Ibuprofen transport into and through skin from topical formulations: in vitro-in vivo comparison

Estimation of ibuprofen in urine and tablet formulations by transmission Fourier Transform Infrared spectroscopy by partial least square

A rapid, reliable and cost effective analytical procedure for the estimation of ibuprofen in pharmaceutical formulations and human urine samples was developed using transmission Fourier Transform Infrared (FT-IR) spectroscopy. For the determination of ibuprofen, a KBr window with 500 μm spacer was used to acquire the FT-IR spectra of standards, pharmaceuticals as well as urine samples. Partial least square (PLS) calibration model was developed based on region from 1807 to 1,461 cm(-1) using ibuprofen standards ranging from 10 to 100 μg ml(-1). The developed model was evaluated by cross-validation to determine standard error of the models such as root mean square error of calibration (RMSEC), root mean square error of cross validation (RMSECV) and root mean square error of prediction (RMSEP). The coefficient of determination (R(2)) achieved was 0.998 with minimum errors in RMSEC, RMSECV and RMSEP with the value of 1.89%, 1.63% and 4.07%, respectively. The method was successfully applied to urine and pharmaceutical samples and obtained good recovery (98-102%).

Finite and infinite dosing: difficulties in measurements, evaluations and predictions

Due to the increased demand for reliable data regarding penetration into and permeation across human skin, assessment of the absorption of xenobiotics has been gaining in importance steadily. In vitro experiments allow for determining these data faster and more easily than in vivo experiments. However, the experiments described in literature and the subsequent evaluation procedures differ considerably. Here we will give an overview on typical finite and infinite dose experiments performed in fundamental research and on the evaluation of the data. We will point out possible difficulties that may arise and give a short overview on attempts at predicting skin absorption in vitro and in vivo.

Microneedle pretreatment enhances the percutaneous permeation of hydrophilic compounds with high melting points

Background

Two commercially available microneedle rollers with a needle length of 200 μm and 300 μm were selected to examine the influence of microneedle pretreatment on the percutaneous permeation of four non-steroidal anti-inflammatory drugs (diclofenac, ibuprofen, ketoprofen, paracetamol) with different physicochemical drug characteristics in Franz-type diffusion cells. Samples of the receptor fluids were taken at predefined times over 6 hours and were analysed by UV–VIS high-performance liquid-chromatography. Histological examinations after methylene blue application were additionally performed to gather information about barrier disruption.

Results

Despite no visible pores in the stratum corneum, the microneedle pretreatment resulted in a twofold (200 μm) and threefold higher (300 μm) flux through the pretreated skin samples compared to untreated skin samples for ibuprofen and ketoprofen (LogK_ow > 3, melting point < 100°C). The flux of the hydrophilic compounds diclofenac and paracetamol (logK_ow < 1, melting point > 100°C) increased their amount by four (200 μm) to eight (300 μm), respectively.

Conclusion

Commercially available microneedle rollers with 200–300 μm long needles enhance the drug delivery of topically applied non-steroidal anti-inflammatory drugs and represent a valuable tool for percutaneous permeation enhancement particularly for substances with poor permeability due to a hydrophilic nature and high melting points.

Novel imaging method to quantify stratum corneum in dermatopharmacokinetic studies: proof-of-concept with acyclovir formulations

PURPOSE

Tape-stripping the stratum corneum (SC) is used in the assessment of dermatopharmacokinetics (DPK). The amount of SC per tape can be determined gravimetrically, but a novel imaging method offers advantages in terms of sensitivity, reproducibility, precision, stability and speed. High-resolution images, acquired under controlled conditions, are analysed in terms of pixel greyscale values and distributions, and their usefulness in DPK studies is demonstrated in this study using acyclovir.

METHODS

At all tape-stripped sites, the SC amount per tape was measured gravimetrically and by imaging. In a first series of experiments, untreated sites were stripped to determine total SC thickness. Subsequently, post-application of two acyclovir creams, drug-permeation profiles were constructed.

RESULTS

The greyscale values from the imaging data can be used directly to estimate total SC thickness and DPK parameters. The results compared favourably with the traditional weighing method. The concentration of drug on each tape, as a function of the relative position within the SC, permitted diffusivity and partitioning parameters characterising the penetration of acyclovir to be derived.

CONCLUSION

The new imaging approach offers a sensitive, reproducible, precise, and rapid technique to quantify the relative SC amount removed on tape-strips, and facilitates the acquisition of DPK data.

