Lattice Dynamics of Chalcopyrite Type Compounds. Part I. Vibrational Frequencies

Metal Chalcogenide-Hydroxide Hybrids as an Emerging Family of Two-Dimensional Heterolayered Materials: An Early Review

Two-dimensional (2D) materials and phenomena attract huge attention in modern science. Herein, we introduce a family of layered materials inspired by the minerals valleriite and tochilinite, which are composed of alternating "incompatible", and often incommensurate, quasi-atomic sheets of transition metal chalcogenide (sulfides and selenides of Fe, Fe-Cu and other metals) and hydroxide of Mg, Al, Fe, Li, etc., stacked via electrostatic interaction rather than van der Waals forces. We survey the data available on the composition and structure of the layered minerals, laboratory syntheses of such materials and the effect of reaction conditions on the phase purity, morphology and composition of the products. The spectroscopic results (Mössbauer, X-ray photoelectron, X-ray absorption, Raman, UV-vis, etc.), physical (electron, magnetic, optical and some others) characteristics, a specificity of thermal behavior of the materials are discussed. The family of superconductors (FeSe)·(Li,Fe)(OH) having a similar layered structure is briefly considered too. Finally, promising research directions and applications of the valleriite-type substances as a new class of prospective multifunctional 2D materials are outlined.

Phonon Raman spectroscopy of nanocrystalline multinary chalcogenides as a probe of complex lattice structures

Ternary (I-III-VI) and quaternary (I-II-IV-VI) metal-chalcogenides like CuInS₂or Cu₂ZnSn(S,Se)₄are among the materials currently most intensively investigated for various applications in the area of alternative energy conversion and light-emitting devices. They promise more sustainable and affordable solutions to numerous applications, compared to more developed and well understood II-VI and III-V semiconductors. Potentially superior properties are based on an unprecedented tolerance of these compounds to non-stoichiometric compositions and polymorphism. However, if not properly controlled, these merits lead to undesirable coexistence of different compounds in a single polycrystalline lattice and huge concentrations of point defects, becoming an immense hurdle on the way toward real-life applications. Raman spectroscopy of phonons has become one of the most powerful tools of structural diagnostics and probing physical properties of bulk and microcrystalline I-III-VI and I-II-IV-VI compounds. The recent explosive growth of the number of reports on fabrication and characterization of nanostructures of these compounds must be pointed out as well as the steady use of Raman spectroscopy for their characterization. Interpretation of the vibrational spectra of these compound nanocrystals (NCs) and conclusions about their structure can be complicated compared to bulk counterparts because of size and surface effects as well as emergence of new structural polymorphs that are not realizable in the bulk. This review attempts to summarize the present knowledge in the field of I-III-VI and I-II-IV-VI NCs regarding their phonon spectra and capabilities of Raman and IR spectroscopies in the structural characterizations of these promising families of compounds.

Mixed Cu-Fe Sulfides Derived from Polydopamine-Coated Prussian Blue Analogue as a Lithium-Ion Battery Electrode

Batteries employing transition-metal sulfides enable high-charge storage capacities, but polysulfide shuttling and volume expansion cause structural disintegration and early capacity fading. The design of heterostructures combining metal sulfides and carbon with an optimized morphology can effectively address these issues. Our work introduces dopamine-coated copper Prussian blue (CuPB) analogue as a template to prepare nanostructured mixed copper-iron sulfide electrodes. The material was prepared by coprecipitation of CuPB with in situ dopamine polymerization, followed by thermal sulfidation. Dopamine controls the particle size and favors K-rich CuPB due to its polymerization mechanism. While the presence of the coating prevents particle agglomeration during thermal sulfidation, its thickness demonstrates a key effect on the electrochemical performance of the derived sulfides. After a two-step activation process during cycling, the C-coated KCuFeS₂ electrodes showed capacities up to 800 mAh/g at 10 mA/g with nearly 100% capacity recovery after rate handling and a capacity of 380 mAh/g at 250 mA/g after 500 cycles.

Designing a novel heterostructure AgInS2@MIL-101(Cr) photocatalyst from PET plastic waste for tetracycline degradation

Semiconductor-containing porous materials with a well-defined structure could be unique scaffolds for carrying out selective organic transformations driven by visible light. We herein introduce for the first time a heterostructure of silver indium sulfide (AgInS₂) ternary chalcogenide and a highly porous MIL-101(Cr) metal-organic framework (MOF) synthesised from polyethylene terephthalate plastic waste. Our results demonstrate that AgInS₂ nanoparticles were uniformly attached to each lattice plane of the octahedral MIL-101(Cr) structure, resulting in a nanocomposite with a high distribution of semiconductors in a porous media. We also demonstrate that the nanocomposite with up to 40% of AgInS₂ doping exhibited excellent catalytic activity for tetracycline degradation under visible light irradiation (∼99% tetracycline degraded after 4 h) and predominantly maintained its performance after five cycles. These results could promote a new material circularity pathway to develop new semiconductors that can be used to protect water from further pollution.

