Toxicology of n-pentane (CAS no. 109-66-0)

Review and priority setting for substances that are listed without a specific migration limit in Table 1 of Annex 1 of Regulation 10/2011 on plastic materials and articles intended to come into contact with food

The EFSA Panel on Food Contact Materials, Enzymes and Processing Aids (CEP) was requested by the European Commission to review the substances for which a Specific Migration Limit (SML) is not assigned in Regulation (EU) No 10/2011. These substances had been covered by the Generic SML of 60 mg/kg food, but with Regulation (EU) 2016/1416 it was removed, necessitating their re-examination. EFSA was requested to identify those substances requiring an SML to ensure the authorisation is sufficiently protective to health, grouping them in high, medium and low priority to serve as the basis for future re-evaluations of individual substances. The CEP Panel established a stepwise procedure. This took into account existing hazard assessments for each substance on carcinogenicity/mutagenicity/reprotoxicity (CMR), bioaccumulation and endocrine disruptor (ED) properties along with the use of in silico generated predictions on genotoxicity. Molecular weights and boiling points were considered with regard to their effect on potential consumer exposure. This prioritisation procedure was applied to a total of 451 substances, from which 78 substances were eliminated at the outset, as they had previously been evaluated by EFSA as food contact substances. For 89 substances, the Panel concluded that a migration limit should not be needed. These are in the lists 0 and 1 of the Scientific Committee for Food (SCF), defined as substances for which an Acceptable Daily Intake (ADI) does not need to be established, along with substances that are controlled by existing restrictions and/or generic limits. Of the remaining 284 substances, 179 were placed into the low priority group, 102 were placed into the medium priority group and 3 were placed into the high priority group, i.e. salicylic acid (FCM No 121), styrene (FCM No 193) and lauric acid, vinyl ester (FCM No 436).

Experimental characterization of an n-pentane oscillating heat pipe for waste heat recovery in ventilation systems

A tubular oscillating heat pipe (OHP), with long form factor and 1 × 0.5 m2 footprint, was experimentally characterized for passive waste heat recovery via air-to-air heat exchange in a typical Heating Ventilation & Air Conditioning (HVAC) ducting system. Experiments were designed to demonstrate the OHP's ability to utilize otherwise wasted thermal energy to pre-heat or pre-cool air for reducing building energy consumption. Results indicate that the OHP is fully-capable of operating while possessing a relatively long form factor (>1 m) and as a forced convection, air-to-air heat exchanger for waste heat recovery in HVAC systems.

The Toxicological Properties of Petroleum Gases

To characterize the toxicological hazards of petroleum gases, 90-day inhalation toxicity (Organization for Economic Cooperation and Development [OECD] 413) and developmental toxicity (OECD 414) tests were conducted with liquefied propane gas (LPG) at concentrations of 1000, 5000, or 10 000 ppm. A micronucleus test (OECD 474) of LPG was also conducted. No systemic or developmental effects were observed; the overall no observed adverse effect concentration (NOAEC) was 10 000 ppm. Further, there was no effect of LPG exposure at levels up to 10 000 ppm on micronucleus induction and no evidence of bone marrow toxicity. Other alkane gases (ethane, propane, n-butane, and isobutane) were then evaluated in combined repeated exposure studies with reproduction/development toxicity screening tests (OECD 422). There were no toxicologically important changes in parameters relating to systemic toxicity or neurotoxicity for any of these gases at concentrations ranging from 9000 to 16 000 ppm. There was no evidence of effects on developmental or reproductive toxicity in the studies of ethane, propane, or n-butane at the highest concentrations tested. However, there was a reduction in mating in the high-exposure group (9000 ppm) of the isobutane study, which although not significantly different was outside the range previously observed in the testing laboratory. Assuming the reduction in mating to have been toxicologically significant, the NOAEC for the isobutane reproductive toxicity screening test was 3000 ppm (7125 mg/m3). A method is proposed by which the toxicity of any of the 106 complex petroleum gas streams can be estimated from its composition.

Subchronic Inhalation Toxicity Study of n-pentane in Rats

Objectives

This study was conducted in order to obtain information concerning the health hazards that may result from a 13 week inhalation exposure of n-pentane in Sprague-Dawley rats.

