A new mechanism of model membrane fusion determined from Monte Carlo simulation

Biological implications of cell fusion

Until recently, cells were thought to be integral and discrete components of tissues, and their state was determined by cell differentiation. However, under some conditions, stem cells or their progeny can fuse with cells of other types, mixing cytoplasmic and even genetic material of different (heterotypic) origins. The fusion of heterotypic cells could be of central importance for development, repair of tissues and the pathogenesis of disease.

The energetics of membrane fusion from binding, through hemifusion, pore formation, and pore enlargement

The main steps of viral membrane fusion are local membrane approach, hemifusion, pore formation, and pore enlargement. Experiments and theoretical analyses have helped determine the relative energies required for each step. Key protein structures and conformational changes of the fusion process have been identified. The physical deformations of monolayer bending and lipid tilt have been applied to the steps of membrane fusion. Experiment and theory converge to strongly indicate that, contrary to former conceptions, the fusion process is progressively more energetically difficult: hemifusion has a relatively low energy barrier, pore formation is more energy-consuming, and pore enlargement is the most difficult to achieve.

Stabilization of model membranes during drying by compatible solutes involved in the stress tolerance of plants and microorganisms

Many organisms accumulate compatible solutes under environmental stress conditions. Cyanobacteria accumulate compatible solutes in response to increased external salinity, with tolerance increasing from Suc (sucrose) or trehalose to 2-O-(alpha-D-glucopyranosyl)-glycerol and glycinebetaine accumulating species. It is not clear how these different solutes influence salt tolerance. One possible explanation may be a differential ability of these solutes to stabilize membranes under stress conditions. We therefore performed drying experiments with liposomes in the presence of compatible solutes. Suc, trehalose and sorbitol protected liposomes from leakage of a soluble marker and from membrane fusion during drying and rehydration. 2-O-(alpha-D-glucopyranosyl)-glycerol was less effective and glycinebetaine showed hardly any effect. In combination with Suc, the latter two solutes showed improved protection. Lipid-phase transitions are known to contribute to solute leakage from liposomes. We determined phase transitions in dry membranes in the absence or presence of the solutes, using Fourier-transform infrared spectroscopy. The ability of the solutes to decrease the phase transition temperature corresponded closely to their ability to protect the liposomes against solute leakage. All solutes interacted with the phosphate in the lipid headgroups. The magnitude of the shift in the asymmetric P=O stretching vibration correlated closely with the lipid-phase transition temperature. This indicates that the degree of membrane protection afforded by the solutes is mainly determined by their ability to interact with the membrane lipids. However, this is not a determinant of cellular protection against salt stress, as the solutes show a reverse order when ranked with regard to protection against these stresses.

Tension-induced fusion of bilayer membranes and vesicles

Maintaining the integrity of their protective plasma membrane is a primary requirement of cells. Accordingly, cellular events that breach the membrane are tightly regulated. Artificial vesicles used in drug delivery must also stay intact until they have reached the desired target. In both cases, the intrinsic resistance of the membrane to rupture must be overcome to allow the efflux of the vesicle's contents. Here, we use mesoscopic simulations to study the fusion of 28-nm-diameter vesicles to 50 x 50 nm(2) planar membrane patches over 2 mus. We monitor the time evolution of 93 different fusion attempts. This allows us to construct a global morphology diagram, using the initial tensions of the vesicle and the planar membrane patch as control parameters, and to determine the corresponding fusion statistics. All successful fusion events are observed to occur within 350 ns, which reflects the presence of alternative pathways for the tension relaxation.

