Motion of model leukocytes near a wall in simple shear flow

Effects of microfluidic channel geometry on leukocyte rolling assays

Microfluidic cell adhesion assays have emerged as a means to increase throughput as well as reduce the amount of costly reagents. However as dimensions of the flow chamber are reduced and approach the diameter of a cell (D(c)), theoretical models have predicted that mechanical stress, force, and torque on a cell will be amplified. We fabricated a series of microfluidic devices that have a constant width:height ratio (10:1) but with varying heights. The smallest microfluidic device (200 μm ×20 μm) requires perfusion rates as low as 40 nL/min to generate wall shear stresses of 0.5 dynes/cm(2). When neutrophils were perfused through P-selectin coated chambers at equivalent wall shear stress, rolling velocities decreased by approximately 70 % as the ratio of cell diameter to chamber height (D(c)/H) increased from 0.08 (H = 100 μm) to 0.40 (H = 20 μm). Three-dimensional numerical simulations of neutrophil rolling in channels of different heights showed a similar trend. Complementary studies with PSGL-1 coated microspheres and paraformaldehyde-fixed neutrophils suggested that changes in rolling velocity were related to cell deformability. Using interference reflection microscopy, we observed increases in neutrophil contact area with increasing chamber height (9-33 %) and increasing wall shear stress (28-56 %). Our results suggest that rolling velocity is dependent not only on wall shear stress but also on the shear stress gradient experienced by the rolling cell. These results point to the D(c)/H ratio as an important design parameter of leukocyte microfluidic assays, and should be applicable to rolling assays that involve other cell types such as platelets or cancer cells.

Dynamic adhesion of umbilical cord blood endothelial progenitor cells under laminar shear stress

Late outgrowth endothelial progenitor cells (EPCs) represent a promising cell source for rapid reendothelialization of damaged vasculature after expansion ex vivo and injection into the bloodstream. We characterized the dynamic adhesion of umbilical-cord-blood-derived EPCs (CB-EPCs) to surfaces coated with fibronectin. CB-EPC solution density affected the number of adherent cells and larger cells preferentially adhered at lower cell densities. The number of adherent cells varied with shear stress, with the maximum number of adherent cells and the shear stress at maximum adhesion depending upon fluid viscosity. CB-EPCs underwent limited rolling, transiently tethering for short distances before firm arrest. Immediately before arrest, the instantaneous velocity decreased independent of shear stress. A dimensional analysis indicated that adhesion was a function of the net force on the cells, the ratio of cell diffusion to sliding speed, and molecular diffusivity. Adhesion was not limited by the settling rate and was highly specific to α(5)β(1) integrin. Total internal reflection fluorescence microscopy showed that CB-EPCs produced multiple contacts of α(5)β(1) with the surface and the contact area grew during the first 20 min of attachment. These results demonstrate that CB-EPC adhesion from blood can occur under physiological levels of shear stress.

Polymeric particles conjugated with a ligand to VCAM-1 exhibit selective, avid, and focal adhesion to sites of atherosclerosis

The increased expression of VCAM-1 on endothelial segments within plaque regions could be used as a target to deliver polymeric drug carriers selectively to sites of atherosclerosis. We probed the hypothesis that polymeric particles conjugated with a ligand for VCAM-1 exhibit selective and avid adhesion to sites of atherosclerosis. Particles made from polystyrene or the biodegradable polymer poly(sebacic acid)-block-polyethylene glycol (PSA-PEG) were conjugated with an antibody to VCAM-1 (alpha-VCAM-1) or IgG (negative control). The particles were injected into the jugular vein of ApoE(-/-) (a murine model of atherosclerosis) or wild type mice and their adhesion to the aorta determined. alpha-VCAM-1 particles exhibited significantly greater adhesion to ApoE(-/-) mouse aorta [32 +/- 5 (mean +/- SEM) particles/mm(2) for polystyrene particles and 31 +/- 7 particles/mm(2) for PSA-PEG particles] compared to the level of adhesion to wild type mouse aorta (18 +/- 1 particles/mm(2) for polystyrene particles and 6 +/- 1 particles/mm(2) for PSA-PEG particles). Within ApoE(-/-) mice, the alpha-VCAM-1 particles exhibited significantly greater adhesion to the aorta (32 +/- 5 particles/mm(2) for polystyrene particles and 31 +/- 7 particles/mm(2) for PSA-PEG particles) compared to the adhesion of IgG particles (1 +/- 1 particles/mm(2) for polystyrene particles and 2 +/- 1 particles/mm(2) for PSA-PEG particles). Detailed analysis of the adhesion revealed that alpha-VCAM-1 particles exhibited focal adhesion to plaque regions, in particular the periphery of the plaques, within the ApoE(-/-) mouse aorta. Combined the data demonstrate that polymeric particles conjugated with a ligand to VCAM-1 exhibit selective, avid and focal adhesion to sites of atherosclerosis providing strong evidence that VCAM-1 ligand bearing polymeric particles could be used for targeting drugs selectively to atherosclerotic tissue.

