Aggregation behavior of sodium cholate in aqueous solution

Micelle formation of sodium cholate and solubilization into the micelle

The micellization of sodium cholate (NaC) was studied at 298.2 K by aqueous solubility at different pH values. Using a stepwise association model of cholate anions without the sodium counterion, the aggregation number (n) of the cholate micelle was evaluated and found to increase with the total concentration, indicating that the mass action model worked quite well. The n value at 60 mM was found equal to 16. The membrane potential measurement of sodium ion with a cation exchange membrane was made in order to confirm the low counterion binding to micelle. The solubilization of alkylbenzenes (benzene, toluene, ethylbenzene, n-propylbenzene, n-butylbenzene, n-pentylbenzene, n-hexylbenzene) and polycyclic aromatic compounds (naphthalene, anthracene, pyrene) into the aqueous micellar solution of sodium cholate was carried out. Solubilizate concentrations at equilibrium were determined spectrophotometrically at 298.2 K. The first stepwise association constants (K1) between solubilizate monomer and vacant micelle were evaluated from the equilibrium concentrations and found to increase with increasing hydrophobicity of the solubilizate molecules. From the Gibbs energy change for solubilization at the different mean aggregation numbers and from molecular structure of the solubilizates, the function of sodium cholate micelle for solubilization was discussed and was compared with data from conventional aliphatic micelles.

Rapid estimation of octanol-water partition coefficients of pesticides by micellar electrokinetic chromatography

Micellar electrokinetic chromatography (MEKC) was evaluated as a new technique for the rapid estimation of octanol-water partition coefficient (logKow). Retention measurements for more than 40 reference pesticides with varied structural characteristics and hydrophobicity were carried out in two MEKC systems, based on sodium dodecyl sulfate (SDS) and sodium cholate (SC), respectively. To enable an accurate determination of capacity factors in the SC-MEKC system, cypermethrin (a synthetic pyrethroid insecticide) was utilized instead of Sudan III as the SC micelle tracer, since a few highly hydrophobic pesticides were found to elute after Sudan III. The linear correlation between logarithmic capacity factor (logk') and logKow in the two systems was examined. It was found that, under the typical buffer condition (10 mM sodium phosphate with 60 mM surfactant, pH 7.0), the SDS-MEKC system provided a somewhat wider dynamic range for hydrophobicity (logKow from -1.0 to 4.5). However, the correlation of logk' with logKow was not very high when all the reference pesticides were included in one single calibration set. For the SC-MEKC system, the dynamic range for logKow was in the range of 1.0-5.5, and a good linear correlation existed between logk' and logKow, even when all reference pesticides were incorporated into a single calibration group. By comparing the regression line of the reference pesticides with that of a group of simple aromatic derivatives, it was discovered that molecular size and functionality posed a less significant effect on the measurement of logKow in the SC-MEKC system than in the SDS-MEKC system. Thus, SC-MEKC shall be the system of choice for the estimation of logKow. The typical error on logKow determination using the current MEKC technique was within 0.5 units, suggesting that MEKC can be a valuable complement to reversed phase high performance liquid chromatography (RP-HPLC) for the indirect determination of logKow. Besides maintaining all the advantages of the HPLC approach, the MEKC technique showed some unique benefits, such as better inter-column reproducibility, higher throughput, and less handling of toxic pesticides and solvents.

Aggregation behavior of bile salts in aqueous solution

Freezing point depression, delta T/k, and pNa are measured and analyzed for aqueous solutions of trihydroxy (NaTC) and dihydroxy (NaDC and NaTDC) bile salts. The results show the existence of break points in the plot of delta T/k vs molality at 0.018, 0.013, and 0.007 m, respectively, in good agreement with previous published critical micelle concentration values. Above the break point bile salts form aggregates with average aggregation numbers of 2.59 +/- 0.12 (NaTC), 5.82 +/- 0.04 (NaDC), and 5.42 +/- 0.47 (NaTDC). Fractions of bound counterions are also deduced, being close to 0.3 for the three bile salts studied. This indicates that only one counterion is bound for every three monomers in the aggregate. The different structural models published for the bile salt aggregates are discussed.

Aggregation behavior of sodium fusidate in aqueous solution

We analyzed the freezing point depression and pNa measurements for aqueous solutions of sodium fusidate. At concentrations lower than 0.011 mol kg(-1), sodium fusidate behaves as a strong 1:1 electrolyte. At higher concentrations, sodium fusidate self-aggregates. To analyze the results two hypotheses on the monomer concentration are presented and discussed. The first one accepts that the monomer concentration, C(A), is constant and equal to 0.023 mol kg(-1). This concentration corresponds to a break point in the plot of the freezing point depression vs total sodium fusidate concentration, C(A)t. The second hypothesis accepts that C(A) increases with C(A)t following a leveling-off curve. Measurements of hydrodynamic radii and comparison with similar systems, such as sodium taurocholate, strongly support the second hypothesis. The results indicate that at concentrations lower than 0.08 mol kg(-1) the aggregation number increases from 2 to 3. Above this concentration, both the aggregation number and the fraction of bound counterions remain constant, with average values of 3.13 +/- 0.10 and 0.31 +/- 0.05, respectively. Such results indicate that for trimers only one Na+ counterion is involved per aggregate. We propose that this counterion shields the repulsion between the two nearest carboxylate groups which, according to a disklike model in which the monomers are packed with that group alternatively oriented up and down, should hold together. Values for the formation equilibrium constant of aggregates are also calculated. Its dependence with the aggregation number allows the determination of the reversible transfer of a free surfactant ion together with the associated counterions from the bulk solution to the aggregate, the resulting value being w(0) = -4.2k(B)T.