MR-based temperature monitoring for hot saline injection therapy

In vivo comparison of simultaneous versus sequential injection technique for thermochemical ablation in a porcine model

PURPOSE

To investigate simultaneous and sequential injection thermochemical ablation in a porcine model, and compare them to sham and acid-only ablation.

MATERIALS AND METHODS

This IACUC-approved study involved 11 pigs in an acute setting. Ultrasound was used to guide placement of a thermocouple probe and coaxial device designed for thermochemical ablation. Solutions of 10 M acetic acid and NaOH were used in the study. Four injections per pig were performed in identical order at a total rate of 4 mL/min: saline sham, simultaneous, sequential, and acid only. Volume and sphericity of zones of coagulation were measured. Fixed specimens were examined by H&E stain.

RESULTS

Average coagulation volumes were 11.2 mL (simultaneous), 19.0 mL (sequential) and 4.4 mL (acid). The highest temperature, 81.3°C, was obtained with simultaneous injection. Average temperatures were 61.1°C (simultaneous), 47.7°C (sequential) and 39.5°C (acid only). Sphericity coefficients (0.83-0.89) had no statistically significant difference among conditions.

CONCLUSIONS

Thermochemical ablation produced substantial volumes of coagulated tissues relative to the amounts of reagents injected, considerably greater than acid alone in either technique employed. The largest volumes were obtained with sequential injection, yet this came at a price in one case of cardiac arrest. Simultaneous injection yielded the highest recorded temperatures and may be tolerated as well as or better than acid injection alone. Although this pilot study did not show a clear advantage for either sequential or simultaneous methods, the results indicate that thermochemical ablation is attractive for further investigation with regard to both safety and efficacy.

Imaging in interventional oncology

Medical imaging in interventional oncology is used differently than in diagnostic radiology and prioritizes different imaging features. Whereas diagnostic imaging prioritizes the highest-quality imaging, interventional imaging prioritizes real-time imaging with lower radiation dose in addition to high-quality imaging. In general, medical imaging plays five key roles in image-guided therapy, and interventional oncology, in particular. These roles are (a) preprocedure planning, (b) intraprocedural targeting, (c) intraprocedural monitoring, (d) intraprocedural control, and (e) postprocedure assessment. Although many of these roles are still relatively basic in interventional oncology, as research and development in medical imaging focuses on interventional needs, it is likely that the role of medical imaging in intervention will become even more integral and more widely applied. In this review, the current status of medical imaging for intervention in oncology will be described and directions for future development will be examined.

Accuracy of MR Temperature Measurement Based on Chemical Shift Change for Radiofrequency Ablation Using Hook-shaped Electrodes

The purpose of the current study is to evaluate the accuracy of MR thermometry for radiofrequency ablation (RFA) with hook-shaped electrodes. The objects were eight extracted bovine livers. The chemical shift change was calculated from MR images acquired with a spoiled gradient echo sequence and compared with the temperature directly measured with a thermocouple. Linear regression was established between them with a coefficient of -0.0110+/-0.0007 ppm/ degrees C and errors were calculated as -0.50+/-7.50 degrees C. MR thermometry is capable of monitoring temperature for RFA.

Real-time MR temperature mapping of rabbit liver in vivo during thermal ablation

It has been shown that quantitative MRI thermometry using the proton resonance frequency (PRF) method can be used to noninvasively monitor the evolution of tissue temperature, and to guide minimally-invasive tumor ablation based on local hyperthermia. Although hepatic tumors are among the main targets for thermal ablation, PRF-based temperature MRI of the liver is difficult to perform because of motion artifacts, fat content, and low T(*) (2). In this study the stability of real-time thermometry was tested on a clinical 1.5 T scanner for rabbit liver in vivo. The fast segmented EPI principle was used together with respiratory gating to limit respiratory motion artifacts. Lipid signal suppression was achieved with a binomial excitation pulse. Saturation slabs were applied to suppress artifacts due to flowing blood. The respiratory-gated MR thermometry in the rabbit liver in vivo showed a standard deviation (SD) of 1-3 degrees C with a temporal resolution of 3 s per slice and 1.4 mm x 1.9 mm spatial resolution in plane (slice thickness = 5 mm). The method was used to guide thermal ablation experiments with a clinical infrared laser. The estimated size of the necrotic area, based on the thermal dose calculated from MR temperature maps, corresponded well with the actual lesion size determined by histology and conventional MR images obtained 5 days posttreatment. These results show that quantitative MR temperature mapping can be obtained in the liver in vivo, and can be used for real-time control of thermal ablation and for lesion size prediction.

Variation correction algorithm: analysis of phase suppression and thermal profile fidelity for proton resonance frequency magnetic resonance thermometry at 0.2 T

PURPOSE

To develop and analyze the performance of the variation correction algorithm (VCA), a phase correction technique that mitigates the contribution of background phase variations by combining accurate alignment of echoes, K-space-based phase correction (as opposed to spatial polynomials), and extraction of alias-free phase difference images.

MATERIALS AND METHODS

A series of echo-shifted gradient-recalled echo (GRE) images was processed with K-space alignment and phase corrected with increasing sizes of M x M masks of central K-space coefficients. The extent of background phase variation suppression due to magnet field drift was assessed. Further, a simulated thermal profile was superimposed on the same data in a related experiment. Residual errors in reconstructed simulated thermal profiles were quantitatively characterized to estimate algorithm performance.

RESULTS

Using a 3 x 3 K-space mask, the VCA was able to 1) maintain the typical mean background error in a 35 x 35 pixel region of interest (ROI) at -0.1 degrees C; and 2) reconstruct, relative to the applied thermal profile, a phase-corrected profile that typically contains a 1.7 degrees C underestimation of peak temperature difference and a mean error along the 60 degrees C line of -0.8 degrees C.

CONCLUSION

The results suggest that thermal profiles can be accurately reconstructed at 0.2 T using the VCA, even in the presence of over 1 ppm spatially and temporally dependent field drift over a 1-hour time frame.