A remote in situ monitor based on continuous flow analysis for the quantitation of sub-micromolar levels of hexavalent chromium in natural waters

A Robust Flow-Based System for the Spectrophotometric Determination of Cr(VI) in Recreational Waters

A flow-based method for the spectrophotometric determination of chromium (VI) in recreational waters with different salinities was developed. Chromium can occur in the environment in different oxidation states with different related physiological properties. With regard to chromium, the speciation is particularly important, as the hexavalent chromium is considered to be carcinogenic. To achieve that purpose, the use of the diphenylcarbazide (DPC) selective colored reaction with the hexavalent chromium was the chosen strategy. The main objective was to develop a direct and simple spectrophotometric method that could cope with the analysis of different types of environmental waters, within different salinity ranges (fresh to marine waters). The potential interference of metal ions, that can usually be present in environmental waters, was assessed and no significant interferences were observed (<10%). For a complete Cr(VI) determination (three replicas) cycle, the corresponding reagents consumption was 75 µg of DPC, 9 mg of ethanol and 54 mg of sulfuric acid. Each cycle takes about 5 min, including the system clean-up. The limit of detection was 6.9 and 12.2 µg L−1 for waters with low and high salt content, respectively. The method was applied for the quantification of chromium (VI) in both fresh and marine water, and the results were in agreement with the reference procedure.

Flow injection analysis of trace chromium (VI) in drinking water with a liquid waveguide capillary cell and spectrophotometric detection

Hexavalent chromium (Cr(VI)) is an acknowledged hazardous material in drinking waters. As such, effective monitoring and assessment of the risks posed by Cr(VI) are important analytical objectives for both human health and environmental science. However, because of the lack of highly sensitive, rapid, and simple procedures, a relatively limited number of studies have been carried out in this field. Here we report a simple and sensitive analytical procedure of flow injection analysis (FIA) for sub-nanomolar Cr(VI) in drinking water samples with a liquid core waveguide capillary cell (LWCC). The procedure is based on a highly selective reaction between 1, 5-diphenylcarbazide and Cr(VI) under acidic conditions. The optimized experimental parameters included reagent concentrations, injection volume, length of mixing coil, and flow rate. Measurements at 540 nm, and a 650-nm reference wavelength, produced a 0.12-nM detection limit. Relative standard deviations for 1, 2, and 10 nM samples were 5.6, 3.6, and 0.72 % (n = 9), and the analysis time was <2 min sample(-1). The effects of salinity and interfering ions, especially Fe(III), were evaluated. Using the FIA-LWCC method, different sources of bottled waters and tap waters were examined. The Cr(VI) concentrations of the bottled waters ranged from the detection limit to ∼20 nM, and tap waters collected from the same community supply had Cr(VI) concentration around 14 nM.