An Acute Mercuric Mercury Poisoning: Chemical Speciation of Hair Mercury Shows a Peak of Inorganic Mercury Value

A woman ingested a dose of sublimate (approximately 0.9 g) in an attempted suicide. She survived and recovered in response to a combination of therapies including chelate (BAL) therapy, plasma exchange, haemodialysis and peritoneal dialysis.

Serum inorganic mercury concentration, urinary inorganic mercury excretion and hair inorganic and organic mercury and selenium concentrations, along the length from the scalp to the distal part, were measured. Longitudinal analysis of hair, revealed a peak in inorganic mercury corresponding to the time of mercury ingestion. Organic mercury and selenium in the hair had different patterns of longitudinal variation from that of inorganic mercury. The biological half-life (23.5 d) of serum inorganic mercury levels was in good agreement with values previously reported in the literature.

Site-specific associations of muscle thickness with bone mineral density in middle-aged and older men and women

It is unknown whether age-related site-specific muscle loss is associated with areal bone mineral density (aBMD) in older adults. To examine the relationships between aBMD and whole-body muscle thickness distribution, 97 healthy adults (46 women and 51 men) aged 50-78 years volunteered. Total and appendicular lean soft tissue mass, aBMD of the lumbar spine (LS-aBMD) and femoral neck (FN-aBMD) were determined using dual-energy X-ray absorptiometry. Muscle thickness (MT) was measured by ultrasound at nine sites of the body (forearm, upper arm, trunk, upper leg, and lower leg). Relationships of each co-variate with aBMD were tested partialling out the effect of age. aBMD was not correlated with either MT of the trunk or anterior lower leg in either sex. In men, significant and relatively strong correlations were observed between anterior and posterior upper arms, posterior lower leg, and anterior upper leg MT and LS-aBMD or FN-aBMD. In women, significant correlations were observed between anterior and posterior upper legs, posterior lower leg, and anterior upper arm MT and FN-aBMD. LS-aBMD was only correlated with forearm and posterior upper leg MT in women. In conclusion, the site-specific association of MT and aBMD differs between sexes and may be associated with the participants' daily physical activity profile.

Induction Immunosuppressive Therapy With Everolimus and Low-Dose Tacrolimus Extended-Release Preserves Good Renal Function at 1 Year After Kidney Transplantation

BACKGROUND

Utilization of everolimus (EVR) has been increasing in recent years for patients undergoing renal transplantation to reduce calcineurin inhibitor (CNI) levels. However, an optimum regimen has yet to be established.

METHODS

We retrospectively examined 12 renal transplant recipients who underwent an induction immunosuppressive protocol; the protocol comprises 5 agents, including EVR plus low-dose tacrolimus extended-release (TAC-ER) treatment. We compared those findings from those of 14 patients who underwent a conventional protocol without EVR. Clinical outcome and pathologic changes were assessed by using protocol graft biopsy findings obtained at 3 months and 1 year after transplantation.

RESULTS

The estimated glomerular filtration rate was significantly higher for the EVR group at both 3 months and 1 year compared with the conventional group (P < .01 and P = .03, respectively). TAC-ER trough levels were also significantly lower at 3 months and 1 year (both, P < .01). Histologic findings of the 3-month protocol biopsy samples in the EVR group revealed 4 cases of borderline change and 2 of acute cellular-mediated rejection. The findings from the 1-year biopsy samples revealed 10 cases with normal findings with no evidence of CNI toxicity. Patients in the EVR group developed subclinical borderline change and acute cellular-mediated rejection after 3 months at a significantly higher rate than the conventional group (P = .02).

CONCLUSIONS

Use of the present therapeutic strategy successfully maintained the trough of each drug at a lower level, and it also kept renal function stable up to 1 year after transplantation.

Large-Scale Shell-Model Analysis of the Neutrinoless ββ Decay of ^{48}Ca

We present the nuclear matrix element for the neutrinoless double-beta decay of ^{48}Ca based on large-scale shell-model calculations including two harmonic oscillator shells (sd and pf shells). The excitation spectra of ^{48}Ca and ^{48}Ti, and the two-neutrino double-beta decay of ^{48}Ca are reproduced in good agreement to the experimental data. We find that the neutrinoless double-beta decay nuclear matrix element is enhanced by about 30% compared to pf-shell calculations. This reduces the decay lifetime by almost a factor of 2. The matrix-element increase is mostly due to pairing correlations associated with cross-shell sd-pf excitations. We also investigate possible implications for heavier neutrinoless double-beta decay candidates.

