Antimicrobial peptide-lipid binding interactions and binding selectivity

Interaction of the cationic peptide bactenecin with mixed phospholipid monolayers at the air-water interface

The initial mechanism by which antimicrobial peptides target microbes occurs via electrostatic interactions; however, the mechanism is not well understood. We investigate the interaction of the antimicrobial peptide bactenecin with a 50:50 w:w% 1,2-dipalmitoyl-sn-glycero-3-phosphocholine (DPPC) and 1,2-dimyristoyl-sn-glycero-3-phospho-(1'-rac-glycerol) (DMPG) phospholipid mixture at the air-water interface with different NaCl concentrations (0.01, 0.05, 0.1, 0.5 M) in the subphase. A larger shift of DPPC:DMPG isotherms was obtained for 0.1 M salt concentration at lower and higher pressures, demonstrating the influence of the negative charge of DMPG molecules and the screening of the electrostatic interaction by the salt concentration. Raman spectroscopy of monolayers demonstrated the presence of cysteine-cysteine bridges in bactenecin loops. The peptide adsorption in DPPC:DMPG monolayers observed by AFM images suggests a self-assembled aggregation process, starting with filament-like networks. Domains similar to carpets were formed and pore structures were obtained after a critical peptide concentration, according to the carpet model.

Exploring the membrane mechanism of the bioactive peptaibol ampullosporin a using lipid monolayers and supported biomimetic membranes

Ampullosporin A is an antimicrobial, neuroleptic peptaibol, the behavior of which was investigated in different membrane mimetic environments made of egg yolk L-α-phosphatidylcholine. In monolayers, the peptaibol adopted a mixed α/3(10)-helical structure with an in-plane orientation. The binding step was followed by the peptide insertion into the lipid monolayer core. The relevance of the inner lipid leaflet nature was studied by comparing ampullosporin binding on a hybrid bilayer, in which this leaflet was a rigid alkane layer, and on supported fluid lipid bilayers. The membrane binding was examined by surface plasmon resonance spectroscopy and the effect on lipid dynamics was explored using fluorescence recovery after photobleaching. In the absence of voltage and at low concentration, ampullosporin A substantially adsorbed onto lipid surfaces and its interaction with biomimetic models was strongly modified depending on the inner leaflet structure. At high concentration, ampullosporin A addition led to the lipid bilayers disruption.

Vibrational spectroscopy of biomembranes

Vibrational spectroscopy, commonly associated with IR absorption and Raman scattering, has provided a powerful approach for investigating interactions between biomolecules that make up cellular membranes. Because the IR and Raman signals arise from the intrinsic properties of these molecules, vibrational spectroscopy probes the delicate interactions that regulate biomembranes with minimal perturbation. Numerous innovative measurements, including nonlinear optical processes and confined bilayer assemblies, have provided new insights into membrane behavior. In this review, we highlight the use of vibrational spectroscopy to study lipid-lipid interactions. We also examine recent work in which vibrational measurements have been used to investigate the incorporation of peptides and proteins into lipid bilayers, and we discuss the interactions of small molecules and drugs with membrane structures. Emerging techniques and measurements on intact cellular membranes provide a prospective on the future of vibrational spectroscopic studies of biomembranes.

Electrical detection of pathogenic bacteria via immobilized antimicrobial peptides

The development of a robust and portable biosensor for the detection of pathogenic bacteria could impact areas ranging from water-quality monitoring to testing of pharmaceutical products for bacterial contamination. Of particular interest are detectors that combine the natural specificity of biological recognition with sensitive, label-free sensors providing electronic readout. Evolution has tailored antimicrobial peptides to exhibit broad-spectrum activity against pathogenic bacteria, while retaining a high degree of robustness. Here, we report selective and sensitive detection of infectious agents via electronic detection based on antimicrobial peptide-functionalized microcapacitive electrode arrays. The semiselective antimicrobial peptide magainin I--which occurs naturally on the skin of African clawed frogs--was immobilized on gold microelectrodes via a C-terminal cysteine residue. Significantly, exposing the sensor to various concentrations of pathogenic Escherichia coli revealed detection limits of approximately 1 bacterium/μL, a clinically useful detection range. The peptide-microcapacitive hybrid device was further able to demonstrate both Gram-selective detection as well as interbacterial strain differentiation, while maintaining recognition capabilities toward pathogenic strains of E. coli and Salmonella. Finally, we report a simulated "water-sampling" chip, consisting of a microfluidic flow cell integrated onto the hybrid sensor, which demonstrates real-time on-chip monitoring of the interaction of E. coli cells with the antimicrobial peptides. The combination of robust, evolutionarily tailored peptides with electronic read-out monitoring electrodes may open exciting avenues in both fundamental studies of the interactions of bacteria with antimicrobial peptides, as well as the practical use of these devices as portable pathogen detectors.

Interfacial assembly of proteins and peptides: recent examples studied by neutron reflection

Through reviewing a number of recent neutron reflection studies of interfacial adsorption of peptides and proteins, this paper aims to demonstrate the significance of this technique in studying interfacial biomolecular processes by illustrating the typical structural details that can be derived. The review will start with the introduction of relevant theoretical background, followed by an outline of representative biomolecular systems that have recently been studied to indicate the technical strengths of neutron reflection.

