SEIRAS Studies of Water Structure in a Sodium Dodecyl Sulfate Film Adsorbed at a Gold Electrode Surface

Anionic Surfactant-Tailored Interfacial Microenvironment for Boosting Electrochemical CO2 Reduction

Both the catalyst and electrolyte deeply impact the performance of the carbon dioxide reduction reaction (CO2RR). It remains a challenge to design the electrolyte compositions for promoting the CO2RR. Here, typical anionic surfactants, dodecylphosphonic acid (DDPA) and its analogues, are employed as electrolyte additives to tune the catalysis interface where the CO2RR occurs. Surprisingly, the anionic surfactant-tailored interfacial microenvironment enables a set of typical commercial catalysts for the CO2RR to deliver a significantly enhanced selectivity of carbon products in both neutral and acidic electrolytes. Mechanistic studies disclose that the DDPA addition restructures the interfacial hydrogen-bond environment via increasing the weak H-bonded water, thus promoting the CO2 protonation to CO. Specifically, in an H-type cell, the Faradaic efficiency of CO increases from 70 to 98% at -1.0 V versus the reversible hydrogen electrode. Furthermore, in a flow cell, the DDPA-containing electrolyte maintains over 90% FECO from 50-400 mA cm-2. Additionally, this electrolyte modulation strategy can be extended to acidic CO2RR with a pH of 1.5-3.5.

Surface-Enhanced Infrared Absorption Spectroscopy by Resonant Vibrational Coupling with Plasmonic Metal Oxide Nanocrystals

Coupling between plasmonic resonances and molecular vibrations in nanocrystals (NCs) offers a promising approach for detecting molecules at low concentrations and discerning their chemical identities. Metallic NC superlattices can enhance vibrational signals under far-field detection by generating a myriad of intensified electric field hot spots between the NCs. Yet, their effectiveness is limited by the fixed electron concentration dictated by the metal composition and inefficient hot spot creation due to the large mode volume. Doped metal oxide NCs, such as tin-doped indium oxide (ITO), could overcome these limitations by enabling broad tunability of resonance frequencies in the mid-infrared range through independent variation of size and doping concentration. This study investigates the potential of close-packed ITO NC monolayers for surface-enhanced infrared absorption by quantifying trends in the coupling between their plasmon modes and various molecular vibrations. We show that maximum vibrational signal intensity occurs in monolayers composed of larger, more highly doped NCs, where the plasmon resonance peak lies at higher frequency than the molecular vibration. Using finite element and mutual polarization methods, we establish that near-field enhancement is stronger on the low-frequency side of the plasmon resonance and for more strongly coupled plasmonic NCs, thus rationalizing the design rules we experimentally uncovered. Our results can guide the development of optimal metal oxide NC-based superstructures for sensing target molecules or modifying their chemical properties through vibrational coupling.

Sparsely tethered bilayer lipid membranes formed by self-assembly of bicelles: Spectroelectrochemical characterization and incorporation of transmembrane protein

Many biochemical processes related to proper homeostasis take place in cell membranes. The key molecules involved in these processes are proteins, including transmembrane proteins. These macromolecules still challenge the understanding of their function within the membrane. Biomimetic models that mimic the properties of the cell membrane can help understand their functionality. Unfortunately, preserving the native protein structure in such systems is problematic. A possible solution to this problem involves the use of bicelles. Their unique properties make integrating bicelles with transmembrane proteins manageable while preserving their native structure. Hitherto, bicelles have not been used as precursors for protein-hosting lipid membranes deposited on solid substrates like pre-modified gold. Here, we demonstrated that bicelles can be self-assembled to form sparsely tethered bilayer lipid membranes and the properties of the resulting membrane satisfy the conditions suitable for transmembrane protein insertion. We showed that the incorporation of α-hemolysin toxin in the lipid membrane leads to a decrease in membrane resistance due to pore formation. Simultaneously, the insertion of the protein causes a drop in the capacitance of the membrane-modified electrode, which can be explained by the dehydration of the polar region of the lipid bilayer and the loss of water from the submembrane region.

