Electrochemical detection of dopamine in the presence of ascorbic acid using graphene modified electrodes

A three-dimensional interpenetrating electrode of reduced graphene oxide for selective detection of dopamine

A three-dimensional (3D) interpenetrating electrode of reduced graphene oxide with high electrocatalytic activity was fabricated by one-step electrodeposition for selective detection of dopamine.

3D graphene oxide-encapsulated gold nanoparticles to detect neural stem cell differentiation

Monitoring of stem cell differentiation and pluripotency is an important step for the practical use of stem cells in the field of regenerative medicine. Hence, a new non-destructive detection tool capable of in situ monitoring of stem cell differentiation is highly needed. In this study, we report a 3D graphene oxide-encapsulated gold nanoparticle that is very effective for the detection of the differentiation potential of neural stem cells (NSCs) based on surface-enhanced Raman spectroscopy (SERS). A new material, 3D GO-encapsulated gold nanoparticle, is developed to induce the double enhancement effect of graphene oxide and gold nanoparticle on SERS signals which is only effective for undifferentiated NSCs. The Raman peaks achieved from undifferentiated NSCs on the graphene oxide (GO)-encapsulated gold nanoparticles were 3.5 times higher than peaks obtained from normal metal structures and were clearly distinguishable from those of differentiated cells. The number of CC bonds and the Raman intensity at 1656 cm(-1) was found to show a positive correlation, which matches the differentiation state of the NSCs. Moreover, the substrate composed of 3D GO-encapsulated gold nanoparticles was also effective at distinguishing the differentiation state of single NSC by using electrochemical and electrical techniques. Hence, the proposed technique can be used as a powerful non-destructive in situ monitoring tool for the identification of the differentiation potential of various kinds of stem cells (mesenchymal, hematopoietic, and neural stem cells).

Carbon dots and chitosan composite film based biosensor for the sensitive and selective determination of dopamine

A simple, sensitive and reliable dopamine (DA) biosensor was developed based on a carbon dots (CDs) and chitosan (CS) composite film modified glassy carbon electrode (CDs-CS/GCE). Under optimal conditions, the CDs-CS/GCE showed a better electrochemical response for the detection of DA than that of the glassy carbon electrode (GCE). The oxidation peak current (Ipa) of DA was linear with the concentration of DA in the range from 0.1 μM to 30.0 μM with the limit of detection as 11.2 nM (3S/N). The CDs-CS/GCE was applied to the detection of DA content in an injection solution of DA with satisfactory results.

Graphene-based electrochemical sensors

Graphene, one kind of emerging carbon nanomaterial, has attracted increasing attention recently. Due to its fascinating physical and electrochemical properties, graphene as a promising electrode material has been widely used in electrochemical sensing applications. In this review, different approaches for the fabrication of graphene and the preparation of graphene-modified electrodes for electrochemical sensors are introduced. Moreover, recent research results on different graphene-based materials as an electrochemical platform for the detection of various biomolecules and chemicals are reviewed and compared. More electrochemical studies on this novel material should show up in the near future.

New trends in the electrochemical sensing of dopamine

Since the early 70s electrochemistry has been used as a powerful analytical technique for monitoring electroactive species in living organisms. In particular, after extremely rapid evolution of new micro and nanotechnology it has been established as an invaluable technique ranging from experiments in vivo to measurement of exocytosis during communication between cells under in vitro conditions. This review highlights recent advances in the development of electrochemical sensors for selective sensing of one of the most important neurotransmitters--dopamine. Dopamine is an electroactive catecholamine neurotransmitter, abundant in the mammalian central nervous system, affecting both cognitive and behavioral functions of living organisms. We have not attempted to cover a large time-span nor to be comprehensive in presenting the vast literature devoted to electrochemical dopamine sensing. Instead, we have focused on the last five years, describing recent progress as well as showing some problems and directions for future development.

