Luminescent Fluorene-Based Bis-Pyrazolyl Aniline Ligand for Aluminum Detection

The design, synthesis, and photophysical properties of a new fluorene-based fluorescent chemosensor, 4-((E)-2-(2-(benzo[d]thiazol-2-yl)-9,9-diethyl-9H-fluoren-7-yl)vinyl)-N,N-bis((3,5-dimethyl-1H-pyrazol-1-yl)methyl)benzenamine (AXF-Al), is described for the detection of Al3+. AXF-Al exhibited absorption at 382 nm and strong fluorescence emission at 542 nm (fluorescence quantum yield, Φ F, of 0.80). The capture of Al3+ by the pyrazolyl aniline receptor resulted in nominal change in the linear absorption (372 nm) but a large hypsochromic shift of 161 nm in the fluorescence spectrum (542 to 433 nm, Φ F = 0.88), from which Al3+ was detected both ratiometrically and colorimetrically. The addition of other metal ions, namely Mg2+, Ca2+, Mn2+, Fe2+, Co2+, Ni2+, Cu2+, Zn2+, Cd2+, Hg 2+ and Pb2+, produced only minimal changes in the optical properties of this probe. The emission band of this probe was also accessed by two-photon excitation in the near-IR, as two-photon absorption (2PA) is important for potential applications in two-photon fluorescence microscopy (2PFM) imaging. The 2PA cross section of the free fluorenyl ligand AXF-Al was 220 GM at 810 nm and 235 GM at 810 nm for the Al-ligand complex, practically useful properties for 2PFM.

Synthesis and properties of Asante Calcium Red--a novel family of long excitation wavelength calcium indicators

Although many synthetic calcium indicators are available, a search for compounds with improved characteristics continues. Here, we describe the synthesis and properties of Asante Calcium Red-1 (ACR-1) and its low affinity derivative (ACR-1-LA) created by linking BAPTA to seminaphthofluorescein. The indicators combine a visible light (450-540 nm) excitation with deep-red fluorescence (640 nm). Upon Ca2+ binding, the indicators raise their fluorescence with longer excitation wavelengths producing higher responses. Although the changes occur without any spectral shifts, it is possible to ratio Ca(2+)-dependent (640 nm) and quasi-independent (530 nm) emission when using visible (< 490 nm) or multiphoton (∼780 nm) excitation. Therefore, both probes can be used as single wavelength or, less dynamic, ratiometric indicators. Long indicator emission might allow easy [Ca2+]i measurement in GFP expressing cells. The indicators bind Ca2+ with either high (Kd = 0.49 ± 0.07 μM; ACR-1) or low affinity (Kd = 6.65 ± 0.13 μM; ACR-1-LA). Chelating Zn2+ (Kd = 0.38 ± 0.02 nM) or Mg2+ (Kd∼5mM) slightly raises and binding Co2+ quenches dye fluorescence. New indicators are somewhat pH-sensitive (pKa = 6.31 ± 0.07), but fairly resistant to bleaching. The probes are rather dim, which combined with low AM ester loading efficiency, might complicate in situ imaging. Despite potential drawbacks, ACR-1 and ACR-1-LA are promising new calcium indicators.

Construction of a near-infrared fluorescence turn-on and ratiometric probe for imaging palladium in living cells

A new NIR fluorescent probe, NIR-Pd, for palladium species was designed and synthesized, based on a HD NIR fluorophore and deprotection of aryl propargyl ethers by palladium. The probe NIR-Pd displayed either a large NIR fluorescence turn-on or ratiometric response to palladium with high sensitivity and selectivity. Additionally, the novel NIR probe can monitor palladium species in live HeLa cells by NIR fluorescence imaging.

Preparation of a pH-Sensitive Polystyrene Fluorescent Microsphere based on a Cyanine Dye

A novel pH-sensitive near-IR (NIR) fluorescent dye was synthesised and utilised in the preparation of fluorescent polystyrene microspheres. Their photochemical properties, as well as the pH-dependent optical properties were investigated and showed high sensitivity to changes of pH in the range of 3.3–8.1. The fluorescence became stronger with the increase in pH. Importantly, the microspheres were able to work in aqueous media, which is highly valuable for use in biological applications.