Single-crystalline Sb-doped SnO2 nanowires: synthesis and gas sensor application

Gas sensors based on semiconducting metal oxide one-dimensional nanostructures

This article provides a comprehensive review of recent (2008 and 2009) progress in gas sensors based on semiconducting metal oxide one-dimensional (1D) nanostructures. During last few years, gas sensors based on semiconducting oxide 1D nanostructures have been widely investigated. Additionally, modified or doped oxide nanowires/nanobelts have also been synthesized and used for gas sensor applications. Moreover, novel device structures such as electronic noses and low power consumption self-heated gas sensors have been invented and their gas sensing performance has also been evaluated. Finally, we also point out some challenges for future investigation and practical application.

A simple and effective approach towards biomimetic replication of photonic structures from butterfly wings

A general sonochemical process is reported for the replication of photonic structures from Morpho butterfly wings in several hours. By selecting appropriate precursors, we can achieve exact replications of photonic structures in a variety of transparent metal oxides, such as titania, tin oxide and silica. The exact replications at the micro- and nanoscales were characterized by a combination of FE-SEM, TEM, EDX and Raman measurements. The optical properties of the replicas were investigated by using reflectance spectroscopy, and it was found that the interesting chromaticity of the reflected light could be adjusted simply by tuning the replica materials. An ultrasensitive SnO(2)-based chemical sensor was prepared from the SnO(2) replica. The sensor has a sensitivity of 35.3-50 ppm ethanol at 300 degrees C, accompanied by a rapid response and recovery (around 8-15 s), owing to its large surface area and photonic structure. Thus, this process could be developed to produce photonic structural ceramics which could be used in many passive and active infrared devices, especially high performance optical components and sensors.

The template-free synthesis of square-shaped SnO(2) nanowires: the temperature effect and acetone gas sensors

Square-shaped single-crystalline SnO(2) nanowires and their sphere-like hierarchical structures were synthesized successfully with a template-free hydrothermal approach. It was found that an intermediate phase-Na(2)Sn(OH)(6)-is first produced because it is slow to dissolve in ethanol/water media. The intermediate phase gradually decomposes and converts into SnO(2) at temperatures higher than 200 °C. The reaction temperature also affects the microstructure of SnO(2) nanomaterials. Uniform square-shaped SnO(2) nanowires, which form sphere-like hierarchical structures in 100% structure yield, can be produced at 285 °C on a large scale. The diameter of the nanowires shows a decrease accompanying the increase of the reaction temperature. The temperature effect could be a result of the faster and oriented growth of SnO(2) nanowires along their [Formula: see text] direction at higher temperature. Chemical sensors constructed with square-shaped SnO(2) nanowires exhibit excellent stability, good sensitivity and selectivity, as well as a quick response and short recovery times under exposure to acetone gas in practical applications.

Preparation of single-crystalline platinum nanowires with small diameters under mild conditions

We report a convenient method to synthesize single-crystalline platinum nanowires with high aspect ratio of ca. 2.0 nm diameter by sophisticated and precise control of Pt(0) nuclei and their growth.