Novel imaging method to quantify stratum corneum in dermatopharmacokinetic studies

PURPOSE

Tape stripping the stratum corneum (SC) is used in topical bioequivalence studies. Formulations are compared using drug concentration profiles as a function of relative SC position; both of these parameters require quantification of SC amount removed per tape. Here, a novel imaging method to quantify SC on tape strips is described. Comparisons are made with established SC quantification methods, specifically weighing and UV pseudo-absorption.

METHODS

Six stratum corneum tape strips were measured 15 times by the three methods, which were compared for precision, signal:noise ratio, sample size and speed. Furthermore, 600 tape strips were assayed by each method, and correlations examined.

RESULTS

Weighing exhibited low precision, extremely low signal:noise ratio, and was slow. UV pseudo-absorption had high precision, acceptable signal:noise ratio and was quick. However, only a fraction of the total SC removed is analysed, and inhomogeneity can affect the results. The new imaging method was precise, with high signal:noise ratio, and measured the whole SC sample, unaffected by inhomogeneity. In addition, the approach was rapid and has the potential for fast automated scanning of multiple tapes and for further image analysis.

CONCLUSION

The novel imaging method has many advantages over established methods for quantifying SC amount per tape.

The effect of formulation vehicles on the in vitro percutaneous permeation of ibuprofen

Background

The transdermal application of substances represents an elegant approach to overcome side effects related to injections or oral treatment. Due to benefits like a constant plasma level, no pain during application and a simple therapeutic regime, the optimization of formulations for transdermal drug delivery has gained interest in the last decades. Ibuprofen is a non-steroidal anti-inflammatory compound which is nowadays often used transdermally. The objective of this work was to conduct a study on the effect of different 5% ibuprofen containing formulations (Ibutop^® cream, Ibutop^® gel, and ibuprofen solution in phosphate buffered saline) on the in vitro-percutaneous permeation of ibuprofen through skin to emphasise the importance of the formulation on percutaneous permeation and skin reservoir.

Methods

The permeation experiments were conducted in Franz-type diffusion cells according to OECD guideline 428 with 2 mg/cm² ibuprofen formulation on each skin sample. Ibuprofen was analysed in the receptor fluid and extracted skin samples by UV-VIS high-performance liquid-chromatography at 238 nm. The plot of the cumulative amount of ibuprofen permeated versus time was employed to calculate the apparent permeability coefficient, the maximum flux and the lagtime, all of which were statistically analysed by One-way ANOVA.

Results

Although ibuprofen permeation out of the gel increases rapidly within the first four hours, the cream produced the highest ibuprofen delivery through the skin within 28 hours, followed by the solution and the gel. A significant shorter lagtime was found after gel treatment compared with the cream and the solution. After 28 hours 59% of the applied ibuprofen was found in the receptor fluid of the cream treated samples, 26% in the solution treated samples and 21% in the samples treated with the gel. Fourfold higher ibuprofen reservoirs were found in the solution and gel treated skin samples compared to the cream treated skin samples.

Conclusion

The present study demonstrates the importance of the formulation on transdermal drug delivery of ibuprofen and emphasises the differences of drug storage within the skin due to the formulation. Thus, it is a mistaken assumption that formulations comprising the same drug amount are equivalent regarding skin permeability.

Imaging drug delivery to skin with stimulated Raman scattering microscopy

Efficient drug delivery to the skin is essential for the treatment of major dermatologic diseases, such as eczema, psoriasis and acne. However, many compounds penetrate the skin barrier poorly and require optimized formulations to ensure their bioavailability. Here, stimulated Raman scattering (SRS) microscopy, a recently developed, label-free chemical imaging tool, is used to acquire high resolution images of multiple chemical components of a topical formulation as it penetrates into mammalian skin. This technique uniquely provides label-free, nondestructive, three-dimensional images with high spatiotemporal resolution. It reveals novel features of (trans)dermal drug delivery in the tissue environment: different rates of drug penetration via hair follicles as compared to the intercellular pathway across the stratum corneum are directly observed, and the precipitation of drug crystals on the skin surface is visualized after the percutaneous penetration of the cosolvent excipient in the formulation. The high speed three-dimensional imaging capability of SRS thus reveals features that cannot be seen with other techniques, providing both kinetic information and mechanistic insight into the (trans)dermal drug delivery process.

Mathematical model to predict skin concentration of drugs: toward utilization of silicone membrane to predict skin concentration of drugs as an animal testing alternative

PURPOSE

To calculate the skin concentration of active ingredients in cosmetics and topical pharmaceuticals using silicone membrane permeation.

METHODS

A series of parabens were used as model ingredients. Skin concentration of parabens was calculated using silicone membrane permeability. Their partition coefficient from formulations to the silicone membrane was determined by the membrane permeation profiles, and used to calculate their silicone membrane concentration, under an assumption that the membrane is one homogenous diffusion layer. The same procedure was applied for hairless rat skin.

