Insights into the Regulation Effects of Certain Phenolic Acids on 2,3-Dihydro-3,5-dihydroxy-6-methyl-4(H)-pyran-4-one Formation in a Microaqueous Glucose-Proline System

Formation of advanced glycation end products in glucose-amino acid models of Maillard reaction under dry- and wet-heating conditions

BACKGROUND

Advanced glycation end products (AGEs) are compounds formed by non-enzymatic processes in the Maillard reaction and can cause various chronic diseases. This study explores the AGE formation process in a glucose-amino acid system under both wet- and dry-heating conditions, and analyzes the effect of cysteine in AGE formation.

RESULTS

Under wet-heating conditions, Nε-carboxymethyllysine (CML) and Nε-carboxyethyllysine (CEL) concentrations rose for the initial 90 min and subsequently declined after 120 min; after 90 min of heating, the maximum yields in the absence of cysteine were 1151.04 ± 14.01 and 3386.90 ± 26.55 ng mL-1, respectively. The concentration of pyrraline (Pyr) increased after 30 min and then decreased after 60 min with a maximum yield of 777.68 ± 23.36 ng mL-1. However, in dry-heating models, the AGE concentrations consistently increased with increasing heating time; the maximum yields for CML, CEL and Pyr were 468.66 ± 10.96, 1993.57 ± 14.81 and 1085.74 ± 58.06 ng mL-1, respectively. The addition of cysteine showed an inhibitory effect on AGE formation, especially for Pyr in the dry-heating model, with inhibition rates ranging from 17.14% to 95.60%.

CONCLUSION

Although wet-heating models produced more CML and CEL, they produced less Pyr than dry-heating models. The AGE formation in wet-heating models positively correlated with the reaction rate; however, the dry-heating reaction demonstrated a more complex relationship between reaction rate and reaction protocol. Moreover, cysteine exhibited a significant inhibitory effect on AGE production, and the degree of inhibition was proportional to the cysteine concentration. This study provides important insights into the mechanisms for AGE formation under various heating conditions, such as those representing baking (dry-heating) and steaming conditions (wet-heating). © 2024 Society of Chemical Industry.

Effects of stir-frying on chemical profile, sensory quality and antioxidant activity of Chrysanthemi Flos: A metabolomics and sensory study

Chrysanthemi Flos has been consumed as floral tea for centuries, but the effects of stir-frying on its chemical profile, sensory characteristics, and bioactivity remain unclear. This study used untargeted metabolomics, sensory assessment (E-eye, E-nose, E-tongue), and antioxidant activity evaluation to investigate compositional changes and their effects. In the metabolomics analysis, a total of 101 non-volatile and 306 volatile differential metabolites were identified. During stir-frying of Chrysanthemi Flos, glycosidic bond rupture in flavonoid glycosides, thermal decomposition of caffeoylquinic acid, Maillard, and caramelization reactions occurred. This led to the formation of 4 flavonoid glycosides (luteolin, diosmetin, apigenin, and quercetin) and 33 roasted aroma compounds like pyrazines, furans, 2-methylbutanal, and 2-furanmethanol. The Spearson's correlation analysis of metabolomics, E-eye, and E-tongue data showed that these compositional changes not only resulted in darkening and scorching of the color of Chrysanthemi Flos after stir-frying, but also improved the bitter and astringent taste of Chrysanthemi Flos tea broths, and enhanced the antioxidant activity of Chrysanthemi Flos. These findings will provide new perspectives on the selection of processing methods for Chrysanthemi Flos.

Effects of moisture content on the enolization products formation in glucose-proline Maillard reaction models

BACKGROUND

2,3-Dihydro-3,5-dihydroxy-6-methyl-4(H)-pyran-4-one (DDMP) and 5-hydroxymethylfurfural (HMF) are two main enolization products in the Maillard reaction and found in some foodstuffs. For many years, whether they are functional or noxious to human health has been a matter of debate. Thus, insight into their formation pathways is important to manage Maillard reaction products. In this study, DDMP and HMF were quantified and compared with regard to their formation and degradation in the d-glucose and l-proline Maillard reaction models using different moisture contents (0, 0.1, 0.5, 1.0, and 4.0 mL) at 150 °C for various heating times.

RESULTS

DDMP was predominantly generated in dry or low water-content heating models along with n increased 1-deoxyglucosone (1-DG) generation via 2,3-enolization. However, increasing moisture content resulted in a decay of reaction intensity, 1-DG, and DDMP due to a change in the reaction mechanism from 2,3-enolization to 1,2-enolization, which facilitated 3-deoxyglucosone (3-DG) and HMF formation.

