Adult Spinal Deformity: A Comprehensive Review of Current Advances and Future Directions

Effects of bone cement augmentation for uppermost instrumented vertebra on adjacent disc segment degeneration in lumbar fusions

OBJECTIVE

We investigated the long-term effects of bone cement-augmented instrumentation in multilevel lumbar fusions in a retrospective cohort study. The use of cement-augmented screws is one of the techniques used to reduce early mechanical failure in treating multilevel lumbar fusion, especially in the elderly. However, little information is available regarding the long-term effects.

METHODS

A total of 51 patients who had undergone ≥3 levels of lumbar fusion were divided into two groups according to the use of bone cement-augmented screw fixation involving the upper instrumented vertebra: 22 patients in the cement-augmented group (group I) and 29 patients in the non-cement-augmented group (group II). Analysis of radiographic adjacent disc segment degeneration (ASD) revealed patients with lumbosacral fusion with a similar degree of osteoporosis. Radiologic ASD was defined as progression of >2 UCLA (University of California, Los Angeles) grades at 2 years postoperatively. Other sagittal parameters and the preoperative magnetic resonance imaging Pfirrmann grades at the adjacent levels, possibly related to ASD, were also analyzed.

RESULTS

No significant differences were present in the preoperative demographic and radiographic parameters between the 2 groups. However, the postoperative kyphotic changes at 3 months were greater for the non-cement-augmented group. In terms of the long-term effects, the incidence of radiologic ASD (group I, n = 20 [95.2%]; vs group II, n = 15 [53.6%]) was significantly higher in the cement-augmented group. Logistic regression analysis of radiologic ASD, including other clinical and radiologic parameters, postoperative pelvic incidence-lumbar lordosis mismatch (odds ratio, 5.201; 95% confidence interval, 1.123-24.090; P = 0.035), and cement augmentation (odds ratio, 20.193; 95% confidence interval, 2.195-185.729; P = 0.008) showed a significant correlation with the development of radiologic ASD at 2 years postoperatively.

CONCLUSIONS

Although bone cement-augmented screw implantation can prevent kyphotic deformation at the proximal junction of upper instrumented vertebra in the early postoperative stages of multilevel lumbar fusion, a careful selection of patients is required because of possibly accelerated degeneration of adjacent segments.

Fusion rates based on type of bone graft substitute using minimally invasive scoliosis surgery for adolescent idiopathic scoliosis

BACKGROUND

Minimally invasive scoliosis surgery (MISS) is currently introduced on novel technique for surgical treatment of adolescent idiopathic scoliosis (AIS). This study is aimed to evaluate the efficacy of facet fusion in MISS compared to posterior fusion in conventional open scoliosis surgery (COSS) and compare facet fusion rates based on three bone graft substitutes in MISS for adolescent idiopathic scoliosis (AIS).

METHODS

Eighty six AIS patients who underwent scoliosis surgery were divided into two groups: the COSS group and the MISS group. COSS was performed through posterior fusion with allograft. MISS was applied via facet fusion with three bone graft substitutes. The MISS group was further divided into three subgroups based on graft substitute: Group A (allograft), Group B (demineralized bone matrix [DBM]), and group C (demineralized cancellous bone chips). Fusion rate was measured using conventional radiographs to visualize loss of correction > 10°, presence of lysis around implants, breaks in fusion mass, and abnormal mobility of the fused segment.

RESULTS

The fusion rates showed no significant difference in COSS and MISS groups (p = 0.070). In the MISS group, the fusion rates were 85, 100, and 100% in groups A, B, and C, respectively, with no significant difference (p = 0.221). There were no statistical differences between groups A, B, and C in terms of correction rate, fusion rate, and SRS-22 scores (p > 0.05).

CONCLUSIONS

The facet fusion in MISS showed comparable to posterior fusion in COSS with regard to radiological and clinical outcomes. Furthermore, the type of graft substitute among allograft, DBM, and demineralized cancellous bone chips did not affect facet fusion rate or clinical outcomes in MISS. Therefore, MISS showed comparable fusion rate (with no influences on the type of graft substitute) and clinical outcomes to those of COSS in the surgical treatment of AIS.

Biomechanical Comparison of Multilevel Lumbar Instrumented Fusions in Adult Spinal Deformity According to the Upper and Lower Fusion Levels: A Finite Element Analysis

Multilevel lumbar fusion with posterior pedicle screw fixation is a widely performed surgical procedure for the management of adult spinal deformity. However, there has not been a comprehensive biomechanical study on the different types of fusion levels in terms of stability and possible complications. We aimed to investigate the biomechanical properties of multilevel lumbar fusion according to different types of upper and lower fusion levels. Six different types of fusions were performed using three-dimensional finite element models. Type A and B referred to the group of which upper fusion level was L1 and T10, respectively. Subtype 1, 2, and 3 referred to the group of which lower fusion level was L5, S1, and ilium, respectively (A1, L1-L5; A2, L1-S1; A3, L1-ilium; B1, T10-L5; B2, T10-S1; B3, T10-ilium). Flexion, extension, axial rotation, and lateral bending moments were applied, and the risk of screw loosening and failure and adjacent segment degeneration (ASD) was analyzed. Stress at the bone-screw interface of type B3 was lowest in overall motions. The risk of screw failure showed increasing pattern as the upper and lower levels extended in all motions. Proximal range of motion (ROM) increased as the lower fusion level changed from L5 to S1 and the ilium. For axial rotation, type B3 showed higher proximal ROM (16.2°) than type A3 (11.8°). In multilevel lumbar fusion surgery for adult spinal deformity, adding iliac screws and increasing the fusion level to T10-ilium may lower the risk of screw loosening. In terms of screw failure and proximal ASD, however, T10-ilium fusion has a higher potential risk compared with other fusion types. These results will contribute for surgeons to provide adequate patient education regarding screw failure and proximal ASD, when performing multilevel lumbar fusion.