Influence of disorder on conductance in bilayer graphene under perpendicular electric field

Electron transport in bilayer graphene placed under a perpendicular electric field is revealed experimentally. Steep increase of the resistance is observed under high electric field; however, the resistance does not diverge even at low temperatures. The observed temperature dependence of the conductance consists of two contributions: the thermally activated (TA) conduction and the variable range hopping (VRH) conduction. We find that for the measured electric field range (0-1.3 V/nm) the mobility gap extracted from the TA behavior agrees well with the theoretical prediction for the band gap opening in bilayer graphene, although the VRH conduction deteriorates the insulating state more seriously in bilayer graphene with smaller mobility. These results show that the improvement of the mobility is crucial for the successful operation of the bilayer graphene field effect transistor.

Low operating bias and matched input-output characteristics in graphene logic inverters

We developed a simple and novel method to fabricate complementary-like logic inverters based on ambipolar graphene field-effect transistors (FETs). We found that the top gate stacks (with both the metal and oxide layers) can be simply prepared with only one-step deposition process and show high capacitive efficiency. By employing such a top gate as the operating terminal, the operating bias can be lowered within 2 V. In addition, the complementary p- and n-type FET pairs can be also simply fulfilled through potential superposition effect from the drain bias. The inverters can be operated, with up to 4-7 voltage gains, in both the first and third quadrants due to the ambipolarity of graphene FETs. For the first time, a match between the input and output voltages is achieved in graphene logic devices, indicating the potential in direct cascading of multiple devices for future nanoelectronic applications.

Field-induced carrier delocalization in the strain-induced mott insulating state of an organic superconductor

We report the influence of the field effect on the dc resistance and Hall coefficient in the strain-induced Mott insulating state of an organic superconductor kappa-(BEDT-TTF)(2)Cu[N(CN)(2)]Br. Conductivity obeys the formula for an activated transport sigma(square)=sigma(0)exp(-W/k(B)T), where sigma(0) is a constant and W depends on the gate voltage. The gate-voltage dependence of the Hall coefficient shows that, unlike in conventional field-effect transistors, the effective mobility of dense hole carriers ( approximately 1.6x10(14) cm(-2)) is enhanced by a positive gate voltage. This implies that carrier doping involves delocalization of intrinsic carriers that were initially localized due to electron correlation.

Simple and scalable gel-based separation of metallic and semiconducting carbon nanotubes

We report a rapid and scalable method for the separation of metallic and semiconducting single-wall carbon nanotubes (SWCNTs); the separation is performed by the selective adsorption of semiconducting SWCNTs on agarose gel. The most effective separation was realized by a simple procedure in which a piece of gel containing SWCNTs and sodium dodecyl sulfate was frozen, thawed, and squeezed. This process affords a solution containing 70% pure metallic SWCNTs and leaves a gel containing 95% pure semiconducting SWCNTs. Field-effect transistors constructed from the separated semiconducting SWCNTs have been demonstrated to function without any electrical breakdown.

In-crystal and surface charge transport of electric-field-induced carriers in organic single-crystal semiconductors

Gate-voltage dependence of carrier mobility is measured in high-performance field-effect transistors of rubrene single crystals by simultaneous detection of the longitudinal conductivity sigma(square) and Hall coefficient R(H). The Hall mobility mu(H) (identical with sigma(square)R(H)) reaches nearly 10 cm(2)/V s when relatively low-density carriers (<10(11) cm(-2)) distribute into the crystal. mu(H) rapidly decreases with higher-density carriers as they are essentially confined to the surface and are subjected to randomness of the amorphous gate insulators. The mechanism to realize high carrier mobility in the organic transistor devices involves intrinsic-semiconductor character of the high-purity organic crystals and diffusive bandlike carrier transport in the bulk.

Direct Formation of Micro-/Nanocrystalline 2,5-Dimethyl-N,N‘-dicyanoquinonediimine Complexes on SiO2/Si Substrates and Multiprobe Measurement of Conduction Properties

Multiprobe measurements were performed on tiny single crystals of DMe-DCNQI complexes prepared directly on SiO2/Si substrates. The differences in conduction properties between the micro- and nanocrystals and bulk crystals were observed.