Electron-bombarded ⟨110⟩-oriented tungsten tips for stable tunneling electron emission

A clean tungsten (W) tip apex with a robust atomic plane is required for producing a stable tunneling electron emission under strong electric fields. Because a tip apex fabricated from a wire by aqueous chemical etching is covered by impurity layers, heating treatment in ultra-high vacuum is experimentally known to be necessary. However, strong heating frequently melts the tip apex and causes unstable electron emissions. We investigated quantitatively the tip apex and found a useful method to prepare a tip with stable tunneling electron emissions by controlling electron-bombardment heating power. Careful characterizations of the tip structures were performed with combinations of using field emission I-V curves, scanning electron microscopy, X-ray diffraction (transmitted Debye-Scherrer and Laue) with micro-parabola capillary, field ion microscopy, and field emission microscopy. Tips were chemically etched from (1) polycrystalline W wires (grain size ∼1000 nm) and (2) long-time heated W wires (grain size larger than 1 mm). Heating by 10-40 W (10 s) was found to be good enough to remove oxide layers and produced stable electron emission; however, around 60 W (10 s) heating was threshold power to increase the tip radius, typically +10 ± 5 nm (onset of melting). Further, the grain size of ∼1000 nm was necessary to obtain a conical shape tip apex.

The acute muscular effects of cycling with and without different degrees of blood flow restriction

The aim was to compare the acute effects of work matched high intensity (75% peak aerobic capacity) aerobic exercise to low intensity (40% peak aerobic capacity) aerobic exercise with different degrees of blood flow restriction (BFR) [40% estimated arterial occlusion (40 BFR) and 60% estimated arterial occlusion (60 BFR)] on variables previously hypothesized to be important for muscle adaptation. There were no meaningful changes in torque. Anterior thigh muscle thickness was increased from baseline with high intensity cycling and 40 BFR (~2 mm increase, p ≤ 0.008). A significant increase in lactate occurred in all exercise conditions but was greatest with high intensity cycling (~5.4 mmol/L increase). Muscle activation was significantly higher with high intensity cycling compared to low intensity cycling with BFR, regardless of pressure (~25% vs. ~12% MVC). Mean power frequency was not different between conditions but did increase from the first 5 minutes of exercise to the last 5 minutes (93% vs. 101%, p < 0.001). Ratings of perceived exertion (RPE) were higher with high intensity cycling but discomfort was similar between conditions. We wish to suggest that high intensity cycling produces greater muscular stress than that observed with work matched low intensity cycling in combination with BFR.

Improvement of spinal alignment and quality of life after corrective surgery for spinal kyphosis in patients with osteoporosis: a comparative study with non-operated patients

This study evaluated changes in spinal alignment and quality of life (QOL) after corrective spinal surgery for patients with postmenopausal osteoporosis and spinal kyphosis. Spinal global alignment and QOL were significantly improved after corrective spinal surgery but did not reach the level of non-operated controls.

INTRODUCTION

With the increased aging of society, the demand for corrective spinal instrumentation for spinal kyphosis in osteoporotic patients is increasing. However, previous studies have not focused on the improvement of quality of life (QOL) after corrective spinal surgery in patients with osteoporosis, compared to non-operated control patients. The purposes of this study were thus to evaluate changes in spinal alignment and QOL after corrective spinal instrumentation for patients with osteoporosis and spinal kyphosis and to compare these results with non-operated patients.

METHODS

Participants comprised 39 patients with postmenopausal osteoporosis ≥50 years old who underwent corrective spinal surgery using multilevel posterior lumbar interbody fusion (PLIF) for symptomatic thoracolumbar or lumbar kyphosis, and 82 age-matched patients with postmenopausal osteoporosis without prevalent vertebral fractures. Spinopelvic parameters were evaluated with standing lateral spine radiography, and QOL was evaluated with the Japanese Osteoporosis QOL Questionnaire (JOQOL), SF-36, and Roland-Morris Disability Questionnaire (RDQ).

RESULTS

Lumbar kyphosis angle, sagittal vertical axis, and pelvic tilt were significantly improved postoperatively. QOL evaluated with all three questionnaires also significantly improved after 6 months postoperatively, particularly in domain and subscale scores for pain and general/mental health. However, these radiographic parameters, total JOQOL score, SF-36 physical component summary score, and RDQ score were significantly inferior compared with non-operated controls.

