Highly sensitive biological and chemical sensors based on reversible fluorescence quenching in a conjugated polymer

Photophysics and electron transfer in poly(3-octylthiophene) alternating with Ru(II)- and Os(II)-bipyridine complexes

A series of soluble metal-organic polymers that contain Ru(II)- and Os(II)-polypyridine complexes interspersed within a pi-conjugated poly(3-octylthiophene) backbone are prepared. Detailed electrochemical and photophysical studies are carried out on the polymers and two model complexes to determine the extent that the metal-polypyridine units interact with the pi-conjugated system. The results indicate that there is a strong electronic interaction between the metal-based chromophores and the pi-conjugated organic segments, and consequently the photophysical properties are not simply based on the sum of the properties of the individual components. In the Ru(II) polymers, the metal-to-ligand charge-transfer (MLCT) excited state is slightly higher in energy than the 3 pi,pi* state of the poly(3-octylthiophene) backbone. This state ordering results in a material that displays only a weak MLCT luminescence and a long-lived transient absorption spectrum that is dominated by the 3 pi,pi* state. In the Os(II) polymer the MLCT state is lower in energy than the polythiophene-based 3 pi,pi* state and the "unperturbed" MLCT emission is observed. Finally, all of the metal-organic polymers undergo photoinduced bimolecular electron-transfer (ET) reactions with the oxidative quencher dimethyl viologen. Transient absorption spectroscopy reveals that photoinduced ET to dimethyl viologen produces the oxidized polymers, and in most cases, the transient spectra are dominated by features characteristic of a poly(3-octylthiophene) polaron.

Single chain spectroscopy of conformational dependence of conjugated polymer photophysics

Single molecule confocal fluorescence microscopy was used to perform photoluminescence spectroscopy on single, isolated molecules of the conjugated polymer poly[2-methoxy, 5-(2'-ethyl-hexyloxy)-p-phenylene-vinylene] (MEH-PPV). We show that the fluorescence from single chains of this electroluminescent polymer depends strongly on chain conformation. The time evolution of the spectra, emission intensity, and polarization all provide direct evidence that memory of the chain conformation in solution is retained after solvent evaporation. Chains cast from toluene solution are highly folded and show memory of the excitation polarization. Exciton funneling to highly aggregated low energy regions causes the chain to mimic the photophysical behavior of a single chromophore. Chains cast from chloroform, however, behave as multichromophore systems, and no sudden discrete spectral or intensity jumps are observed. These also exhibit different spectroscopy from the folded chromophores.

Affinity biosensor for avidin using a double functionalized dendrimer monolayer on a gold electrode

We have developed an affinity biosensor system based on avidin-biotin interaction on a gold electrode. As the building block of an affinity-sensing monolayer, a fourth-generation (G4) poly(amidoamine) dendrimer having partial ferrocenyl-tethered surface groups was prepared and used. The unmodified surface amine groups from dendrimers were functionalized with biotinamidocaproate, and the biotinylated and electroactive dendritic monolayer was constructed on a gold electrode for the affinity-sensing surface interacting with avidin. An electrochemical signal from the affinity biosensor was generated by free glucose oxidase in electrolyte, depending on the degree of coverage of the sensing surface with avidin. The sensor signal decreased correlatively with increasing avidin concentration and approached a minimum level when the sensing surface was fully covered with avidin. The detection limit of avidin was about 4.5 pM, and the sensor signal was linear ranging from 1.5 pM to 10 nM under optimized conditions. From the kinetic analysis using the biotinylated glucose oxidase, an active enzyme coverage of 2.5 x 10(-12) mol/cm(2) on the avidin-pretreated surface was registered, which demonstrates the formation of a spatially ordered and compact protein layer on the derivatized electrode surface.