CONCLUSION

Increased moisture content in glucose-proline models reduced reaction intensity and also inhibited DDMP and facilitated HMF formation by promoting the pathway change from 2,3-enolization to 1,2-enolization to generate more 3-DG. A water content of 1.0 mL was identified as a critical value, from which the 1,2-enolization became a primary pathway occurring in the Maillard reaction. © 2022 Society of Chemical Industry.

New Strategy for Inducing Resistance against Bacterial Wilt Disease Using an Avirulent Strain of Ralstonia solanacearum

Ralstonia solanacearum is one of the globally significant plant pathogens that infect a wide host range of economically important plants. A study was conducted to evaluate the hypothesis that an avirulent strain of R. solanacearum can act as a biocontrol mediator for managing potato bacterial wilt. Virulent R. solanacearum was isolated and identified (GenBank accession number; OP180100). The avirulent strain was obtained from the virulent strain through storage for 3 weeks until the development of deep red colonies. The virulent strain had higher lytic activity than the avirulent strain. Tubers' treatments by the avirulent strain of R. solanacearum, (supernatant, boiled supernatant, and dead cells) significantly reduced plant disease rating and increased the growth, physiological activities, and biomass of potato compared to the untreated, infected control. The major components detected by GC-MS in the supernatant revealed 10.86% palmitic acid (virulent), and 18.03% 1,3-dioxolane, 2,4,5-trimethyl- (avirulent), whereas the major component in the boiled supernatant was 2-hydroxy-gamma-butyrolactone in the virulent (21.17%) and avirulent (27.78%) strains. This is the first research that assessed the influence of boiled supernatant and dead cells of virulent and avirulent R.solanacearum strains in controlling bacterial wilt disease. Additional work is encouraged for further elucidation of such a topic.

Comparative elucidation of bioactive and volatile components in dry mature jujube fruit (Ziziphus jujuba Mill.) subjected to different drying methods

This study investigated the effects of convective drying(CD) and freeze drying(FD) on bioactive and volatile components in jujube. No significant difference in total phenolic, total flavonoids and antioxidant capacity among CD60, CD70, CD80 and FD samples (P > 0.05). LC-MS/MS analysis showed that this trend mainly originated from the dynamic equilibrium relationships between caffeic acid, chlorogenic acid, p-hydroxybenzoic acid, rutin, epicatechin, and quercetin. HS-SPME-GC-MS identified 31 volatile organic compounds (VOCs) comprising more than 80% aldehydes and acids. Principal component analysis distinguished the VOC characteristics of samples subjected to different drying methods. Six VOCs had an odor activity value (OAV) >1, most of which were fatty acid oxidation or Maillard reaction products. Combined with the precursor components, these reactions were speculated to be the major VOC-producing pathways in dried jujube. Considering the bioactive components and flavor retention, CD at 60 °C was an effective drying method with potential to replace FD.

Synthesis of 2,3-dihydro-3,5-dihydroxy-6-methyl-4H-pyran-4-one from maltol and its taste identification

2,3-Dihydro-3,5-dihydroxy-6-methyl-4H-pyran-4-one (DDMP) exists in many foods, and its effect on taste is controversial. The aim of this study was to clarify whether DDMP has bitter taste or not. For this purpose, DDMP was synthesized from maltol instead of from glucose for the first time. In contrast, DDMP derived from glucose was also prepared and further purified. Their structures were identified by NMR and MS, and considered to be the same substance. The sensory analysis showed that DDMP derived from maltol was tasteless. Further studies indicated that some impurities in Maillard reaction made DDMP derived from glucose taste bitter.

Detection of Bitter Taste Molecules Based on Odorant-Binding Protein-Modified Screen-Printed Electrodes

Bitter taste substances commonly represent a signal of toxicity. Fast and reliable detection of bitter molecules improves the safety of foods and beverages. Here, we report a biosensor using an easily accessible and cost-effective odorant-binding protein (OBP) of Drosophila melanogaster as a biosensitive material for the detection of bitter molecules. Based on the theoretical evaluation of the protein-ligand interaction, binding energies between the OBP and bitter molecules were calculated via molecular docking for the prediction and verification of binding affinities. Through one-step reduction, gold nanoparticles (AuNPs) and reduced graphene oxide (rGO) were deposited on the screen-printed electrodes for improving the electrochemical properties of electrodes. After the electrodes were immobilized with OBPs via layer-by-layer self-assembly, typical bitter molecules, such as denatonium, quinine, and berberine, were investigated through electrochemical impedance spectroscopy. The bitter molecules showed significant binding properties to the OBP with linear response concentrations ranging from 10^-9 to 10^-6 mg/mL. Therefore, the OBP-based biosensor offered powerful analytic techniques for the detection of bitter molecules and showed promising applications in the field of bitter taste evaluation.