Temperature-dependent refractive index issues using a UV-visible detector in high-performance liquid chromatography

Terminally Phosphorylated Triblock Polyethers Acting Both as Templates and Pore-Forming Agents for Surface Molecular Imprinting of Monoliths Targeting Phosphopeptides

The novel process reported here described the manufacture of monolithic molecularly imprinted polymers (MIPs) using a terminally functionalized block copolymer as the imprinting template and pore-forming agent. The MIPs were prepared through a step-growth polymerization process using a melamine-formaldehyde precondensate in a biphasic solvent system. Despite having a relatively low imprinting factor, the use of MIP monolith in liquid chromatography demonstrated the ability to selectively target desired analytes. An MIP capillary column was able to separate monophosphorylated peptides from a tryptic digest of bovine serum albumin. Multivariate data analysis and modeling of the phosphorylated and nonphosphorylated peptide retention times revealed that the number of phosphorylations was the strongest retention contributor for peptide retention on the monolithic MIP capillary column.

G-index: A new metric to describe dynamic refractive index effects in HPLC absorbance detection

High performance liquid chromatography (HPLC) with a solvent gradient and absorbance detection is one of the most widely used methods in analytical chemistry. The observed absorbance baseline is affected by the changes in the refractive index (RI) of the mobile phase. Near the limited of detection, this complicates peak quantitation. The general aspects of these RI-induced apparent absorbance effects are discussed. Two different detectors with fundamentally different optics and flow cell concepts, a variable-wavelength detector equipped with a conventional flow cell and a diode-array detector equipped with a liquid core waveguide flow cell, are compared with respect to their RI behavior. A simple method to separate static - partly unavoidable - RI effects from dynamic RI effects is presented. It is shown that the dynamic RI behavior of an absorbance detector can be well described using a single, relatively easy-to-determine metric called the G-index. The G-index is typically in the order of a few seconds and its sign depends on the optical flow cell concept.

Unusually high fluorescence quantum yield of a homopolyfluorenylazomethine--towards a universal fluorophore

The absolute fluorescence quantum yield (Φfl) of a polyfluorenyl azomethine homopolymer was measured as a function of solvent polarity. The solvent induced and temperature dependent fluorescence of the homopolymer were also investigated and they were compared to the corresponding monomer and copolymer. The Φfl of the homopolymer was consistent (45-70%), regardless of solvent polarity with Stokes shifts up to 7460 cm(-1) in ethanol. In contrast, the Φfl of its corresponding monomer decreased from 60% in ethanol to 1% in toluene, whereas a Φfl < 5% for its analogous copolymer was measured. Moderate fluorescence yields (Φfl ≈ 25%) were also possible in thin film when co-depositing the homopolymer with PMMA. Cryofluorescence was used to probe the excited state deactivation modes. Deactivation by internal conversion was found to compete with fluorescence. The fluorescence deactivation pathways of the homopolymer and its corresponding monomer could be suppressed at 77 K, resulting in fluorescence turn-on. Both fluorophores were found to detect nitroaromatics.

Solvatochromic investigation of highly fluorescent 2-aminobithiophene derivatives

The solvatochromic and electrochemical properties of electronic push-pull 2-aminobithiophenes consisting of an aldehyde and nitro withdrawing groups were examined. With the use of an integrating sphere, the absolute quantum yields of the bithiophenes were measured. They were found to be highly fluorescent (Φfl > 70%), provided the nitro group was not located in the 4'-position. High fluorescence yields were observed regardless of solvent, except for alcohols, notably methanol and ethanol. Cryofluorescence was used to probe the bithiophene temperature dependent excited state deactivation modes. The singlet excited state deactivation mode other than fluorescence was found to be internal conversion involving rotation around the thiophene-thiophene bond. Deactivation by intersystem crossing to the triplet state occurred in ca. 40% only for the unsubstituted 2-aminobithiophene. In contrast, the fluorescence was quenched by photoinduced intramolecular electron transfer when the nitro group was located in the 4'-position of the bithiophene. Both the absorbance and fluorescence of the bithiophenes were found to be solvatochromic with more pronounced solvent dependent shifts being observed with the fluorescence. In fact, both the fluorescence and Stokes shifts were linearly dependent on the ET(30) solvent parameter. Deviations from the linear trend of the Stokes shift with ET(30) were observed in ethanol and methanol as a result of intermolecular hydrogen abstraction from the solvent and by the excited nitro group. The oxidation potential of the bithiophenes was also highly dependent on the type and number of the electron withdrawing substituents, with values ranging between 0.8 and 1.2 V vs. SCE.

Superheated Water Chromatography of Low Molecular Weight Polyethylene Glycols with Ultraviolet Detection

Superheated water chromatography (SWC) with ultraviolet detection was applied to the separation of low molecular weight polyethylene glycols (PEGs). PEG oligomers could be detected sensitively when the detection wavelength was set at 190 nm. The effect of column temperature on the separation of PEG oligomers was investigated. The elution time of all PEG oligomers decreased with increase in the column temperature; linear relationships were obtained between ln k and 1/T. A temperature-programmed SWC separation enabled the baseline separation of a PEG 200 sample within 50 min.

High-temperature liquid chromatography

The present state of the active use of elevated temperatures in liquid chromatography is reviewed, including the effects on retention, selectivity and efficiency. Separations in aqueous mobile phases as well as non-aqueous media are discussed, with particular emphasis on narrow-bore columns.