Direct Determination of Plasmon Enhancement Factor and Penetration Depths in Surface Enhanced IR Absorption Spectroscopy

Surface Enhanced Infrared Absorption Spectroscopy (SEIRAS) is a powerful tool for studying a wide range of surface and electrochemical phenomena. For most electrochemical experiments the evanescent field of an IR beam partially penetrates through a thin metal electrode deposited on top of an attenuated total reflection (ATR) crystal to interact with molecules of interest. Despite its success, a major problem that complicates quantitative interpretation of the spectra from this method is the ambiguity of the enhancement factor due to plasmon effects in metals. We developed a systematic method for measuring this, which relies upon independent determination of surface coverage by Coulometry of a surface-bound redox-active species. Following that, we measure the SEIRAS spectrum of the surface bound species, and from the knowledge of surface coverage, retrieve the effective molar absorptivity, ε_SEIRAS. Comparing this to the independently determined bulk molar absorptivity leads us to the enhancement factor f = ε_SEIRAS/ε_bulk. We report enhancement factors in excess of 1000 for the C-H stretches of surface bound ferrocene molecules. We additionally developed a methodical approach to measure the penetration depth of the evanescent field from the metal electrode into a thin film. Such systematic measure of the enhancement factor and penetration depth will help SEIRAS advance from a qualitative to a more quantitative method.

Highly efficient preconcentration using anodically generated shrinking gas bubbles for per- and polyfluoroalkyl substances (PFAS) detection

Here we report a highly efficient PFAS preconcentration method that uses anodically generated shrinking gas bubbles to preconcentrate PFAS via aerosol formation, achieving ~ 1400-fold enrichment of PFOS and PFOA-the two most common PFAS-in 20 min. This new method improves the enrichment factor by 15 to 105% relative to the previous method that uses cathodically generated H₂ bubbles. The shrinking gas bubbles are in situ electrogenerated by oxidizing water in an NH₄HCO₃ solution. H⁺ produced by water oxidation reacts with HCO₃^- to generate CO₂ gas, forming gas bubbles containing a mixture of O₂ and CO₂. Due to the high solubility of CO₂ in aqueous solutions, the CO₂/O₂ bubbles start shrinking when they leave the electrode surface region. A mechanistic study reveals two reasons for the improvement: (1) shrinking bubbles increase the enrichment rate, and (2) the attractive interactions between the positively charged anode and negatively charged PFAS provide high enrichment at zero bubble path length. Based on this preconcentration method, we demonstrate the detection of ≥ 70 ng/L PFOA and PFOS in water in ~ 20 min by coupling it with our bubble-nucleation-based detection method, fulfilling the need of the US Environmental Protection Agency.

Influence of lipophilicity of anthracyclines on the interactions with cholesterol in the model cell membranes - Langmuir monolayer and SEIRAS studies

The interactions of anthracyclines with biological membranes strongly depend on the drug lipophilicity, which might also determine the specific affinity to cholesterol molecules. Therefore, in this work we show the studies concerning the effect of two selected anthracyclines, daunorubicin (DNR) and idarubicin (IDA) on simple models of healthy (DMPC:Chol 7:3) and cancer cells membranes with increased level of cholesterol (DMPC:Chol 3:7) as well as pure cholesterol monolayers prepared at the air-water interface and supported on gold surface. It has been shown that more lipophilic IDA is able to penetrate cholesterol monolayers more effectively than DNR due to the formation of IDA-cholesterol arrangements at the interface, as proved by the thermodynamic analysis of compression-expansion cycles. The increased interactions of IDA were also confirmed by the time measurements of pre-compressed monolayers exposed to drug solutions as well as grazing incidence X-ray diffraction studies demonstrating differences in the 2D organization of cholesterol monolayers. Langmuir studies of mixed DMPC:Chol membranes revealed the reorganization of molecules in the cancer cell models at the air-water interface at higher surface pressures due to the removal of DNR, while increased affinity of IDA towards cholesterol allowed this drug to penetrate the layer more efficiently without its removal. The SEIRAS spectra obtained for supported DMPC:Chol bilayers proved that IDA locates both in the ester group and in the acyl chain region of the bilayer, while DNR does not penetrate the membranes as deeply as IDA. The increased penetration of the mixed phospholipid layers by idarubicin might be attributed to the higher lipophilicity caused by the lack of methoxy group and resulting in a specific affinity towards cholesterol.

Physicochemical Characterization of Daptomycin Interaction with Negatively Charged Lipid Membranes

Daptomycin is known as an effective antibiotic lipopeptide which shows activity against the number of Gram-positive pathogens. Its primary target is the bacterial cell membrane. However, the detailed mechanism of daptomycin action is still subject to debate. In this paper, we have investigated the interactions between lipopeptide and model lipid films composed of negatively charged phosphatidylglycerols and cardiolipin. In order to evaluate the effect of daptomycin on the molecular organization and the properties of lipid assemblies, we have used surface pressure measurements and electrochemical methods combined with atomic force microscopy, quartz crystal microbalance, and surface-enhanced infrared absorption spectroscopy. Our results indicate that daptomycin interaction with the lipid membrane is complex. It involves daptomycin aggregation and partial insertion, which in turn affect the charge distribution on both sides of the membrane and may result in a gradient of water chemical potential. The latter can drive the flux of water across the membrane.