Prm1 prevents contact-dependent lysis of yeast mating pairs

Membrane fusion requires localized destabilization of two phospholipid bilayers, but unrestrained membrane destabilization could result in lysis. prm1 mutant yeast cells have a defect at the plasma membrane fusion stage of mating that typically results in the accumulation of prezygotes that have fingers of membrane-bound cytoplasm projecting from one cell of each pair into its mating partner in the direction of the osmotic gradient between the cells. However, some prm1 mating pairs fuse successfully whereas the two cells in other prm1 mating pairs simultaneously lyse. Lysis only occurs if both mating partners are prm1 mutants. Osmotic stabilization does not protect prm1 mating pairs from lysis, indicating that lysis is not caused by a cell wall defect. prm1 mating pairs without functional mitochondria still lyse, ruling out programmed cell death. No excess lysis was found after pheromone treatment of haploid prm1 cells, and lysis did not occur in mating pairs when prm1 was combined with the fus1 and fus2 mutations to block cell wall remodeling. Furthermore, short (<1 microm) cytoplasmic microfingers indicating the completion of cell wall remodeling appeared immediately before lysis. In combination, these results demonstrate that plasma membrane contact is a prerequisite for lysis. Cytoplasmic microfingers are unlikely to cause lysis since most prm1 mating pairs with microfingers do not lyse, and microfingers were also detected before fusion in some wild-type mating pairs. The lysis of prm1 mutant mating pairs suggests that the Prm1 protein stabilizes the membrane fusion event of yeast mating.

Field theoretic study of bilayer membrane fusion. I. Hemifusion mechanism

Self-consistent field theory is used to determine structural and energetic properties of metastable intermediates and unstable transition states involved in the standard stalk mechanism of bilayer membrane fusion. A microscopic model of flexible amphiphilic chains dissolved in hydrophilic solvent is employed to describe these self-assembled structures. We find that the barrier to formation of the initial stalk is much smaller than previously estimated by phenomenological theories. Therefore its creation it is not the rate-limiting process. The relevant barrier is associated with the rather limited radial expansion of the stalk into a hemifusion diaphragm. It is strongly affected by the architecture of the amphiphile, decreasing as the effective spontaneous curvature of the amphiphile is made more negative. It is also reduced when the tension is increased. At high tension the fusion pore, created when a hole forms in the hemifusion diaphragm, expands without bound. At very low membrane tension, small fusion pores can be trapped in a flickering metastable state. Successful fusion is severely limited by the architecture of the lipids. If the effective spontaneous curvature is not sufficiently negative, fusion does not occur because metastable stalks, whose existence is a seemingly necessary prerequisite, do not form at all. However if the spontaneous curvature is too negative, stalks are so stable that fusion does not occur because the system is unstable either to a phase of stable radial stalks, or to an inverted-hexagonal phase induced by stable linear stalks. Our results on the architecture and tension needed for successful fusion are summarized in a phase diagram.

Trans-SNARE interactions elicit Ca2+ efflux from the yeast vacuole lumen

Ca²⁺ transients trigger many SNARE-dependent membrane fusion events. The homotypic fusion of yeast vacuoles occurs after a release of lumenal Ca²⁺. Here, we show that trans-SNARE interactions promote the release of Ca²⁺ from the vacuole lumen. Ypt7p–GTP, the Sec1p/Munc18-protein Vps33p, and Rho GTPases, all of which function during docking, are required for Ca²⁺ release. Inhibitors of SNARE function prevent Ca²⁺ release. Recombinant Vam7p, a soluble Q-SNARE, stimulates Ca²⁺ release. Vacuoles lacking either of two complementary SNAREs, Vam3p or Nyv1p, fail to release Ca²⁺ upon tethering. Mixing these two vacuole populations together allows Vam3p and Nyv1p to interact in trans and rescues Ca²⁺ release. Sec17/18p promote sustained Ca²⁺ release by recycling SNAREs (and perhaps other limiting factors), but are not required at the release step itself. We conclude that trans-SNARE assembly events during docking promote Ca²⁺ release from the vacuole lumen.

Multiple stalk formation as a pathway of defect-induced membrane fusion

We propose that the first stage of membrane fusion need not be the formation of a single stalk. Instead, we consider a scenario for defect-induced membrane fusion that proceeds cooperatively via multiple stalk formation. The defects (stalks or pores) attract each other via membrane-mediated capillary interactions that result in a condensation transition of the defects. The resulting dense phase of stalks corresponds to the so-called fusion intermediate.

Membrane fusion: a structural perspective on the interplay of lipids and proteins

The fusion of biological membranes is governed by the carefully orchestrated interplay of membrane proteins and lipids. Recently determined structures of fusion proteins, individual domains of fusion proteins and their complexes with regulatory proteins and membrane lipids have yielded much suggestive insight into how viral and intracellular membrane fusion might proceed. These structures may be combined with new knowledge on the fusion of pure lipid bilayer membranes in an attempt to begin to piece together the complex puzzle of how biological membrane fusion machines operate on membranes.