Hydrolysis Kinetics of Low-Concentration Industrial TiOSO4 Solution and Structural Evolution of Metatitanic Acid

Using the industrial low-concentration TiOSO4 solution as the raw material, the hydrolysis kinetics and structural evolution of metatitanic acid was investigated. The samples were characterized by TiO2 content, XRD analysis, particle size distribution, FT-IR spectroscopy, Raman analysis, and HRTEM. The curves of hydrolysis yield showed S type shape, and the hydrolysis process consisted of the induction period, rapid hydrolysis period, and mature period. The rapid hydrolysis period was the first-order reaction, and increasing of hydrolysis temperature would shorten the induction period and hydrolysis period while prolonging the mature period had an approximate linear positive correlation on the hydrolysis yield and hydrolysis rate. The actual hydrolysis yield at the graying point was consistent with the calculated hydrolysis yield. The calculated pre-exponential factor k0 was 1.40 × 1018 min-1 and activation energy Ea was of 147.6 kJ/mol. With the hydrolysis temperature increasing, the grain size increased, the lattice stress decreased, the average particle size of metatitanic acid decreased, and the sulfur content decreased, resulting from the growth and adjustment of crystals and colloidal particles. Also, the SO42- ions promoted the formation of anatase TiO2 crystals. The formation of the precipitated particles underwent processes such as gel, crystal growth, aggregation, and condensation.

Exploring and exploiting different catalytic systems for the direct conversion of cellulose into levulinic acid

The single step conversion of cellulose into levulinic acid has been studied under hydrothermal conditions with several catalytic systems.

Whiter, brighter, and more stable cellulose paper coated with TiO2 /SiO2 core/shell nanoparticles using a layer-by-layer approach

To inhibit the photocatalytic degradation of organic material supports induced by small titania (TiO2 ) nanoparticles, four kinds of TiO2 nanoparticles, that is, commercial P25-TiO2 , commercial rutile phase TiO2 , rutile TiO2 nanorods and rutile TiO2 spheres, prepared from TiCl4 , were coated with a thin, but dense, coating of silica (SiO2 ) using a conventional sol-gel technique to form TiO2 /SiO2 core/shell nanoparticles. These core/shell particles were deposited and fixed as a very thin coating onto the surface of cellulose paper samples by a wet-chemistry polyelectrolyte layer-by-layer approach. The TiO2 /SiO2 nanocoated paper samples exhibit higher whiteness and brightness and greater stability to UV-bleaching than comparable samples of blank paper. There are many potential applications for this green chemistry approach to protect cellulosic fibres from UV-bleaching in sunlight and to improve their whiteness and brightness.

Preparation and characterization of photoactive composite kaolinite/TiO(2)

Preparation of nanocomposite kaolinite/TiO(2), using hydrolysis of titanyl sulfate in the presence of kaolin was addressed. A variable (kaolin)/(titanyl sulfate) ratio has been used in order to achieve the desired TiO(2) content in prepared nanocomposites. Calcination of the composites at 600 °C led to the transformation of the kaolinite to metakaolinite and to origination of metakaolinite/TiO(2) composites. The prepared samples were investigated using X-ray fluorescence spectroscopy, X-ray powder diffraction, Fourier transform infrared spectroscopy, scanning electron microscopy, thermogravimetry and diffuse reflectance spectroscopy in the UV-VIS region. Structural ordering of TiO(2) on the kaolinite particle surface was modeled using empirical force field atomistic simulations in the Material Studio modeling environment. Photodegradation activity of the composites prepared was evaluated by the discoloration of Acid Orange 7 aqueous solution.