Molecular interactions between magainin 2 and model membranes in situ

In this paper, we investigated the molecular interactions of magainin 2 with model cell membranes using sum frequency generation (SFG) vibrational spectroscopy and attenuated total reflectance-Fourier transform infrared spectroscopy (ATR-FTIR). Symmetric 1-palmitoyl-2-oleoyl-sn-glycero-3-[Phospho-rac-(1-glycerol)] (POPG) and 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC) bilayers, which model the bacterial and mammalian cell membranes, respectively, were used in the studies. It was observed by SFG that magainin 2 orients relatively parallel to the POPG lipid bilayer surface at low solution concentrations, around 200 nM. When increasing the magainin 2 concentration to 800 nM, both SFG and ATR-FTIR results indicate that magainin 2 molecules insert into the POPG bilayer and adopt a transmembrane orientation with an angle of about 20 degrees from the POPG bilayer normal. For the POPC bilayer, even at a much higher peptide concentration of 2.0 microM, no ATR-FTIR signal was detected. For this concentration on POPC, SFG studies indicated that magainin 2 molecules adopt an orientation nearly parallel to the bilayer surface, with an orientation angle of about 75 degrees from the surface normal. This shows that SFG has a much better detection limit than ATR-FTIR and can therefore be applied to study interfacial molecules with a much lower surface coverage. This magainin 2 orientation study and further investigation of the lipid bilayer SFG signals support the proposed toroidal pore model for the antimicrobial activity of magainin 2.

Membrane permeability and antimicrobial kinetics of cecropin P1 against Escherichia coli

The interaction of cecropin P1 (CP1) with Escherichiacoli was investigated to gain insight into the time-dependent antimicrobial action. Biophysical characterizations of CP1 with whole bacterial cells were performed using both fluorescent and colorimetric assays to investigate the role of membrane permeability and lipopolysaccharide (LPS) binding in lytic behavior. The kinetics of CP1 growth inhibition assays indicated a minimal inhibitory concentration (MIC) of 3 microM. Bactericidal kinetics at the MIC indicated rapid killing of E.coli (<30 min). Membrane permeability studies illustrated permeation as a time-dependent event. Maximum permeability at the MIC occurred within 30 min, which correlates to the bactericidal action. Further investigation showed that the immediate permeabilizing action of CP1 is concentration-dependent, which correlates to the concentration-dependent nature of the inhibition assays. At the MIC and above, the immediate permeability was significant enough that the cells could not recover and exhibit growth. Below the MIC, immediate permeability was evident, but the level was insufficient to inhibit growth. Dansyl polymyxin B displacement studies showed LPS binding is essentially the same at all concentrations investigated. However, it does appear that only the immediate interaction is important, because binding continued to increase over time beyond cell viability. Our studies correlated CP1 bactericidal kinetics to membrane permeability suggesting CP1 concentration-dependent killing is driven by the extent of the immediate permeabilizing action of the peptide.

Effect of lipid composition on the topography of membrane-associated hydrophobic helices: stabilization of transmembrane topography by anionic lipids

To investigate the effect of lipid structure upon the membrane topography of hydrophobic helices, the behavior of hydrophobic peptides was studied in model membrane vesicles. To define topography, fluorescence and fluorescence quenching methods were used to determine the location of a Trp at the center of the hydrophobic sequence. For peptides with cationic residues flanking the hydrophobic sequence, the stability of the transmembrane (TM) configuration (relative to a membrane-bound non-TM state) increased as a function of lipid composition on the order: 1:1 (mol:mol) 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC):1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine approximately 6:4 POPC:cholesterol<POPC approximately dioleoylphosphatidylcholine (DOPC)<1,2-dioleoyl-sn-glycero-3-[phospho-rac-(1-glycerol)] sodium salt (DOPG)</=1,2-dioleoyl-sn-glycero-3-[phospho-l-serine] sodium salt (DOPS), indicating that the anionic lipids DOPG and DOPS most strongly stabilized the TM configuration. TM stabilization was near maximal at 20-30 mol% anionic lipid, which are physiologically relevant values. TM stabilization by anionic lipid was observed for hydrophobic sequences with a diverse set of sequences (including polyAla), diverse lengths (from 12 to 22 residues), and various cationic flanking residues (H, R, or K), but not when the flanking residues were uncharged. TM stabilization by anionic lipid was also dependent on the number of cationic residues flanking the hydrophobic sequence, but was still significant with only one cationic residue flanking each end of the peptide. These observations are consistent with TM-stabilizing effects being electrostatic in origin. However, Trp located more deeply in DOPS vesicles relative to DOPG vesicles, and peptides in DOPS vesicles showed increased helix formation relative to DOPG and all other lipid compositions. These observations fit a model in which DOPS anchors flanking residues near the membrane surface more strongly than does DOPG and/or increases the stability of the TM state to a greater degree than DOPG. We conclude that anionic lipids can have significant and headgroup structure-specific effects upon membrane protein topography.

Effects of the cationic antimicrobial peptide eumenitin from the venom of solitary wasp Eumenes rubronotatus in planar lipid bilayers: surface charge and pore formation activity

Eumenitin, a novel cationic antimicrobial peptide from the venom of solitary wasp Eumenes rubronotatus, was characterized by its effects on black lipid membranes of negatively charged (azolectin) and zwitterionic (1,2-diphytanoyl-sn-glycero-3-phosphocholine (DPhPC) or DPhPC-cholesterol) phospholipids: surface potential changes, single-channel activity, ion selectivity, and pore size were studied. We found that eumenitin binds preferentially to charged lipid membranes as compared with zwitterionic ones. Eumenitin is able to form pores in azolectin (G1=118.00+/-3.67pS or G2=160.00+/-7.07pS) and DPhPC membranes (G=61.13+/-7.57pS). Moreover, cholesterol addition to zwitterionic DPhPC membranes inhibits pore formation activity but does not interfere with the binding of peptide. Open pores presented higher cation (K+) over anion (Cl-) selectivity. The pore diameter was estimated at between 8.5and 9.8 angstroms in azolectin membranes and about 4.3 angstroms in DPhPC membranes. The results are discussed based on the toroidal pore model for membrane pore-forming activity and ion selectivity.