Single-Pot Ethane Carboxylation Catalyzed by New Oxorhenium(V) Complexes with N,O Ligands

C-Heterogenized Re Nanoparticles as Effective Catalysts for the Reduction of 4-Nitrophenol and Oxidation of 1-Phenylethanol

Rhenium nanoparticles (Re NPs) supported on Norit (activated carbon—C) and graphene (G) were prepared by a solvothermal method under microwave irradiation (MW). The synthesised heterogeneous catalysts were characterised and tested as reduction and oxidation catalysts, highlighting their dual catalytic behaviour. In the first case, they were used, for the first time, to reduce 4-nitrophenol, in aqueous medium, under MW irradiation. Re catalysts were easily recovered by centrifugation and recycled up to six times without significant activity loss. However, the same Re catalysts in MW-assisted oxidation of 1-phenylethanol with no added solvent experienced a significant loss of activity when recycled. The higher activity of the rhenium nanoparticles supported on graphene (Re/G) catalyst in both reactions was assigned to the higher dispersion and smaller particle size of Re NPs when graphene is the support.

Commercial Gold Complexes Supported on Functionalised Carbon Materials as Efficient Catalysts for the Direct Oxidation of Ethane to Acetic Acid

The single-pot efficient oxidation of ethane to acetic acid catalysed by Au(I) or Au(III) compounds, chlorotriphenylphosphinegold(I) (1), chlorotrimethylphosphinegold(I) (2), 1,3-bis(2,6-diisopropylphenyl)imidazol-2-ylidenegold(I) chloride (3), dichloro(2-pyridinecarboxylato)gold(III) (4), homogenous and supported on different carbon materials: activated carbon (AC), multi-walled carbon nanotubes (CNT) and carbon xerogel (CX), oxidised with nitric acid followed by treatment with NaOH (-ox-Na), is reported. The reactions were performed in water/acetonitrile. The materials were selective for the production of acetic acid, with no trace of by-products being detected. The best homogenous catalysts were complexes 2 and 3 which showed the highest ethane conversion and an acetic acid yield of ca. 21%, followed by 4 and 1. The heterogenised materials showed much better activity than the homogenous counterparts, with acetic acid yields up to 41.4% for 4@CNT-ox-Na, and remarkable selectivity (with acetic acid being the only product detected). The heterogenised catalysts with the best results were reused up to five cycles, with no significant loss of activity, and maintaining high selectivity for acetic acid. 4@CNT-ox-Na showed not only the best catalytic activity but also the best stability during the recycling runs.

Unprecedented Use of NHC Gold (I) Complexes as Catalysts for the Selective Oxidation of Ethane to Acetic Acid

The highly efficient eco-friendly synthesis of acetic acid (40% yield) directly from ethane is achieved by the unprecedented use of N-heterocyclic carbene (NHC) and N-heterocyclic oxo-carbene (NHOC) gold(I) catalysts in mild conditions. This is a selective and promising protocol to generate directly acetic acid from ethane, in comparison with the two most used methods: (i) the three-step, capital- and energy-intensive process based on the high-temperature conversion of methane to acetic acid; (ii) the current industrial methanol carbonylation processes, based in iridium and expensive rhodium catalysts. Green metrics determinations highlight the environmental advantages of the new ethane oxidation procedure. Comparison with previous reported published catalysts is performed to highlight the features of this remarkable protocol.

Selective Oxidation of Ethane to Acetic Acid Catalyzed by a C-Scorpionate Iron(II) Complex: A Homogeneous vs. Heterogeneous Comparison

The direct, one-pot oxidation of ethane to acetic acid was, for the first time, performed using a C-scorpionate complex anchored onto a magnetic core-shell support, the Fe₃O₄/TiO₂/[FeCl₂{κ³-HC(pz)₃}] composite. This catalytic system, where the magnetic catalyst is easily recovered and reused, is highly selective to the acetic acid synthesis. The performed green metrics calculations highlight the “greeness” of the new ethane oxidation procedure.

Rhenium(V)-oxo complexes [ReOX2(N∩O)(EPh3)] (X=Cl, Br, I; E=P, As) – synthesis, structure, spectroscopy, and catalytic properties

The present review aims to give a comprehensive survey about the chemistry of rhenium(V)-oxo complexes of general formula [ReOX2(N∩O)(EPh3)], where X=Cl, Br, I, E=P, As, and N∩O stands for uninegative chelating N∩O-ligand, carried out within the last four decades. In addition to the synthesis aspects, the available structural data as well as the results issued from techniques such as infrared and ultraviolet-visible spectroscopies are collected and discussed. Furthermore, a brief description of the applications of these compounds in catalysis is included.

On the Origin of Reactivity Enhancement/Suppression upon Sequential Ligation: [Re(CO)x ]+ /CH4 (x=0-3) Couples

The thermal gas-phase reactions of rhenium carbonyl complexes [Re(CO)_x ]⁺ (x=0-3) with methane have been explored by using FT-ICR mass spectrometry complemented by high-level quantum chemical calculation. While it had been concluded in previous studies that addition of closed-shell ligands in general decreases the reactivity of metal ions, the current work provides an exception: the previously demonstrated inertness of atomic Re⁺ towards methane is completely changed upon ligation with CO. Both [Re(CO)]⁺ and [Re(CO)₂ ]⁺ bring about efficient dehydrogenation of the hydrocarbon under ambient conditions. However, addition of a third ligand to form [Re(CO)₃ ]⁺ completely quenches the reactivity.

