Comparison with Magnetic Resonance Three-Dimensional Sequence for Lumbar Nerve Root with Intervertebral Foramen

Diagnostic utility of 3D MRI sequences in the assessment of central, recess and foraminal stenoses of the spine: a systematic review

OBJECTIVE

To perform a systematic literature review on the diagnostic utility of 3D MRI sequences in the assessment of central canal, recess and foraminal stenosis in the spine.

METHODS

The databases PubMed, MEDLINE (via OVID) and The Cochrane Central Register of Controlled Trials, were searched for studies that investigated the diagnostic use of 3D MRI to evaluate stenoses in various parts of the spine in humans. Three reviewers examined the literature and conducted systematic review according to PRISMA 2020 guidelines.

RESULTS

Thirty studies were retrieved from 2 595 publications for this systematic review. The overall diagnostic performance of 3D MRI outperformed the conventional 2D MRI with reported sensitivities ranging from 79 to 100% and specificities ranging from 86 to 100% regarding the evaluation of central, recess and foraminal stenoses. In general, high level of agreement (both intra- and interrater) regarding visibility and pathology on 3D sequences was reported. Studies show that well-optimized 3D sequences allow the use of higher spatial resolution, similar scan time and increased SNR and CNR when compared to corresponding 2D sequences. However, the benefit of 3D sequences is in the additional information provided by them and in the possibility to save total protocol scan times.

CONCLUSION

The literature on the spine 3D MRI assessment of stenoses is heterogeneous with varying MRI protocols and diagnostic results. However, the 3D sequences offer similar or superior detection of stenoses with high reliability. Especially, the advantage of 3D MRI seems to be the better evaluation of recess stenoses.

3D MRI of the Spine

Three-dimensional (3D) magnetic resonance imaging of the spine is now clinically feasible due to technological advancements. Its advantages over two-dimensional imaging include higher in-plane spatial resolution and the ability for reformation in any plane that enables time savings in image acquisition and aids more accurate interpretation. Multispectral 3D techniques for imaging around metal are sometimes useful for evaluating anatomy adjacent to spinal fixation hardware. 3D gradient-recalled echo sequences, including ultrashort or zero time to echo sequences, can provide osseous detail similar to conventional computed tomography.

EVALUATION OF THE LUMBAR SAFETY TRIANGLE THROUGH MAGNETIC RESONANCE IMAGING

ABSTRACT Objective: To evaluate the lumbar triangular safety zone, its boundaries and its relationship with the dorsal root ganglion through Magnetic Resonance Imaging (MRI). Methods: The boundaries, shape and dimensions of 303 triangular safety zones were analyzed in Tesla 3.0 Magnetic Resonance Imaging (MRI) coronal sections from L2 to L5, including the dorsal root ganglion. Results: The sample consisted of 101 patients with a mean age of 32 years. The height of the triangular safety zone was formed by the lateral edge of the dura mater, the width by the upper plateau of the lower vertebra and the hypotenuse by the corresponding nerve root. The mean dimensions and the area varied according to the level studied. The dorsal root ganglion invaded the dimensions of the triangle in all the images studied. Conclusion: Based on the data and the analyses performed, we concluded that knowledge of the boundaries of the triangular safety zone through MRI increases the safety of minimally invasive procedures in the lumbar spine. Level of evidence I; Diagnostic studies – Investigation of a diagnostic test.

Morphological evaluation of the calcaneofibular ligament in different ankle positions using a three-dimensional MRI sequence

PURPOSE

Evaluating images of the lateral ligament of the ankle is not easy, and evaluation of the calcaneofibular ligament (CFL) in particular is difficult. We prospectively conducted morphological measurements of the CFL in different ankle positions and obtain basic data for use in functional assessment of the CFL, diagnosis of CFL injury, and determination of treatment effects.

METHODS

The subjects were ten healthy volunteers (ten ankles) with a mean age of 27.8 years and no history of ankle disease. Imaging was done using a 3-T magnetic resonance imaging (MRI) machine and fast imaging employing steady-state acquisition cycled phases (FIESTA-C), a three-dimensional (3D) sequence, with the ankle in a neutral position, maximum dorsiflexion, and maximum plantar flexion. 3D images of the CFL, peroneal muscle tendons, fibula, and calcaneus were prepared at a workstation, and morphological measurements of the CFL were made.

RESULTS

In all positions, the CFL showed a gently curving course with the peroneal muscle tendons as a fulcrum. The tortuosity angle was significantly smaller in plantar flexion (30.0° ± 7.4°) than in the neutral position (41.7° ± 8.3°).