Gate-voltage dependence of zero-bias anomalies in multiwall carbon nanotubes

Temperature dependence of zero-bias conductance of the vanadium (V)/multiwall carbon nanotube (MWNT)/V structure is studied. As temperature is reduced, the conductance decreases with a functional form consistent with a power law. For the first time, we find that the exponent depends significantly on gate voltage. This exponent dependence cannot be explained by Luttinger-liquid theory for ballistic MWNTs. We interpret the obtained results within the framework of the nonconventional Coulomb blockade theory for strongly disordered MWNTs.

Consideration on peak shape in a batch-type chemiluminescence detection cell for capillary electrophoresis

Peak areas, peak heights, and apparent theoretical plate numbers were examined as a function of sample injection times by use of the batch-type CL detection cell. Comparing the experimental data with those obtained by absorption detector, some considerations were carried out about the peak shape. The peak shape in CL detection was influenced by not only concentration distribution of sample in a sample zone but also sample diffusion and CL reaction at the capillary outlet. The sample injection time of ca. 35 s was recommended for the present CE with CL detector. The injection time much influenced peak shape as well as sensitivity in the CL detection cell.

Sensitive determination of metal ions by liquid chromatography with tris(2,2'-bipyridine) ruthenium (II) complex electrogenerated chemiluminescence detection

Emetine dithiocarbamate metal complex, which is prepared from emetine, carbon disulfide, and metal (II), was found to indicate a large chemiluminescence intensity on the electrogenerated chemiluminescence of tris(2,2'-bipyridine)ruthenium(II). Liquid chromatography equipped with the chemiluminescence detection was developed for analyzing trace metal ions by use of the metal complex formation. The mixture of the Cu(II) and Co(II) complexes as a model sample was injected into the LC system. The two metal complexes and an excess emetine were successfully separated. The Cu(II) and Co(II) complexes were determined over the range 1-300 nM (the detection limit of 650 fg) and 30-5000 nM (the detection limit of 17 pg), respectively.

Microchip capillary electrophoresis using on-line chemiluminescence detection

Chemiluminescence detection was used in capillary electrophoresis integrated on a microchip. Quartz microchips have two main channels and four reservoirs. Dansyl-lysine and -glycine were separated and detected with bis[(2-(3,6,9-trioxadecanyloxycarbony)-4-nitrophenyl]oxalate as peroxyoxalate chemiluminescent reagent. These dansyl amino acids came into contact with the chemiluminescence reagent to produce visible light at the interface between the separation channel and chemiluminescence reagent-containing reservoir. The detection limit (S/N = 3) for dansyl-lysine was 1 x 10(-5) M, which corresponded to the very small mass detection limit of ca. 0.4 fmol. However, the concentration sensitivity in the present system was approximately two orders of magnitude lower than that in the conventional capillary electrophoresis-chemiluminescence detection system. The relative standard deviations of migration time and peak height for dansyl-lysine were 4.2 and 4.5%, respectively. A channel conditioning before every run and an appropriate control of voltages were needed for the reproducible results. The present system had advantages in rapid separation time (within 40 s), small (several 10 pI) and accurate sample injection method using a cross-shaped injector, and simplification and miniaturization of the detection device.

Chemiluminescence detection of heme proteins separated by capillary isoelectric focusing

Chemiluminescence detection was combined with capillary isoelectric focusing to perform protein analysis with high sensitivity. Luminol-H2O2 chemiluminescence was utilized, and heme proteins such as cytochrome c, myoglobin and peroxidase were analyzed. The proteins were focused by use of Pharmalyte 3-10 as ampholytes. Hydroxypropylmethyl-cellulose was added to the sample solution in order to easily reduce protein interactions with the capillary wall as well as the electroendoosmotic flow. The focused proteins were transported by salt mobilization to chemiluminescence detection cell equipped with an optical fiber. The present method showed significantly high sensitivity and wide dynamic range; the detection limit for cytochrome c was 6 x 10(-9) M and the linear dynamic range was greater than two-orders of magnitude (up to 2 x 10(-6) M).

Setting up an automated system for evaluation of bone age

The "Tanner-Whitehouse 2" method is the most popular in evaluating skeletal maturation, but this method has some inherent weak points. We therefore developed the new system to automatically evaluate the skeletal maturation of Japanese children by means of a personal computer. The subjects of this study were 318 healthy Japanese boys and 199 girls ranging from 2 to 15 years of age. The bone age was calculated by multiple regression analysis with parameters for the epiphysis and metaphysis. Successful automatic evaluation was about 80-90% on each phalanx. There was a significant correlation between chronological age and the ratio of epiphyseal width to metaphyseal width. The system developed in this study was useful for evaluating the skeletal maturation.

