Supported liquid membrane extraction of urinarytrans, trans-muconic acid, a biomarker for benzene exposure

Development of Hollow-Fiber Liquid-Phase Microextraction Method for Determination of Urinary trans,trans-Muconic Acid as a Biomarker of Benzene Exposure

For the first time, hollow-fiber liquid-phase microextraction combined with high-performance liquid chromatography–ultraviolet was used to extract trans,trans-muconic acid, in urine samples of workers who had been exposed to benzene. The parameters affecting the metabolite extraction were optimized as follows: the volume of sample solution was 11 mL with pH 2, liquid membrane containing dihexyl ether as the supporter, 15% (w/v) of trioctylphosphine oxide as the carrier, the time of extraction was 120 minutes, and stirring rate was 500 rpm. Organic phase impregnated in the pores of a hollow fiber was extracted into 24 µL solution of 0.05 mol L⁻¹ Na₂CO₃ located inside the lumen of the fiber. Under optimized conditions, a high enrichment factor of 153–182 folds, relative recovery of 83%–92%, and detection limit of 0.001 µg mL⁻¹ were obtained. The method was successfully applied to the analysis of ttMA in real urine samples.

Determination of short-chain fatty acids in serum by hollow fiber supported liquid membrane extraction coupled with gas chromatography

A method based on hollow fiber supported liquid membrane extraction coupled with a gas chromatograph equipped with flame ionization detector (GC-FID) was developed for the determination of six short-chain fatty acids including acetic acid, propionic acid, i-butyric acid, n-butyric acid, i-valeric acid and n-valeric acid in serum. Hollow fiber supported liquid membrane extraction was employed for preconcentration and clean-up of the samples. The fatty acids were extracted from the acidic donor (diluted serum) into a liquid membrane formed in the wall of the hollow fiber with 10% tri-n-octylphoshphine oxide (TOPO) in di-n-hexyl ether, and then extracted back into a basic acceptor solution filled in the lumen of the hollow fiber. After being acidified with HCl, the acceptor was directly analyzed by GC-FID. The acceptor concentration, donor pH, membrane liquid and extracting time were optimized giving an enrichment factor up to 155 times. The good linearity (r(2)>0.980), reasonable recovery (87.2-121%), and satisfactory intra-assay (8.2-11.5%) and inter-assay (6.1-11.6%) precision illustrated the good performance of the present method. Limits of detection (LOD) ranged from 0.04 to 0.24 microM and limits of quantification (LOQ) varied from 0.13 to 0.80 microM.

An electrospray ionization tandem mass spectrometry based system with an online dual-loop cleanup device for simultaneous quantitation of urinary benzene exposure biomarkers trans,trans-muconic acid and S-phenylmercapturic acid

An electrospray ionization tandem mass spectrometry (ESI-MS/MS) system with an online dual-loop cleanup device was developed for simultaneous quantitation of the urinary benzene exposure biomarkers trans,trans-muconic acid (ttMA) and S-phenylmercapturic acid (SPMA). The cleanup device was constructed from an autosampler, two electrically operated two-position switching valves, a reversed-phase C18 trap cartridge, a 200-microL loop, and two solvent-delivery pumps. The device was interfaced directly with a triple-quadrupole mass spectrometer and fully controlled by computer software and hardware. Because isotope dilution by introducing 13C-labeled ttMA and SPMA as internal standards was employed, the precision of the analytical system was high (for ttMA, intra- and inter-day CV values ranged from 3.82-4.53%; for SPMA, 2.13-7.06%). The calibration curves obtained using human urine spiked with ttMA were linear from 15.6-4000 microg/L (R = 0.9998) and SPMA at concentrations from 0.78-200 microg/L (R = 0.9993). The method detection limit (MDL) for SPMA was 0.23 microg/L. The MDL of ttMA could not be determined accurately because of unavailability of an appropriate blank urine matrix, but was estimated to be lower than 7.43 microg/L. Without tedious manual sample cleanup procedures the analytical system is fully automated and is therefore useful for high-throughput simultaneous determination of urinary ttMA and SPMA. The sample throughput is roughly 100 samples per day. With the selectivity and the sensitivity provided by MS/MS detection, the analytical system can be used for large-scale monitoring of environmental or occupational exposure of humans to benzene.

The XT-Tube Extractor: A Hollow Fiber-Based Supported Liquid Membrane Extractor for Bioanalytical Sample Preparation

A new supported liquid membrane extractor for bioanalytical sample preparation is presented. The extractor consists of a polypropylene hollow fiber mounted inside a PTFE tube by means of a cross-connector and a tee-connector. All parts are commercially available, inexpensive, and easily assembled. An organic solvent in the pores of the fiber forms a liquid membrane that separates the sample, which is pumped along the outside of the fiber, from the acceptor phase, which is pumped inside. The length of the hollow fiber may easily be varied to meet different demands on extractive surface and extract volumes. To test the system, the strongly acidic plasticizer/flame retardant metabolite diphenyl phosphate ester (DPhP), with a pKa value of 0.26, was extracted from urine. DPhP was protonated using 4 M hydrochloric acid and extracted into an acceptor phase at pH 9. Thirty extractions were made with the same liquid membrane without any decrease in extraction efficiency and with a relative standard deviation <7%. An analyte concentration enrichment of 5-10 times was achieved in the extraction step, giving a limit of detection (S/N = 3) of 0.014 microg/mL with LC/ESI-MS and 0.18 microg/mL with CE-UV. The effects on extraction efficiency using different sample pH, organic solvents, sample flow rates, and lengths of the fiber were evaluated.