CONCLUSIONS

3D MRI sequences showed that, in all positions, the CFL curved due to the influence of the peroneal muscle tendons. With maximum plantar flexion, the CFL tortuosity angle was small, which was thought to have been due to the tension in the CFL.

Spinal endoscopy combined with selective CT myelography for dural closure of the spinal dural defect with superficial siderosis: technical note

The authors describe a new procedure to detect the tiny dural hole in patients with superficial siderosis (SS) and CSF leakage using a coronary angioscope system for spinal endoscopy and selective CT myelography using a spinal drainage tube. Under fluoroscopy, surgeons inserted the coronary angioscope into the spinal subarachnoid space, similar to the procedure of spinal drainage, and slowly advanced it to the cervical spine. The angioscope clearly showed the small dural hole and injured arachnoid membrane. One week later, the spinal drainage tube was inserted, and the tip of the drainage tube was located just below the level of the dural defect found by the spinal endoscopic examination. This selective CT myelography clarifies the location of the dural defect. During surgery, the small dural hole could be easily located, and it was securely sutured. It is sometimes difficult to detect the actual location of the small dural hole even with thin-slice MRI or dynamic CT myelography in patients with SS. The use of a coronary angioscope for the spinal endoscopy combined with selective CT myelography may provide an effective examination to assess dural closure of the spinal dural defect with SS in cases without obvious dural defects on conventional imaging.

Clinical utility of optimized three-dimensional T1-, T2-, and T2*-weighted sequences in spinal magnetic resonance imaging

This article reviews the clinical utility of 3D magnetic resonance imaging (MRI) sequences optimized for the evaluation of various intraspinal lesions. First, intraspinal tumors with hypervascular components and arteriovenous malformations (AVM) are clearly shown on contrast-enhanced (CE)-3D T1-weighted gradient-echo (GE) sequences with high spatial resolution. Second, dynamic CE-3D time-resolved magnetic resonance angiography (MRA) shows delineated feeding arteries of intraspinal AVM or arteriovenous fistula (AVF), greatly aiding subsequent digital subtraction angiography (DSA). Third, 3D multiecho T2*-weighted GE sequences are used to visualize intraspinal structures and spinal cord lesions and are sensitive to the magnetic susceptibility of intraspinal hemorrhages. Three-dimensional balanced steady-state free precession (SSFP) and multishot 3D balanced non-SSFP sequences produce contiguous thin images with high signal-to-noise ratio (SNR) in short scanning times. Intraspinal cystic lesions and small nerve-root tumors in subarachnoid space can be viewed using 3D balanced SSFP. Spinal cord myelomalacia and cord compression can be evaluated on fat-suppressed multishot 3D balanced non-SSFP. Finally, a 3D T2-weighted fast spin-echo (FSE) sequence with variable flip angle (FA) refocusing pulse improves through-plane spatial resolution over conventional 2D T2-weighted FSE sequences while matching image contrast.

A controlled study on the anatomy of cervical extraforaminal ligaments and three-dimensional fast-imaging employing a steady-state acquisition sequence

PURPOSE

To evaluate the utility of magnetic resonance three-dimensional fast-imaging employing a steady-state acquisition (MR 3D-FIESTA) sequence to study cervical EFLs using the anatomical results of cadavers as the gold standard.

METHODS

Part I: The cervical regions of five embalmed adult cadavers were scanned using the MR 3D-FIESTA sequence. Ligamentous structures in the intervertebral foramina (IVFs) between C4 and T1 in the MRI scans were identified by a radiologist. Part II: After the specimens were scanned, gross and microscopic anatomical studies were conducted on the IVFs between C4 and T1 in the specimens by an anatomist. Part III: Using the anatomical results of the cadavers as the gold standard, the utility of the MR 3D-FIESTA sequence for imaging cervical EFLs was evaluated. Specificity, sensitivity, positive and negative predictive values (PPV and NPV, respectively) and accuracy were calculated.

RESULTS

The occurrence rate of transforaminal ligaments (TFLs) in the IVFs between C4 and T1 was 42.5%. The results obtained by the radiologist using the MR 3D-FIESTA sequence to identify TFLs are as follows: specificity 96.2%, sensitivity 76.5%, PPV 92.9%, NPV 86.2%, and accuracy 88.4%.

CONCLUSION

MR 3D-FIESTA sequences clearly showed cervical EFLs. In the 3D-FIESTA sequence scans that the radiologist believed to indicate the presence of a cervical TFL, the probability that the TFL existed was approximately 93%. When the radiologist believed that no TFL was present in the 3D-FIESTA sequence scan, the probability that a TFL existed was 14%.