Atomic Force Microscopy and Raman Microspectroscopy Investigations of the Leaching of Chalcopyrite (112) Surface

The aim of this study was to determine the reactivity of the chalcopyrite (112) surface under industrially relevant leaching conditions. Leaching of the chalcopyrite (112) surface was carried out at approximately pH 1 and in the presence of 0.01 M ferric or ferrous. The atomic force microscopy (AFM) and Raman microspectroscopy analyses suggested that the chalcopyrite (112) surface was relatively inert, with no formation of elemental sulfur observed over 42 days of leaching. In addition, it was found that the distribution of Fe-S and Cu-S bonds was always negatively correlated, as revealed by Raman analysis. This suggested that the breakage of the Fe-S and Cu-S bonds did not occur concurrently at a specific reaction site. The rate of variation of surface roughness, as reflected by AFM data, also suggested that leaching of the chalcopyrite (112) surface in the ferric or ferrous solution medium likely occurred more rapidly in the initial stage (fewer than seven days) than in the later stage (after seven days).

Ternary Metal Chalcogenide Heterostructure (AgInS2-TiO2) Nanocomposites for Visible Light Photocatalytic Applications

Hybrid nanoarchitectures of AgInS2 and TiO2 photocatalysts were prepared by using a modified sol-gel method. The experimental results reveal that these nanocomposites display enhanced visible light absorption and effective charge carrier separation compared to their pristine parent samples (AgInS2 or TiO2). 0.5 wt % AgInS2 loading was found to be the optimum concentration for photocatalytic applications. More than 95% of doxycycline degradation was achieved within 180 min of solar light illumination. Similarly, the dopant concentrations at lower values (<2 wt %) exhibited 300 times higher H2 generation rate under visible light irradiation compared to AgInS2 and TiO2. The microbial strains (Escherichia coli and Staphylococcus aureus) exhibited a 99.999% reduction within half an hour of simulated solar light illumination. The computational investigation was employed to understand the structural, electronic, and the dielectric properties of AgInS2 and TiO2 composites. The improved photocatalytic results are explained as a result of the decreased rate of exciton recombination. The current investigation opens up new insights into the use of novel ternary heterostructure nanocomposites for improved visible light activity.

Pressure Effect of the Vibrational and Thermodynamic Properties of Chalcopyrite-Type Compound AgGaS₂: A First-Principles Investigation

To explore the structural, vibrational, and thermodynamic properties of the chalcopyrite-type compound AgGaS₂ under pressure, we applied hydrostatic pressure to the relaxed compound based on the first principles calculation and quasi-harmonic approximation. The structural parameters, including lattice constants and bond lengths decrease monotonically with the increasing pressure. The phonon dispersion curves under various pressures reveal the structural phase transition of chalcopyrite-type compound AgGaS₂ at about 4 GPa. The intrinsic mechanism of thermal conductivity for the chalcopyrite-type compound AgGaS₂ has been shown with phonon anharmonicity. The frequencies of the optical phonons at the center point Γ of the first Brillouin zone were calculated with the longitudinal optical–transverse optical (LO–TO) splitting mode. The dependence of the frequencies of the optical phonons on the pressure provides the information for the Raman spectroscopic study under high pressure. The pressure dependence of the Grüneisen parameters indicates that the instability of chalcopyrite-type compound AgGaS₂ is associated with the softening of the acoustic phonon modes at around the center point Γ. The thermal conductivity for chalcopyrite-type compound AgGaS₂ could be reduced by applying external pressure. The various thermodynamic properties, such as the Helmholtz free energy, entropy, and heat capacity, at different temperatures and pressures were discussed and analyzed based on the phonon properties.

Silicon nanowire-silver indium selenide heterojunction photodiodes

Structural and optoelectronic properties of silicon (Si) nanowire-silver indium selenide (AgInSe2) thin film heterojunctions were investigated. The metal-assisted etching method was employed to fabricate vertically aligned Si nanowire arrays. Stoichiometric AgInSe2 films were then deposited onto the nanowires using co-sputtering and sequential selenization techniques. It was demonstrated that the three-dimensional interface between the Si nanowire arrays and the AgInSe2 thin film significantly improved the photosensitivity of the heterojunction diode compared to the planar reference. The improvements in device performance are discussed in terms of interface state density, reflective losses and surface recombination of the photogenerated carriers, especially in the high-energy region of the spectrum.

Lattice dynamics and elastic properties of LiPN(2) and NaPN(2)

Density functional theory calculations using the ultrasoft pseudopotentials and local density approximation have been carried out to investigate the phonon spectra and elastic properties of LiPN(2) and NaPN(2) crystals with chalcopyrite structure. As follows from the results obtained, phonon spectra of LiPN(2) and NaPN(2) consist of three bands and have a high-frequency boundary at ∼1200 cm(-1). Phonon modes of the upper half of the spectrum involve mainly nitrogen atom vibrations, whereas low-frequency modes have a predominant contribution from the lithium or sodium atoms and the contribution of phosphorus is almost uniformly distributed over the entire range of allowed frequencies. The calculations performed show that the dynamical and elastic behaviour of the compounds under study is determined by the strong covalent bond between P and N atoms and the substantially weaker interaction of the alkali metal and N atoms.