CONCLUSIONS

The results indicate that spinal global alignment and QOL were significantly improved after corrective spinal surgery using multilevel PLIF for patients with osteoporosis and spinal kyphosis but did not reach the level of non-operated controls.

Impairment of host resistance to helminthes with age in murine small intestine

Age-associated alterations of Th2 immune responses against nematode parasites are largely unknown. We investigated primary and memory responses against two types of gastrointestinal nematode parasites, Heligmosomoides polygyrus (Hp) and Nippostrongylus brasiliensis (Nb), in aged mice. The small intestinal gene expression of Th2 cytokines was almost unchanged after primary (Nb and Hp) and secondary infection (Hp) in aged mice in contrast to strongly increased small intestinal gene expression of Th2 cytokines in young (3-month-old) mice. Mucus production decreased (Nb), and worm expulsion was impaired (Nb and Hp) compared with the young mice. Immunofluorescent staining revealed that after Hp infection, the number of alternatively activated macrophages, which are induced by Th2 cytokines, was lower in the aged mice. On the other hand, the number of CD4(+) T cells recruited to the worm cysts was normal compared with the young mice. These results suggest that migration of CD4(+) T cells to the host-parasite interface is not affected by ageing. Alterations in Th2 immune responses in aged mice might be due to inappropriate or insufficient activation of CD4(+) T cells in the submucosa.

Relationship between fibrinopeptide a (FPA) level and fibrinogen kinetics in patients with malignant disease

The relationship between FPA level and fibrinogen turnover rate as well as fibrinolytic activity was studied in 18 patients with malignant diseases. It was found that the FPA levels were significantly elevated and were correlated with fibrinogen turnover rate (r = 0.74, p less than 0.001) and FDP (r = 0.58, p less than 0.02). The estimated FPA turnover rate was also correlated with fibrinogen turnover rate (r = 0.70, p less than 0.001). These results suggest that fibrinogen catabolism in patients with malignant disease is related to thrombin proteolysis. However, ratios of 1/2 FPA turnover rate to fibrinogen turnover rate suggest that intravascular thrombin proteolysis is not the major determinant of fibrinogen catabolism. It is suspected that extravascular thrombin proteolysis is responsible for the elevation of plasma FPA level which is correlated with acceleration of fibrinogen catabolism.

Whole-genome association study for fatty acid composition of oleic acid in Japanese Black cattle

Fatty acid composition, especially oleic acid (C18:1), plays an important role in the eating quality of meat in Japanese Black cattle. Therefore, the objective of this study was to identify loci associated with C18:1 in the intramuscular fat of the trapezius muscles in Japanese Black cattle using the Illumina BovineSNP50 BeadChip whole genome single nucleotide polymorphism (SNP) assay. We also evaluated the relationship between C18:1 and three fatty acid synthesis genes, fatty acid synthase (FASN), stearoyl-CoA desaturase and sterol regulatory element-binding protein-1. In this experiment, we applied a mixed model and Genomic Control approach using selective genotyping to perform a genome-wide association study. A total of 160 animals (80 animals with higher values and 80 animals with lower values), selected from 3356 animals based on corrected phenotype, were genotyped using the Illumina BovineSNP50 BeadChip and three fatty acid synthesis genes, and the quality of these SNPs was assessed. In this study, a total of 38 955 SNPs, which included SNPs in the three fatty acid synthesis genes, were used, and the estimated inflation factor was 1.06. In the studied population, a total of 32 SNPs, including the FASN gene, had significant effects, and in particular 30 SNPs of all significant SNPs were located between 49 and 55 Mbp on chromosome 19. This study is one of the first genome-wide association studies for fatty acid composition in a cattle population using the recently released Illumina BovineSNP50 BeadChip.

Thermal reactive ion etching technique involving use of self-heated cathode

In this work, the thermal reactive ion etching (TRIE) technique for etching hard-to-etch materials is presented. The TRIE technique employs a self-heated cathode and a thermally insulated aluminum plate is placed on the cathode of a regular reactive ion etching (RIE) system. By optimizing the beam size to support the sample stage, the temperature of the stage can be increased to a desired temperature without a cathode heater. The technique was used to etch a bulk titanium plate. An etch rate of 0.6 μm/min and an etch selectivity to nickel of 100 were achieved with SF6 plasma. The proposed technique makes a regular RIE system a more powerful etcher without the use of chlorine gas, a cathode heater, and an inductively coupled plasma source.