Development and Characterization of a Capillary Gap Sampler as New Microfluidic Device for Fast and Direct Analysis of Low Sample Amounts by ESI-MS

Bioaffinity Screening with a Rapid and Sample-Efficient Autosampler for Native Electrospray Ionization Mass Spectrometry

Fast and efficient handling of ligands and biological targets are required in bioaffinity screening based on native electrospray ionization mass spectrometry (ESI-MS). We use a prototype microfluidic autosampler, called the "gap sampler", to sequentially mix and electrospray individual small molecule ligands together with a target protein and compare the screening results with data from thermal shift assay and surface plasmon resonance. In a first round, all three techniques were used for a screening of 110 ligands against bovine carbonic anhydrase II, which resulted in five mutual hits and some false positives with ESI-MS presumably due to the high ligand concentration or interferences from dimethyl sulfoxide. In a second round, 33 compounds were screened in lower concentrations and in a less complex matrix, resulting in only true positives with ESI-MS. Within a cycle time of 30 s, dissociation constants were determined within an order of magnitude accuracy consuming only 5 pmol of ligand and less than 15 pmol of protein per screened compound. In a third round, dissociation constants of five compounds were accurately determined in a titration experiment. Thus, the gap sampler can rapidly and efficiently be used for high-throughput screening.

An open port sampling interface for liquid introduction atmospheric pressure ionization mass spectrometry

RATIONALE

A simple method to introduce unprocessed samples into a solvent for rapid characterization by liquid introduction atmospheric pressure ionization mass spectrometry has been lacking. The continuous flow, self-cleaning open port sampling interface introduced here fills this void.

METHODS

The open port sampling interface used a vertically aligned, co-axial tube arrangement enabling solvent delivery to the sampling end of the device through the tubing annulus and solvent aspiration down the center tube and into the ionization source of the mass spectrometer via the commercial APCI emitter probe. The solvent delivery rate to the interface was set to exceed the aspiration rate, creating a continuous sampling interface along with a constant, self-cleaning spillover of solvent from the top of the probe.

RESULTS

Using the open port sampling interface with positive ion mode APCI and a hybrid quadrupole time-of-flight mass spectrometer, rapid, direct sampling and analysis possibilities are exemplified with plastics, ballpoint and felt tip ink pens, skin, and vegetable oils. These results demonstrated that the open port sampling interface could be used as a simple, versatile and self-cleaning system to rapidly introduce multiple types of unprocessed, sometimes highly concentrated and complex, samples into a solvent flow stream for subsequent ionization and analysis by mass spectrometry. The basic setup presented here could be incorporated with any self-aspirating liquid introduction ionization source (e.g., ESI, APCI, APPI, ICP, etc.) or any type of atmospheric pressure sampling-ready mass spectrometer system.

CONCLUSIONS

The open port sampling interface provides a means to introduce and quickly analyze unprocessed solid or liquid samples with the liquid introduction atmospheric pressure ionization source without fear of sampling interface or ionization source contamination.

Lab-on-a-Chip hyphenation with mass spectrometry: strategies for bioanalytical applications

The Lab-on-a-Chip concept aims at miniaturizing laboratory processes to enable automation and/or parallelization via microfluidic chips that are capable of handling minute sample volumes. Mass spectrometry is nowadays the detection method of choice, because of its selectivity, sensitivity and wide application range. We review the most interesting examples over the last two-and-a-half years where the two techniques were used for bioanalytical applications. Furthermore, we discuss the merits and limitations of such hyphenated systems. We inventorize the reported applications and approaches. We see an ongoing trend towards chip-based liquid chromatography-mass spectrometry usage and small volume analysis applications, particularly in the field of proteomics where bottom-up approaches profit from chip-based technologies and hyphenation with complex cell cultures.

Interfacing microsampling droplets and mass spectrometry by paper spray ionization for online chemical monitoring of cell culture

In this work, the establishment of a microdialysis-paper spray ionization-mass spectrometry (MS) system was described. A homemade microdialysis module was employed for sampling, and microdroplets were generated at the outlet of the capillary conducting the dialysate. Online MS analysis of each microdroplet was immediately accomplished, interfacing by paper spray ionization. Analytical performance of the method was investigated and improved through the introduction of thinner capillary tubes and the optimization of spray solvent and paper substrate. For microdroplets with concentrated salt at 50 nL, the limit of detection at 0.8 ppm (or 40 pg absolute) and a highest resolution at about 1.5 s were achieved. The integrated system was applied into the online monitoring of glucose concentration in cell culture mediums. A satisfactory linearity of the calibration curve between the relative MS intensity and the glucose concentration was observed. Furthermore, as a model, hormone regulation of the glucose concentration was investigated. This work demonstrated the potential application of the label-free, online "MS sensor" into studies on cellular metabolism.