Determination of Picogram Quantities of Vanadium in Calcite and Seawater by Isotope Dilution Inductively Coupled Plasma Mass Spectrometry with Electrothermal Vaporization

Determination of cadmium and lead in urine by electrothermal vaporization isotope dilution inductively coupled plasma mass spectrometry

Electrothermal vaporization isotope dilution inductively coupled plasma mass spectrometry (ETV-ID-ICP-MS) was applied to the determination of Cd and Pb in urine samples. The isotope ratios for each element in each analytical run were calculated from the peak areas of each isotope. A relatively low vaporization temperature was used, which separated the analyte from the major matrix components and improved the ion signals of Cd and Pb significantly. Various chemical modifiers were tested to obtain the best signal of Cd and Pb. After preliminary studies, 1% HNO3 was added to the samples as the chemical modifier. The ETV-ID-ICP-MS method was applied to the determination of Cd and Pb in freeze-dried urine reference material NIST SRM 2670 and several fresh urine samples. The results for NIST SRM 2670 agreed satisfactorily with the certified values. The results for other samples obtained by isotope dilution and the method of standard additions agreed satisfactorily. The detection limits were 0.02 and 0.005 ng ml-1 for Cd and Pb, respectively. The precision between sample replicates was better than 11% for all determinations.

Isotope dilution analysis of Se in human blood serum by using high-power nitrogen microwave-induced plasma mass spectrometry coupled with a hydride generation technique

To establish a method for sensitive, accurate, and precise determination of Se in real samples, isotope dilution analysis using high-power nitrogen microwave-induced plasma mass spectrometry (N2 MIP-IDMS) was conducted. In this study, freeze-dried human blood serum (Standard Reference Material, NIES No. 4) provided by NIES (National Institute for Environmental Studies) was used as a real sample. The measured isotopes of Se were 78Se and 80Se which are the major isotopes of Se. The appropriate amount of a Se spike solution was theoretically calculated by using an error multiplication factor (F) and was confirmed experimentally for the isotope dilution analysis. The mass discrimination effect was corrected for by using a standard Se solution for the measurement of Se isotope ratios in the spiked sample. However, the sensitivity for the detection of Se was not so good and the precision of the determination was not improved (2-3%) by N2 MIP-IDMS with use of the conventional nebulizer. Therefore, a hydride generation system was connected to N2 MIP-IDMS as a sample introduction system (HG-N2 MIP-IDMS) in order to establish a more sensitive detection and a more precise determination of Se. A detection limit (3 sigma) of 10 pg mL-1 could be achieved, and the RSD was less than 1% at the concentration level of 5.0-10.0 ng mL-1 by HG-N2 MIP-IDMS. The analytical results were found to be in a good agreement with those obtained by the standard addition method using conventional Ar ICPMS.