Methods

This study was conducted in accordance with the Organization for Economic Co-operation and Development (OECD) guidelines for the testing of chemicals No. 413 'Subchronic inhalation toxicity: 90-day study (as revised in 2009)'. The rats were divided into 4 groups (10 male and 10 female rats in each group), and were exposed to 0, 340, 1,530, and 6,885 ppm n-pentane in each exposure chamber for 6 hour/day, 5 days/week, for 13 weeks. All of the rats were sacrificed at the end of the treatment period. During the test period, clinical signs, mortality, body weights, food consumption, ophthalmoscopy, locomotion activity, urinalysis, hematology, serum biochemistry, gross findings, organ weights, and histopathology were assessed.

Results

During the period of testing, there were no treatment related effects on the clinical findings, body weight, food consumption, ophthalmoscopy, urinalysis, hematology, serum biochemistry, gross findings, relative organ weight, and histopathological findings.

Conclusion

The no-observable-adverse-effect level (NOAEL) of n-pentane is evaluated as being more than 6,885 ppm (20.3 mg/L) in both male and female rats. n-pentane was not a classified specific target organ toxicity in the globally harmonized classification system (GHS).

Neurobehavioral Effects of Acute Exposure to Normal (n-) Paraffins

This article reports the results of neurobehavioral tests on C5-C10 normal paraffinic constituents (n-paraffins). Shortly after exposure, effects were evaluated in several domains including clinical effects, motor activity, functional observations, and visual discrimination performance. The representative C5 n-paraffin, n-pentane, did not produce any evidence of acute central nervous system (CNS) effects at levels up to 20 000 mg/m3. Similarly, there was no compelling evidence that n-octane (C8) produced CNS effects at 14 000 mg/m3, the highest concentration tested. n-decane (C10) produced minor, reversible acute CNS effects at 5000 mg/m3, with 1500 mg/m3 as the no-effect level. Consistent with literature data, there seemed to be a relationship between increasing molecular weight up to C10 and acute CNS effects. However, the CNS effects were reversible. Repeated exposures did not provide evidence of metabolic induction.

A proposed methodology for setting occupational exposure limits for hydrocarbon solvents

Occupational exposure limit (OEL) development for hydrocarbon solvents is complicated because most of these solvents have complex compositions and only a few representative constituents have been studied in detail. A proposed solution to this problem is to group constituents with similar physical, chemical, and toxicological properties and to assign "guidance values" to each group. A unique OEL can then be calculated for each solvent, using a reciprocal calculation procedure (RCP) based on the liquid composition. This procedure follows the American Conference of Governmental Industrial Hygienists' (ACGIH) generic advice for complex mixtures and is recommended by the U.K. Health and Safety Executive for OEL calculations by hydrocarbon solvent manufacturers. The RCP is justified, as the toxicological properties of the constituents are additive and the differences between the vapor and liquid compositions do not substantially affect the calculated exposure limits. The guidance values are based principally on acute central nervous system depression and eye and respiratory tract irritation, effects that are the most sensitive indicators of hydrocarbon solvent exposure. One benefit of this procedure is that it is a relatively simple but practical procedure that requires limited compositional information. Further, it provides OEL recommendations that are consistent with occupational experience and current regulatory advice. Groupings and guidance values are proposed, and sample calculations are provided.

Vascularization and tissue infiltration of a biodegradable polyurethane matrix

Urethanes are frequently used in biomedical applications because of their excellent biocompatibility. However, their use has been limited to bioresistant polyurethanes. The aim of this study was to develop a nontoxic biodegradable polyurethane and to test its potential for tissue compatibility. A matrix was synthesized with pentane diisocyanate (PDI) as a hard segment and sucrose as a hydroxyl group donor to obtain a microtextured spongy urethane matrix. The matrix was biodegradable in an aqueous solution at 37 degrees C in vitro as well as in vivo. The polymer was mechanically stable at body temperatures and exhibited a glass transition temperature (Tg) of 67 degrees C. The porosity of the polymer network was between 10 and 2000 microm, with the majority of pores between 100 and 300 microm in diameter. This porosity was found to be adequate to support the adherence and proliferation of bone-marrow stromal cells (BMSC) and chondrocytes in vitro. The degradation products of the polymer were nontoxic to cells in vitro. Subdermal implants of the PDI-sucrose matrix did not exhibit toxicity in vivo and did not induce an acute inflammatory response in the host. However, some foreign-body giant cells did accumulate around the polymer and in its pores, suggesting its degradation is facilitated by hydrolysis as well as by giant cells. More important, subdermal implants of the polymer allowed marked infiltration of vascular and connective tissue, suggesting the free flow of fluids and nutrients in the implants. Because of the flexibility of the mechanical strength that can be obtained in urethanes and because of the ease with which a porous microtexture can be achieved, this matrix may be useful in many tissue-engineering applications.