End Group Properties of Thiols Affecting the Self-Assembly Mechanism at Gold Nanoparticles Film As Evidenced by Water Infrared Probe

Water infrared probe has been employed for in situ monitoring of the detailed self-assembly processes of four thiol molecules with different end groups (-CH₃, -NH₂, -COOH, and -OH) on gold nanoparticles (Au NPs) film in aqueous solution. Based on the change of water IR signal, the significant influence of end group properties on the kinetics and thermodynamics of thiols self-assembly can be estimated. It is found that the assembly kinetics of thiols decreases with the increase of the hydrophobicity of the end groups. In addition, the charges carried by the end groups (-COOH and -NH₂ terminated thiols) will also slow down the self-assembly kinetics owing to the electrostatic repulsions. However, the isothermal adsorption is only affected by the wettability of the end groups of thiols. The higher hydrophilicity of the end groups results in larger equilibrium constant of the self-assembly process. Results show that water infrared probe offers an additional approach to the monitoring of thiols self-assembly processes with higher sensitivity and more detailed information as compared to traditional molecule fingerprints.

Effect of Interfacial Water on the Nanomechanical Properties of Negatively Charged Floating Bilayers Supported on Gold Electrodes

Floating lipid bilayers composed of phosphatidylglycerols and cardiolipin were deposited on gold electrodes premodified with 1-thio-β-d-glucose monolayer by spreading of small unilamellar vesicles. The resulting lipid membrane was homogeneous, and its thickness was ∼5.0 nm. Electrochemical characterization combined with surface-enhanced infrared absorption spectroscopy revealed that negative polarization of the electrode leads to accumulation of water molecules in the interfacial region between lipid membrane and the thioglucose film. Moreover, the buildup of water layer was demonstrated to affect the nanomechanical properties of the membrane. The latter was manifested by well-pronounced decrease of Young's modulus of the lipid bilayer correlating with increasing hydration. This effect was ascribed to the decoupling of the membrane from supporting thioglucose film due to the accumulation of interfacial water. As a result, the effective stiffness of the supporting layer is lower and it alters the nanomechanical behavior of lipid membrane. Our results provide strong experimental proof for the correlation between elastic properties of floating lipid membrane and the amount of water accumulated in the submembrane region.

Water as a Universal Infrared Probe for Bioanalysis in Aqueous Solution by Attenuated Total Reflection-Surface Enhanced Infrared Absorption Spectroscopy

Monitoring the properties and reactions of biomolecules at their interface has attracted ever-growing interest. Here, we propose an approach of infrared analysis technique that utilizes water molecule as a universal probe for in situ and label free monitoring of interfacial bioevents in aqueous solution with high sensitivity. The strong infrared (IR) signal of O-H stretching vibrations from the repelled water is used to sensitively reveal the kinetics of interfacial bioevents at molecular level based on the steric displacement of water using an attenuated total reflection-surface enhanced infrared absorption spectroscopy. Using interfacial immuno-recognition and DNA hybridization as demonstrations, water IR probe offers 26 and 34 times higher sensitivity and even 200 and 86 times lower detection limit for immunosensing and DNA sensing, respectively, as compared to the traditional IR molecular fingerprints.

Amphotericin B-silver hybrid nanoparticles: synthesis, properties and antifungal activity

High antifungal activity is reported, in comparison with commercially available products, of a novel hybrid system based on silver nanoparticles synthesized using a popular antifungal macrocyclic polyene amphotericin B (AmB) acting both as a reducing and stabilizing/capping agent. The synthesis reaction proceeds in an alkaline environment which prevents aggregation of AmB itself and promotes nanoparticle formation. The innovative approach produces monodisperse (PDI=0.05), AmB-coated silver nanoparticles (AmB-AgNPs) with the diameter ~7nm. The products were characterized using imaging (electron microscopy) and spectroscopic (UV-vis and infrared absorption, dynamic light scattering and Raman scattering) methods. The nanoparticles were tested against Candida albicans, Aspergillus niger and Fusarium culmorum species. For cytotoxicity studies CCD-841CoTr and THP-1 cell lines were used. Particularly high antifungal activity of AmB-AgNPs is interpreted as the result of synergy between the antifungal activity of amphotericin B and silver antimicrobial properties (Ag(+) ions release).

FROM THE CLINICAL EDITOR

Amphotericin B (AmB) is a common agent used for the treatment against severe fungal infections. In this article, the authors described a new approach in using a combination of AmB and silver nanoparticles, in which the silver nanoparticles were synthesized and stabilized by AmB. Experimental data confirmed synergistic antifungal effects between amphotericin B and silver. This novel synthesis process could potentially be important in future drug development and fabrication.