Bilirubin oxidases in bioelectrochemistry: Features and recent findings

Recoverable hybrid enzymatic biofuel cell with molecular oxygen-independence

Enzymatic biofuel cells (EBFCs) have drawn great attentions because of its potential in energy conversion. However, designing of highly efficient EBFCs which can adapt to the anaerobic system is still a great challenge. In this study, we propose a novel hybrid enzymatic biofuel cell (HEBFC) which was fabricated by a glucose dehydrogenase modified bioanode and a solid-state silver oxide/silver (Ag2O/Ag) cathode. The as-assembled HEBFC exhibited an open circuit potential of 0.59V and a maximum power output of 0.281mWcm(-2) at 0.34V in air saturated buffer. Especially, due to the introduction of Ag2O/Ag, our HEBFC could also operate under anaerobic condition, while the maximum power output would reach to 0.275mWcm(-2) at 0.34V. Furthermore, our HEBFC had stable cycle operation and could keep high power output for a certain time as the result of the regeneration of Ag2O. Our work provides a new concept to develop EBFCs for efficient energy conversion in the future.

Stretchable biofuel cell with enzyme-modified conductive textiles

A sheet-type, stretchable biofuel cell was developed by laminating three components: a bioanode textile for fructose oxidation, a hydrogel sheet containing fructose as fuel, and a gas-diffusion biocathode textile for oxygen reduction. The anode and cathode textiles were prepared by modifying carbon nanotube (CNT)-decorated stretchable textiles with fructose dehydrogenase (FDH) and bilirubin oxidase (BOD), respectively. Enzymatic reaction currents of anode and cathode textiles were stable for 30 cycles of 50% stretching, with initial loss of 20-30% in the first few cycles due to the partial breaking of the CNT network at the junction of textile fibers. The assembled laminate biofuel cell showed power of ~0.2 mW/cm(2) with 1.2 kΩ load, which was stable even at stretched, twisted, and wrapped forms.

Bilirubin Oxidase from Myrothecium verrucaria Physically Absorbed on Graphite Electrodes. Insights into the Alternative Resting Form and the Sources of Activity Loss

The oxygen reduction reaction is one of the most important chemical processes in energy converting systems and living organisms. Mediator-less, direct electro-catalytic reduction of oxygen to water was achieved on spectrographite electrodes modified by physical adsorption of bilirubin oxidases from Myrothecium verrucaria. The existence of an alternative resting form of the enzyme is validated. The effect on the catalytic cycle of temperature, pH and the presence of halogens in the buffer was investigated. Previous results on the electrochemistry of bilirubin oxidase and on the impact of the presence of halogens are reviewed and reinterpreted.

Employing FAD-dependent glucose dehydrogenase within a glucose/oxygen enzymatic fuel cell operating in human serum

Flavin adenine dinucleotide-dependent glucose dehydrogenase (FAD-GDH) is emerging as an oxygen-insensitive alternative to glucose oxidase (GOx) as the biocatalyst for bioelectrodes and bioanodes in glucose sensing and glucose enzymatic fuel cells (EFCs). Glucose EFCs, which utilize oxygen as the oxidant and final electron acceptor, have the added benefit of being able to be implanted within living hosts. These can then produce electrical energy from physiological glucose concentrations and power internal or external devices. EFCs were prepared with FAD-GDH and bilirubin oxidase (BOx) to evaluate the suitability of FAD-GDH within an implantable setting. Maximum current and power densities of 186.6±7.1 μA cm(-2) and 39.5±1.3 μW cm(-2) were observed when operating in human serum at 21 °C, which increased to 285.7±31.3 μA cm(-2) and 57.5±5.4 μW cm(-2) at 37 °C. Although good stability was observed with continual near-optimal operation of the EFCs in human serum at 21 °C for 24 h, device failure was observed between 13-14 h when continually operated at 37 °C.

Organic transdermal iontophoresis patch with built-in biofuel cell

A completely organic iontophoresis patch is reported. A built-in biofuel cell is mounted on the patch that generates transdermal iontophoretic administration of compounds into the skin. The amplitude of transdermal current is tuned by integrating a conducting polymer-based stretchable resistor of predetermined resistance.

A membraneless air-breathing hydrogen biofuel cell based on direct wiring of thermostable enzymes on carbon nanotube electrodes

A membraneless air-breathing hydrogen biofuel cell.

Surfactant-assisted direct electron transfer between multi-copper oxidases and carbon nanotube-based porous electrodes

The pre-treatment of carbon nanotube-based nanostructured porous electrodes with surfactant enhanced the efficiency of direct electron transfer of multi-copper oxidases.