Graphene-based electrodes

Graphene, the thinnest two dimensional carbon material, has become the subject of intensive investigation in various research fields because of its remarkable electronic, mechanical, optical and thermal properties. Graphene-based electrodes, fabricated from mechanically cleaved graphene, chemical vapor deposition (CVD) grown graphene, or massively produced graphene derivatives from bulk graphite, have been applied in a broad range of applications, such as in light emitting diodes, touch screens, field-effect transistors, solar cells, supercapacitors, batteries, and sensors. In this Review, after a short introduction to the properties and synthetic methods of graphene and its derivatives, we will discuss the importance of graphene-based electrodes, their fabrication techniques, and application areas.

A dual fluorometric and colorimetric sensor for dopamine based on BSA-stabilized Au nanoclusters

An easy prepared fluorometric and colorimetric dual channel probe is developed for dopamine (DA) detection with high sensitivity and selectivity by use of BSA-stabilized Au nanoclusters (BSA-AuNCs). The BSA-AuNCs exhibit strong fluorescence emission, while upon addition of DA, the AuNCs show a dramatic decrease of the fluorescence intensity as a result of the photo-induced electron transfer process from the electrostatically attached DA to the BSA-AuNCs. The detection limit of DA can be as low as 10 nM. In addition, the assay for DA can also be easy to implement for visual detection due to the observed inhibition of the peroxidase-like activity of AuNCs in the presence of DA, with a detection limit of 10 nM. Both fluorometric and colorimetric methods exhibit excellent selectivity toward DA over interfering substances. Furthermore, we demonstrate the application of the present approach in hydrochloride injection sample, human serum sample and PC12 cells, which suggests its great potential for diagnostic purposes.

Emotion-on-a-chip (EOC): evolution of biochip technology to measure human emotion using body fluids

Recent developments in nano/micro technology have made it possible to construct small-scale sensing chips for the analysis of biological markers such as nucleic acids, proteins, small molecules, and cells. Although biochip technology for the diagnosis of severe physiological diseases (e.g., cancer, diabetes, and cardiovascular disease) has been extensively studied, biochips for the monitoring of human emotions such as stress, fear, depression, and sorrow have not yet been introduced, and the development of such a biochip is in its infancy. Emotion science (or affective engineering) is a rapidly expanding engineering/scientific discipline that has a major impact on human society. The growing interest in the integration of emotion science and engineering is a result of the recent trend of merging various academic fields. In this paper we discuss the potential importance of biochip technology in which human emotion can be precisely measured in real time using body fluids such as blood, saliva, urine, or sweat. We call these biochips emotion-on-a-chip (EOC). The EOC system consists of four parts: (1) collection of body fluids, (2) separation of emotional markers, (3) detection of optical or electrical signals, and (4) display of results. These techniques provide new opportunities to precisely investigate human emotion. Future developments in EOC techniques will combine social and natural sciences to expand their scope of study.

Peroxidase immobilized on phospholipid bilayers supported on Au (111) by DTT self-assembled monolayers: application to dopamine determination

In this work, horseradish peroxidase (HRP) was immobilized on dimyristoylphosphatidylcholine (DMPC) bilayers supported on Au (111) by dithiotreitol (DTT) self-assembled monolayers and used as a nanostructured electrochemical biosensor to dopamine determination. The morphology of the phospholipid bilayers and the immobilization of HRP to these layers were characterized by atomic force microscopy (AFM). Square-wave voltammetry (SWV) experiments were done to investigate the performance of the HRP-modified electrode. The AFM images indicate that the enzyme is adsorbed at the external layer of the lipid bilayer and, although the electrical charges on the surface were not measured, the enzyme and phospholipids surface interaction occurs probably by electrostatic forces due to the pH used in the experiments. Interestingly, the present system can be used as one-shot sensor for the rapid detection of dopamine. The analytical performance of this system was linear for dopamine concentrations from 3.3 × 10⁻⁵ to 1.3 × 10⁻³  mol L⁻¹ (r = 0.9997) with a detection limit of 2.0 × 10⁻⁶  mol L⁻¹. Our results indicate that the use of HRP-DMPC bilayer system may be useful not only in developing new nanostructured materials for technological purposes, but could be very useful in fundamental studies to investigate the interactions between different micro-and macromolecules, even with soluble proteins, and lipid membranes.