Control by pulse parameters of electric field-mediated gene transfer in mammalian cells

Poloxamer 188 decreases susceptibility of artificial lipid membranes to electroporation

The effect of a nontoxic, nonionic block co-polymeric surface active agent, poloxamer 188, on electroporation of artificial lipid membranes made of azolectin, was investigated. Two different experimental protocols were used in our study: charge pulse and voltage clamp. For the charge pulse protocol, membranes were pulsed with a 10-micronsecond rectangular voltage waveform, after which membrane voltage decay was observed through an external 1-M omega resistance. For the voltage clamp protocol the membranes were pulsed with a waveform that consisted of an initial 10-microsecond rectangular phase, followed by a negative sloped ramp that decayed to zero in the subsequent 500 microseconds. Several parameters characterizing the electroporation process were measured and compared for the control membranes and membranes treated with 1.0 mM poloxamer 188. For both the charge pulse and voltage clamp experiments, the threshold voltage (amplitude of initial rectangular phase) and latency time (time elapsed between the end of rectangular phase and the onset of membrane electroporation) were measured. Membrane conductance (measured 200 microseconds after the initial rectangular phase) and rise time (tr; the time required for the porated membrane to reach a certain conductance value) were also determined for the voltage clamp experiments, and postelectroporation time constant (PE tau; the time constant for transmembrane voltage decay after onset of electroporation) for the charge pulse experiments. The charge pulse experiments were performed on 23 membranes with 10 control and 13 poloxamer-treated membranes, and voltage pulse experiments on 49 membranes with 26 control and 23 poloxamer-treated membranes. For both charge pulse and voltage clamp experiments, poloxamer 188-treated membranes exhibited a statistically higher threshold voltage (p = 0.1 and p = 0.06, respectively), and longer latency time (p = 0.04 and p = 0.05, respectively). Also, poloxamer 188-treated membranes were found to have a relatively lower conductance (p = 0.001), longer time required for the porated membrane to reach a certain conductance value (p = 0.05), and longer postelectroporation time constant (p = 0.005). Furthermore, addition of poloxamer 188 was found to reduce the membrane capacitance by approximately 4-8% in 5 min. These findings suggest that poloxamer 188 adsorbs into the lipid bilayers, thereby decreasing their susceptibility to electroporation.

In vivo gene electroinjection and expression in rat liver

In vivo targeted gene transfer by non-viral vectors is subjected to anatomical constraints depending on the route of administration. Transfection efficiency and gene expression in vivo using non-viral vectors is also relatively low. We report that in vivo electropermeabilization of the liver tissue of rats in the presence of genes encoding luciferase or beta-galactosidase resulted in the strong expression of these genetic markers in rat liver cells. About 30-40% of the rat liver cells electroporated expressed the beta-galactosidase genetic marker 48 h after electroporation. The marker expression was also detected at least 21 days after transfection at about 5% of the level 48 h after electroporation. The results indicate that gene transfer by electroporation in vivo may avoid anatomical constraints and low transfection efficiency.

Effects of electroporation on the tubulin cytoskeleton and directed migration of corneal fibroblasts cultured within collagen matrices

Electroporation provides a useful method for loading fibroblasts with fluorescent probes for the cytoskeleton, but the possible deleterious effects of this loading technique on cell motility are unknown. We have used conventional and confocal microscopy of living cells and immunohistochemistry to examine the migration and cytoskeleton of chick embryo corneal fibroblasts electroporated while cultured within collagen gels. Fibroblasts cultured in collagen (1 mg/ml) are successfully electroloaded (0.5-1.0 kVcm-1/960 microF in DMEM/F12/20 mM Hepes, pH 7.2) with dextran (4-150 kDa) and immunoglobulin, but subsequently display uncoordinated pseudopodia and hence are unable to migrate effectively in any one direction. The lack of directed movement is due to depolymerization of microtubules and/or a perinuclear collapse of vimentin filaments, seemingly caused by millimolar levels of Ca2+ ions derived from culture medium following electroporation. Fibroblasts loaded in a buffer which resembles intracellular fluid (< or = 10 microM Ca2+) maintain their cytoskeleton and continue to migrate, when returned to culture medium within 10 min. Using this novel approach, we have loaded fibroblasts migrating through extracellular matrix (ECM) with rhodamine phalloidin and monitored the behavior of the labeled actin cortex by confocal microscopy. During migration phalloidin-actin accumulates near the base of pseudopodia and at the rear of the cell where it is subsequently left behind. We conclude that electroporation is a valuable technique for loading fibroblasts to study migration within ECM, provided that the conditions used support stability of the tubulin cytoskeleton.

Control by electrical parameters of short- and long-term cell death resulting from electropermeabilization of Chinese hamster ovary cells

Chinese hamster ovary (CHO) cells were pulsed by using brief intense square-wave electric field pulses. The electrical treatment induced a transient local permeabilization of the cell membrane. The growth of CHO cells after electropulsation in an iso-osmotic pulsing buffer with low ionic content was measured. Parallel experiments evaluated cell death which took place in the minute range after electropulsation (short-term death) and the cell death upon 24 h (long-term death). Short-term cell death was defined as the case of cells with membrane still permeable to Direct-blue at 15 min after electropulsation. It was observed only under stringent pulsing conditions where electropermeabilization of the two sides of the cell was triggered. The long-term cell death, i.e., the inability of some pulsed cells to grow was observed as soon as permeabilization had been triggered. The higher the permeabilization level of the cell population was, the higher the long-term cell death level was. The cell death was linearly related to the reciprocal of the electric field intensity, i.e., to the fraction of the membrane area electrically brought to the permeable state. From this work, it appeared that for high levels of permeabilization of a cell suspension, best cell survivals were obtained if limited alterations were triggered over a large area of the plasma membrane (single pulse with high intensity) than if a small area of the membrane was strongly altered (repetitive pulses with small intensity). The highest yield of viable permeabilized cells was achieved when using one single pulse of duration up to 1 ms.

Separation of human breast cancer cells from blood by differential dielectric affinity

Electrorotation measurements were used to demonstrate that the dielectric properties of the metastatic human breast cancer cell line MDA231 were significantly different from those of erythrocytes and T lymphocytes. These dielectric differences were exploited to separate the cancer cells from normal blood cells by appropriately balancing the hydrodynamic and dielectrophoretic forces acting on the cells within a dielectric affinity column containing a microelectrode array. The operational criteria for successful particle separation in such a column are analyzed and our findings indicate that the dielectric affinity technique may prove useful in a wide variety of cell separation and characterization applications.