RESULTS

The calculated concentration of parabens in silicone membrane was very close to their observed values. However, the skin concentration calculated by skin permeability was not similar to the observed concentration. Re-calculation was performed under the assumption that the skin consists of two diffusion layers. This modification using permeation data through full-thickness and stripped skin enabled precise prediction of the skin concentration of parabens. In addition, the partition coefficient to the silicone membrane was useful to estimate their skin concentration.

CONCLUSIONS

Ingredient concentration in skin can be precisely predicted using diffusion equations and partition coefficients through permeation experiments using a silicone membrane. The calculated in-skin concentration is useful for formulation studies of cosmetics and topical pharmaceuticals.

Infrared microspectroscopy analysis of ibuprofen release from drug eluting beads in uterine tissue

Ibuprofen loaded embolization beads (IBU-BB) have been developed to reduce inflammation and pain following uterine artery embolization for the treatment of uterine fibroids. The present work has investigated the elution properties of IBU-BB in situ after embolization with Fourier Transform Infrared Microspectroscopy (FTIRMS). Twelve sheep underwent uterine artery embolization with IBU-BB (485 mM) or control unloaded beads. IBU concentration was determined inside the beads and in the tissue surrounding the beads using FTIRMS of uterine tissue sections sampled 24 h or 1 week after embolization. After 24 h, IBU concentration inside the bead was only 18.6 mM out of the 485 mM initially loaded (p < 0.0001, univariate sign test). The concentration in the tissue around the beads was 8 mM, which is well above the in vitro therapeutic levels (6 microM). After one week the concentration of IBU had decreased to 4.9 mM in the beads (p = 0.0502, Mann Whitney) and no IBU was detected in the surrounding tissue. This work has demonstrated that IBU-BB can provide a sustained release of the anti-inflammatory drug over at least one week. The in vivo elution properties of IBU-BB may be suitable to alleviate pain and inflammation after embolization.

Pharmacodynamics and dermatopharmacokinetics of betamethasone 17-valerate: assessment of topical bioavailability

BACKGROUND

The bioavailability of most topically delivered drugs is difficult to quantify, but is generally believed to be very low. With the exception of the vasoconstrictor assay for corticosteroids, no methodology to quantify the rate and extent of drug delivery to the skin has been validated. Recent research has examined the dermatopharmacokinetic (DPK) technique, which is based on stratum corneum (SC) tape-stripping.

OBJECTIVE

To compare the in vivo bioavailability of different topical formulations of betamethasone 17-valerate (BMV) using the vasoconstrictor assay and the DPK method.

METHODS

BMV was formulated in different vehicles and the drug concentration was adjusted to either (i) equal thermodynamic activity, or (ii) a range of values up to that corresponding to 80% of maximum thermodynamic activity. Vasoconstriction, an accepted and widely used method to determine bioavailability and bioequivalence of topical steroids, was quantified with a chromameter over 24 h post-removal of the formulation. Drug uptake into the SC was assessed by tape-stripping.

RESULTS

BMV at the same thermodynamic activity in different vehicles provoked similar skin blanching responses, while DPK profiles distinguished between the formulations. Further, skin blanching responses and drug uptake into the SC clearly depended upon the absolute BMV concentration applied. However, while the saturable nature of the pharmacodynamic response was clear, the tape-stripping method distinguished unequivocally between the different formulations and different concentrations.

CONCLUSIONS

The DPK approach offers a reliable metric with which to quantify transfer of drug from the vehicle to the SC, and may be useful for topical bioavailability and bioequivalence determinations.

The determination of stratum corneum thickness: an alternative approach

The individual thickness of the stratum corneum is required to normalise drug permeation profiles in dermato-pharmacokinetic studies. The thickness is often estimated using tape-stripping combined with transepidermal water loss measurements. A linear transformation of Fick's first law is used to relate the progressively thinner barrier with the corresponding increase in transepidermal water loss and to estimate the thickness by linear regression. However, the data from an important subset of subjects are poorly fitted to this linear model. This is typically due to the removal of loose outer layers of stratum corneum, which do not contribute significantly to barrier function. This work proposes two alternative non-linear models. All three models were used to fit data from 31 in vivo tape-stripping experiments and their outcomes and goodness-of-fit compared. The results suggest that the linear model may overestimate the stratum corneum thickness and is open to subjectivity regarding the selection of data points to be fitted. The non-linear models satisfactorily fitted all the data, including all data points. No significant differences were found between the thicknesses derived from the two non-linear models. However, the analysis of the goodness-of-fit of the models to the data suggests a preference for a baseline-corrected approach.