Progress in supercapacitors: roles of two dimensional nanotubular materials

Magnetite ultrafine particles/porous reduced graphene oxide in situ grown onto Ni foam as a binder-free electrode for supercapacitors

Here, we report a simple and green electrochemical route to fabricate a porous network of a Fe₃O₄ nanoparticle-porous reduced graphene oxide (p-rGO) nanocomposite supported on a nickel-foam substrate, which is directly used as a binder-free charge storage electrode. Through this method, pristine Fe₃O₄ NPs/Ni, p-rGO/Ni and Fe₃O₄ NPs@p-rGO/Ni electrodes are fabricated and compared. In the fabricated Fe₃O₄ NPs@p-rGO/Ni electrode, the porous rGO sheets served as a conductive network to facilitate the collection and transportation of electrons during the charge/discharge cycles, improving the conductivity of magnetite NPs and providing a larger specific surface area. As a result, the Fe₃O₄ NPs@p-rGO/Ni exhibited a specific capacitance of 1323 F g⁻¹ at 0.5 A g⁻¹ and 79% capacitance retention when the current density is increased 20 times, where the Fe₃O₄ NPs/Ni electrode showed low specific capacitance of 357 F g⁻¹ and 43% capacity retention. Furthermore, the composite electrode kept 95.1% and 86.7% of its initial capacitances at the current densities of 1 and 4 A g⁻¹, respectively, which were higher than those of a Fe₃O₄/NF electrode at similar loads (i.e. 80.4% and 65.9% capacitance retentions at 1 and 4 A g⁻¹, respectively). These beneficial effects proved the synergistic contribution between p-rGO and Fe₃O₄. Hence, such ultrafine magnetite particles grown onto a porous reduced GO network directly imprinted onto a Ni substrate could be a promising candidate for high performance energy storage aims.

Here, we report a simple and green electrochemical route to deposition of Fe₃O₄ nanoparticle-porous reduced graphene oxide (p-rGO) nanocomposite onto nickel foam substrate, which is directly used as a binder-free charge storage electrode.

Engineering work function of graphene oxide from p to n type using a low power atmospheric pressure plasma jet

In this work, we demonstrate doping graphene oxide (GO) films using a low power atmospheric pressure plasma jet (APPJ) with subsequent tuning of the work function. The surface potential of the plasma functionalized GO films could be tuned by 120 ± 10 mV by varying plasma parameters. X-ray spectroscopy used to probe these changes in electronic structure of systematically functionalized GO films by plasma. Detailed investigation using X-ray photoelectron spectroscopy and near edge X-ray absorption fine structure spectroscopy revealed the reactive nitrogen species in the plasma induce finite changes in the surface chemistry of the GO films, introducing additional density of states near the top of the valence band edge. Nitrogen introduced by the atmospheric pressure plasma is predominantly in a graphitic configuration with a varying concentration of pyridinic nitrogen. Additionally, evidence of gradual de-epoxidation of these GO films with increasing plasma exposure was also observed. We attribute this variation in work function values to the configuration of nitrogen in the graphitic structure as revealed by X-ray spectroscopy. With pyridinic nitrogen the electronic states of GO became electron deficient, inducing a p-type doping whereas an increase in graphitic nitrogen increased the electron density of GO leading to an n-type doping effect. Nitrogen doping was also found to decrease the resistivity from 138 MΩ sq^-1 to 4 MΩ sq^-1. These findings are extremely useful in fabricating heterojunction devices like sensors and optoelectronic devices where band structure alignment is key to device performance when GO is used as a charge transport layer. This technique can be extended to other known 2D systems.

High performance flexible supercapacitors based on secondary doped PEDOT-PSS-graphene nanocomposite films for large area solid state devices

In this work, we propose the development of high performance and flexible supercapacitors using reduced graphene oxide (rGO) incorporated poly(3,4 ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT-PSS) nanocomposites by secondary doping. The structural and morphological features of the composite film were analyzed in detail using SEM, AFM, FTIR, XPS and TGA. Secondary doping of ethylene glycol (EG) assisted by rGO incorporation significantly enhances the room temperature conductivity of PEDOT-PSS films from 3 S cm-1 to nearly 1225 S cm-1 for a 10 wt% composite. The secondary doped PEDOT-PSS:EG/rGO composite film demonstrated improved electrochemical performances with specific capacitance of 174 (F g-1) and energy density of 810 (W h kg-1) which is nearly 4 times greater than pristine PEDOT-PSS due to synergetic interactions between rGO and PEDOT-PSS. The prepared composite films show long term stability with capacitance retention of over 90% after 5000 cycles of charging-discharging. The nanocomposite films used in the present investigation demonstrates percolative behavior with a percolation threshold at 10 wt% of rGO in PEDOT-PSS. The assembled supercapacitor device could be bent and rolled-up without a decrease in electrochemical performance indicating the potential to be used in practical applications. To demonstrate the practical applicability, a rolled-up supercapacitor device was constructed that demonstrates operation of a red LED for 40 seconds when fully charged. This study will provide new dimensions towards designing cost effective, flexible and all solid-state supercapacitors with improved electrochemical performance using electrodes based on secondary doped PEDOT-PSS/rGO organic thin films.

Challenges and prospects of polyatomic ions’ intercalation in the graphite layer for energy storage applications

This review focuses on unraveling the reaction mechanisms of the intercalation of polyatomic ions into GICs by in situ techniques, correlated with computational studies.

A unique core-shell structured ZnO/NiO heterojunction to improve the performance of supercapacitors produced using a chemical bath deposition approach

The integration of metal oxide composite nanostructures has attracted great attention in supercapacitor (SC) applications. Herein, we fabricated a series of metal oxide composite nanostructures, including ZnO nanowires, NiO nanosheets, ZnO/CuO nanowire arrays, ZnO/FeO nanocrystals, ZnO/NiO nanosheets and ZnO/PbO nanotubes, via a simple and cost-effective chemical bath deposition (CBD) method. The electrochemical properties of the produced SCs were examined by performing cyclic voltammetry (CV), galvanostatic charge-discharge (GCD) analysis, and electrochemical impedance spectroscopy (EIS). Of the different metal oxides and metal oxide composites tested, the unique surface morphology of the ZnO/NiO nanosheets most effectively increased the electron transfer rate and electrical conductivity, which resulted in improved energy storage properties. The binder-free ZnO/NiO electrode delivered a high specific capacitance/capacity of 1248 F g-1 (599 mA h g-1) at 8 mA cm-2 and long-term cycling stability over the course of 3000 cycles with a capacity retention of 79%. These results suggested a superiority in performance of the ZnO/NiO nanosheets relative to the nanowires, nanowire arrays, nanocrystals, and nanotubes. Thus, the present work has provided an opportunity to fabricate new metal oxide composite nanostructures with high-performance energy storage devices.