Scaling features of the tribology of polymer brushes of increasing grafting density around the mushroom-to-brush transition

Polymer brushes for friction control: Contributions of molecular simulations

When polymer chains are grafted to solid surfaces at sufficiently high density, they form brushes that can modify the surface properties. In particular, polymer brushes are increasingly being used to reduce friction in water-lubricated systems close to the very low levels found in natural systems, such as synovial joints. New types of polymer brush are continually being developed to improve with lower friction and adhesion, as well as higher load-bearing capacities. To complement experimental studies, molecular simulations are increasingly being used to help to understand how polymer brushes reduce friction. In this paper, we review how molecular simulations of polymer brush friction have progressed from very simple coarse-grained models toward more detailed models that can capture the effects of brush topology and chemistry as well as electrostatic interactions for polyelectrolyte brushes. We pay particular attention to studies that have attempted to match experimental friction data of polymer brush bilayers to results obtained using molecular simulations. We also critically look at the remaining challenges and key limitations to overcome and propose future modifications that could potentially improve agreement with experimental studies, thus enabling molecular simulations to be used predictively to modify the brush structure for optimal friction reduction.

Direct Nanoscopic Measurement of Laminar Slip Flow Penetration of Deformable Polymer Brush Surfaces: Synergistic Effect of Grafting Density and Solvent Quality

A detailed quantitative nanoscopic description of soft surfaces under dynamic flow is lacking, despite its importance. To better understand the role of surface texture in nanoscopic mass transport in complex media, we used Förster resonance energy transfer in combination with total internal reflectance fluorescence microscopy (FRET-TIRFM) to directly measure laminar slip flow penetration depth (slip length) on poly(N-isopropylacrylamide) (pNIPAM) thin films (50-110 nm) of different grafting densities (0.60, 0.38, and 0.27 chain/nm²) in solvents of different qualities created via cononsolvency in situ. Nontrivial synergistic interplay of grafting density and solvent quality on slip length was observed. Slip lengths are typically tens of nm (40-100 nm), increasing and then reaching a plateau with applied linear flow velocity (192-2,952 μm/s) regardless of experimental system. Slip length was systematically larger for lower density films, but the effect of grafting density was more significant in a good solvent than a poor solvent. Interestingly, however, the stagnant film thickness (polymer swollen thickness minus the slip length) collapsed to almost a singular value for a given grafting density regardless of solvent quality, likely suggesting a large gradient of segmental mobility at nonequilibrium. Moreover, we found that slip flow penetrates into soft pNIPAM surfaces more deeply in a good solvent than in a poor solvent and that this behavior was general and independent of grafting density. This behavior is counter to the notion that less interaction between a fluid (probe) and a solid surface promotes slip.