Standard RUS skeletal maturation of Tokyo children

A total of 704 girls and 753 boys, all healthy, from 3 to 18 years of age, from Tokyo and its suburbs, were radiographed on the left hand and wrist in 1986. Their RUS (TW2) skeletal maturity was estimated, the 50th-centile skeletal maturity scores were obtained, and the smoothed RUS maturity curves were determined applying the cubic spline function to the 50th-centile scores. On this maturity curve the score at each 0.1 year of chronological age was obtained and allocated as a given RUS skeletal age. This set of scores and ages we termed the TW2-J RUS, i.e. the Japanese TW2 RUS maturity standard. Comparing this RUS standard with the British standard, the Belgian, the southern Chinese, and the northern Indian, it became clear that Japanese children's RUS skeletal maturity progresses rapidly during puberty (after ages 9 in girls and 11 in boys), and that the maximum score difference between neighbouring age groups was observed at ages 12.5 in girls and 14.5 in boys on the spline-smoothed curve. Japanese children attain the adult stage 1 or 2 years earlier than other groups of children (at ages 15 in girls and 16 in boys).

Aberrant expression of a hemidesmosomal protein, bullous pemphigoid antigen 2, in human squamous cell carcinoma

Through yet unidentified mechanisms, squamous epithelial cells become committed to terminal differentiation after detachment from the basement membrane. In squamous cell carcinoma, these mechanisms seem to be disturbed. A murine monoclonal antibody, designated NCC-Lu-226 (IgG1, K), which recognizes an antigen expressed in basal cells of squamous epithelium at the epithelio-connective tissue border, was obtained. A cDNA clone encoding the antigen was isolated from a cDNA library by immunoselection. DNA sequencing and a database search revealed that this cDNA clone was identical to a hemidesmosomal transmembrane protein, bullous pemphigoid antigen 2 (BPA-2; also known as BPAG2, BP180, or type XVII collagen). Immunoelectron microscopy validated the specific reactivity of this monoclonal antibody with skin hemidesmosomes. Enhanced expression and abnormal distribution of BPA-2 was revealed immunohistochemically in various precancerous and cancerous tissues, including solar keratosis (4 of 5), Bowen's disease (3 of 5), invasive squamous cell carcinoma (7 of 7) of the skin, and squamous cell carcinoma of the lung (14 of 14), esophagus (12 of 13), and cervix (14 of 17). The specific expression of BPA-2 protein in squamous cell carcinoma was confirmed by RT-PCR and Northern hybridization. BPA-2 has possible phosphorylation sites and is actually phosphorylated in cultured keratinocytes and squamous cell carcinoma. The aberrant expression of BPA-2 may reflect dysfunction of the hemidesmosome that occurs as a relatively early event in multistep carcinogenesis of squamous epithelium.

[Ferruginous bodies in the lungs of the general population during a 45-year period and mineralogical examination]

In order to determine the level of asbestos pollution in the lungs of members of the general population in and around Tokyo, the incidence of ferruginous bodies in autopsied or resected lungs during 5 periods over the 45 years from 1937 to 1981 was studied by a light microscopy. Core fibres, after removal of their ferruginous coatings with oxalic acid, and uncoated fibres were analyzed using a scanning electron microscope equipped with a Kevex energy-dispersive X-ray spectrometer. The incidence of ferruginous bodies in 5 g (wet) of digested lung tissue was shown to be 10% in period I (1937-1941), 18% in period II (1947-1951), 70% in period III (1958-1963), 74.4% in period IV (1970-1973) and 81.0% in period V (1980-1981). The major types of core fibres of ferruginous bodies were found to be asbestos, including amosite, crocidolite, chrysotile and the tremolite-actiolite series, but a small number of fibers of materials other than asbestos were also detected. In contrast, a large number of short fibers less than 5 microns in length in 1 g of wet lung tissue were classified as belonging to Mg + Si fibers (the ratio of Mg to Si components being 30% or over) and presumed to be chrysotile. Thus an annual increase in asbestos deposition in lungs of people living in and around Tokyo has been demonstrated and fine chrysotile fibers less than 5 microns in length seem to be the main type of deposited fibers.