Microparticle adhesive dynamics and rolling mediated by selectin-specific antibodies under flow

In vitro studies were performed to characterize the relative performance of candidate receptors to target microparticles to inflammatory markers on vascular endothelium. To model the interactions of drug-bearing microparticles or imaging contrast agents with the vasculature, 6 micron polystyrene particles bearing antibodies, peptides, or carbohydrates were perfused over immobilized E- or P-selectin in a flow chamber. Microparticles conjugated with HuEP5C7.g2 (HuEP), a monoclonal antibody (mAb) specific to E- and P-selectin, supported leukocyte-like rolling and transient adhesion at venular shear rates. In contrast, microparticles conjugated with a higher affinity mAb specific for P-selectin (G1) were unable to form bonds at venular flow rates. When both HuEP and G1 were conjugated to the microparticle, HuEP supported binding to P-selectin in flow which allowed G1 to form bonds leading to stable adhesion. While the microparticle attachment and rolling performance was not as stable as that mediated by the natural ligands P-selectin Glycoprotein Ligand-1 or sialyl Lewis(x), HuEP performed significantly better than any previously characterized mAb in terms of mediating microparticle binding under flow conditions. HuEP may be a viable alternative to natural ligands to selectins for targeting particles to inflamed endothelium.

A 3D numerical study of the effect of channel height on leukocyte deformation and adhesion in parallel-plate flow chambers

The effect of channel height on leukocyte adhesion to a lower plate in a parallel-plate flow chamber is studied by direct numerical simulations in three dimensions. The numerical model takes into account deformability and viscoelasticity of the leukocyte, membrane ruffles (microvilli), and the presence of mechanically different regions inside the cell (nucleus and cytoplasm). Leukocyte adhesion is assumed to be mediated by interactions of adhesion molecules on the tips of microvilli with their counterparts on the lower plate. Results of this study indicate that an adherent leukocyte experiences much less drag than a rigid sphere due to its deformation and transient stress growth. While overall leukocyte deformation is modest at shear stresses encountered in the microcirculation, deformation in the contact region is significant. At fixed wall shear stress, the contact area of the cell membrane with the substrate increases with increasing the ratio of cell diameter to channel height, leading to greater adhesion. This suggests that in vitro flow chamber studies typically underestimate leukocyte adhesion that occurs in the microcirculation.

Dynamic contact forces on leukocyte microvilli and their penetration of the endothelial glycocalyx

We develop a theoretical model to examine the combined effect of gravity and microvillus length heterogeneity on tip contact force (F(m)(z)) during free rolling in vitro, including the initiation of L-, P-, and E-selectin tethers and the threshold behavior at low shear. F (m)(z) grows nonlinearly with shear. At shear stress of 1 dyn/cm(2), F(m)(z) is one to two orders of magnitude greater than the 0.1 pN force for gravitational settling without flow. At shear stresses > 0.2 dyn/cm(2) only the longest microvilli contact the substrate; hence at the shear threshold (0.4 dyn/cm(2) for L-selectin), only 5% of microvilli can initiate tethering interaction. The characteristic time for tip contact is surprisingly short, typically 0.1-1 ms. This model is then applied in vivo to explore the free-rolling interaction of leukocyte microvilli with endothelial glycocalyx and the necessary conditions for glycocalyx penetration to initiate cell rolling. The model predicts that for arteriolar capillaries even the longest microvilli cannot initiate rolling, except in regions of low shear or flow reversal. In postcapillary venules, where shear stress is approximately 2 dyn/cm(2), tethering interactions are highly likely, provided that there are some relatively long microvilli. Once tethering is initiated, rolling tends to ensue because F(m)(z) and contact duration will both increase substantially to facilitate glycocalyx penetration by the shorter microvilli.

An activated L-selectin mutant with conserved equilibrium binding properties but enhanced ligand recognition under shear flow

Selectins mediate the initial tethering and rolling of leukocytes on vessel walls. Adhesion by selectins is a function of both ligand recognition at equilibrium and mechanical properties of the selectin-ligand bond under applied force. We describe an EGF domain mutant of L-selectin with profoundly augmented adhesiveness over that of native L-selectin but conserved ligand specificity. This mutant, termed LPL, was derived by a substitution of the EGF-like domain of L-selectin with the homologous domain from P-selectin. The mutant bound soluble carbohydrate L-selectin ligand with affinity comparable with that of native L-selectin but interacted with all surface-bound ligands much more readily than native L-selectin, in particular under elevated shear flow. Tethers mediated by both native and mutant L-selectin exhibited similar lifetimes under a range of shear stresses, but the rate of bond formation by the mutant was at least 10-fold higher than that of native L-selectin toward distinct L-selectin ligands. Enhanced rate of bond formation by the mutant was associated with profoundly stronger rolling interactions and reduced dependence of rolling on a threshold of shear stress. This is the first demonstration that the EGF domain can modulate the binding of the lectin domain of a selectin to surface-immobilized ligands under shear flow without affecting the equilibrium properties of the selectin toward soluble ligands.