[Study of skin markers for magnetic resonance imaging examinations]

Assessing osteoporosis in postmenopausal women: preliminary results using a novel lumbar spine phantom-based MRI scoring method

OBJECTIVE

To develop a novel magnetic resonance imaging (MRI) phantom for producing F-score (for fat) and W-score (for water) and to evaluate the performance of these scores in assessing osteoporosis and related vertebral fractures.

MATERIALS AND METHODS

First, a real-time phantom consisting of oil and water tubes was manufactured. Then, 30 female volunteers (age: 62.3 ± 6.3 years) underwent lumbar spine examination with MRI (using a novel phantom) and dual-energy X-ray absorptiometry (DXA), following ethical approval. MRI phantom-based F-score and W-score were defined by normalizing the vertebral signal intensities (SIs) by the oil and water SIs of the phantom on T1- and T2-weighted images, respectively. The diagnostic performances of the new scores for assessing osteoporosis and vertebral fractures were examined using receiver operating characteristic analysis and compared with DXA-measured areal bone mineral density (DXA-aBMD).

RESULTS

The F-score and W-score were greater in the osteoporotic patients (3.93 and 2.29) than the non-osteoporotic subjects (3.05 and 1.79) and achieved AUC values of 0.85 and 0.74 (p < 0.05), respectively, when detecting osteoporosis. Similarly, F-score and W-score had greater values for the fracture patients (3.94 and 2.53) than the non-fracture subjects (3.14 and 1.69) and produced better AUC values (0.90 for W-score and 0.79 for F-score) compared to DXA-aBMD (AUC: 0.27, p < 0.05). In addition, the F-score and W-score had a strong correlation (r = 0.77; p < 0.001).

CONCLUSION

A novel real-time lumber spine MRI phantom was developed, based upon which newly defined F-score and W-score were able to detect osteoporosis and demonstrated an improved ability over DXA-aBMD in differentiating patients with vertebral fractures.

Development of a Surface Marker for Fractional Anisotropy Maps Using Wood in a Phantom Study

Purpose:

To improve imaging, a reliable setup method is critical for the accurate localization of lesions and surface markers. Because an anisotropic marker has not yet been validated for MRI, direct localization of surface markers is not yet feasible in fractional anisotropy (FA) maps. This study aimed to develop an anisotropic surface marker using wood for an FA map and to determine whether a wood marker is useful for various sequences.

Methods:

Wood infiltrated with water was used to develop an anisotropic surface marker. The wood marker was compared with phantoms composed of clinically available markers, including MR-SPOTS Packets (Beekley Medical, Bristol, CT, USA), Breath Care Oral Refreshing Capsules (Kobayashi Pharmaceutical Co., Ltd., Osaka, Japan), and baby oil (Johnson & Johnson, New Brunswick, NJ, USA). Magnetic resonance images were acquired using the Achieva 3T TX MRI System (Philips HealthCare, Best, Netherlands) equipped with a QD head coil including T₁- and T₂-weighted imaging, proton-density-weighted imaging, T2* -weighted imaging, T₁-weighted imaging spectral pre-saturation with inversion recovery, T₂-weighted imaging spectral attenuated inversion recovery, proton-density-weighted imaging spectral attenuated inversion recovery, diffusion weighted imaging, and diffusion tensor imaging. Apparent diffusion coefficient, FA values, and signal-to-noise ratio (SNR) were measured and recorded, and the coefficient of variation was calculated for two consecutive imaging scans. The wood was observed using a microscope.

Results:

Breath Care Oral Refreshing Capsules and baby oil were not observed in the FA map. The FA value of the MR-SPOTS Packets was 0.18. The FA value of the wood marker was 0.80. The coefficient of variation of the MR-SPOTS Packets and the wood marker were 0.0263 and 0.0013, respectively, in the FA map. Microscopic observation revealed a wood anisotropic structure.

Conclusion:

The wood maker enabled direct localization in the FA map. Hence, wood markers may be useful to radiologists and contribute to obtaining useful findings.