Interfacial Chemistry in the Electrocatalytic Hydrogenation of CO2 over C-Supported Cu-Based Systems

Operando soft and hard X-ray spectroscopic techniques were used in combination with plane-wave density functional theory (DFT) simulations to rationalize the enhanced activities of Zn-containing Cu nanostructured electrocatalysts in the electrocatalytic CO2 hydrogenation reaction. We show that at a potential for CO2 hydrogenation, Zn is alloyed with Cu in the bulk of the nanoparticles with no metallic Zn segregated; at the interface, low reducible Cu(I)-O species are consumed. Additional spectroscopic features are observed, which are identified as various surface Cu(I) ligated species; these respond to the potential, revealing characteristic interfacial dynamics. Similar behavior was observed for the Fe-Cu system in its active state, confirming the general validity of this mechanism; however, the performance of this system deteriorates after successive applied cathodic potentials, as the hydrogen evolution reaction then becomes the main reaction pathway. In contrast to an active system, Cu(I)-O is now consumed at cathodic potentials and not reversibly reformed when the voltage is allowed to equilibrate at the open-circuit voltage; rather, only the oxidation to Cu(II) is observed. We show that the Cu-Zn system represents the optimal active ensembles with stabilized Cu(I)-O; DFT simulations rationalize this observation by indicating that Cu-Zn-O neighboring atoms are able to activate CO2, whereas Cu-Cu sites provide the supply of H atoms for the hydrogenation reaction. Our results demonstrate an electronic effect exerted by the heterometal, which depends on its intimate distribution within the Cu phase and confirms the general validity of these mechanistic insights for future electrocatalyst design strategies.

Orange Peel Biomass-derived Carbon Supported Cu Electrocatalysts Active in the CO2 -Reduction to Formic Acid

We report a green, wet chemistry approach towards the production of C-supported Cu electrocatalysts active in the CO₂ reduction to formic acid. We use citrus peels as a C support precursor and as a source of reducing agents for the Cu cations. We show that orange peel is a suitable starting material compared to lemon peel for the one-pot hydrothermal synthesis of Cu nanostructures affording better Cu dispersion as well as productivity and selectivity towards formic acid. We rationalize this finding in terms of the beneficial chemical composition of the orange peel, which favors both the reduction of the Cu precursor as well as the carbon matrix. This work demonstrates new viable opportunities for the reuse of citrus waste on a rational basis.