclear magnetic resonance (13C-NMR) spectroscopy, and matrix-assisted laser desorption/ionization-time of flight (MALDI-TOF) mass spectrometry (MS). The as-deposited TiO2/ZnO/CuPc on stainless steel retained in pristine state the structural and morphological/spectroscopic characteristics of its respective components. Estimated energy band gap values were 3.22 eV, 3.19 eV, 3.19 eV for TiO2, ZnO, TiO2/ZnO respectively and 1.60 eV, 2.44 eV, and 2.92 eV for CuPc. The photocatalytic efficiency of the fabricated TiO2/ZnO/CuPc coatings was tested toward ibuprofen (IBF). After 4 h irradiation under 365 nm UV, an increased degradation of about 80% was achieved over an initial 5 mg/L ibuprofen (IBF). This was much higher compared to about 42% and 18% IBF degradation by TiO2/ZnO and TiO2 thin film, respectively. In all cases, the stability of the best-performing photocatalyst was investigated showing a small decline to 77% of IBF degradation after the 5th cycle run. The effect of pH, reactive oxygen species (ROS) probe, shed light on a possible catalytic mechanism that was suggested.

Metallic Phthalocyanines: impact of the film deposition method on its supramolecular arrangement and sensor performance

This short review gives a concise overview of the impact of deposition methods on the supramolecular arrangement of metallic phthalocyanine films and their applications. Primarily, an introduction about the possible phthalocyanine molecular structures and derivatives obtained from modification on the phthalocyanine rings was presented. The possibility of perfecting/improving the supramolecular arrangement of metallic phthalocyanine (MPcs) films by using different deposition techniques such as Langmuir-Blodgett (LB), Langmuir-Schaefer (LS), Layer-by-Layer (LbL), physical vapor deposition (PVD) and electrodeposition was discussed in further details. Herein, we highlighted some techniques used on the characterization of supramolecular arrangement (morphology, optical properties, and molecular organization), including the impact on sensing applications. The main scope of this short review is focused on the advances made in this research field in the last five years.