Crystal structure, solvothermal synthesis, thermogravimetric studies and DFT calculations of a five-coordinate cobalt(II) compound based on the N,N-bis-(2-hy-droxy-eth-yl)glycine anion

The reaction of CoCl2·6H2O, N,N-bis-(2-hy-droxy-eth-yl)glycine and tri-ethyl-amine (Et3N) in ethanol solution under solvothermal conditions produced crystals of [N,N-bis-(2-hy-droxy-eth-yl)glycinato]chloridocobalt(II), [Co(C6H12NO4)Cl]. The CoII ion is coordinated in a slightly distorted trigonal-bipyramidal environment which is defined by three O atoms occupying the equatorial plane and the N and Cl atoms in the apical sites. In the crystal, two types of O-H⋯O hydrogen bonds connect the mol-ecules, forming a two-dimensional network parallel to (001). The mol-ecular structure of the title compound confirms the findings of FTIR, elemental analysis, ESI-MS analysis and TG analysis. By using the density functional theory (DFT) (B3LYP) method with 6-31G(d) basis set, the molecular structure has been calculated and optimized.

A Cu(ii) MOF with a flexible bifunctionalised terpyridine as an efficient catalyst for the single-pot hydrocarboxylation of cyclohexane to carboxylic acid in water/ionic liquid medium

A bifunctionalised terpyridine based Cu(ii) MOF for efficient hydrocarboxylation of cyclohexane to cyclohexanecarboxylic acid in an ionic liquid medium.

Oxorhenium complexes bearing the water-soluble tris(pyrazol-1-yl)methanesulfonate, 1,3,5-triaza-7-phosphaadamantane, or related ligands, as catalysts for Baeyer-Villiger oxidation of ketones

New rhenium(VII or III) complexes [ReO3(PTA)2][ReO4] (1) (PTA = 1,3,5-triaza-7-phosphaadamantane), [ReO3(mPTA)][ReO4]I (2) (mPTA = N-methyl-1,3,5-triaza-7-phosphaadamantane cation), [ReO3(HMT)2][ReO4] (3) (HMT = hexamethylenetetramine), [ReO3(η(2)-Tpm)(PTA)][ReO4] (4) [Tpm = hydrotris(pyrazol-1-yl)methane, HC(pz)3, pz = pyrazolyl], [ReO3(Hpz)(HMT)][ReO4] (5) (Hpz = pyrazole), [ReO(Tpms)(HMT)] (6) [Tpms = tris(pyrazol-1-yl)methanesulfonate, O3SC(pz)3(-)] and [ReCl2{N2C(O)Ph}(PTA)3] (7) have been prepared from the Re(VII) oxide Re2O7 (1-6) or, in the case of 7, by ligand exchange from the benzoyldiazenido complex [ReCl2{N2C(O)Ph}(Hpz)(PPh3)2], and characterized by IR and NMR spectroscopies, elemental analysis and electrochemical properties. Theoretical calculations at the density functional theory (DFT) level of theory indicated that the coordination of PTA to both Re(III) and Re(VII) centers by the P atom is preferable compared to the coordination by the N atom. This is interpreted in terms of the Re-PTA bond energy and hard-soft acid-base theory. The oxo-rhenium complexes 1-6 act as selective catalysts for the Baeyer-Villiger oxidation of cyclic and linear ketones (e.g., 2-methylcyclohexanone, 2-methylcyclopentanone, cyclohexanone, cyclopentanone, cyclobutanone, and 3,3-dimethyl-2-butanone or pinacolone) to the corresponding lactones or esters, in the presence of aqueous H2O2. The effects of a variety of factors are studied toward the optimization of the process.

Mild, single-pot hydrocarboxylation of gaseous alkanes to carboxylic acids in metal-free and copper-promoted aqueous systems

A direct, selective and highly efficient method has been developed for the hydrocarboxylation of C(n) gaseous alkanes into C(n+1) carboxylic acids, in aqueous acid-solvent-free medium at low temperatures. The approach is based on a metal-free or copper-promoted reaction of ethane, propane or n-butane with carbon monoxide and water, in a H(2)O/MeCN medium at 50-60 degrees C, in the presence of potassium peroxodisulfate. The effects of various reaction parameters, such as the absence or presence of a copper promoter, solvent composition, temperature, time, CO and alkane pressure, were studied. A free radical mechanism was confirmed by radical trap experiments involving acyl radical formation, oxidation and subsequent hydroxylation by water. Remarkable yields (based on alkane) of carboxylic acids in the 34-41 % range were achieved even in the metal-free systems, although in the presence of a tetracopper(II) triethanolaminate derived promoter they reach superior values of 58 and 87 % for the hydrocarboxylations of propane and n-butane, respectively; in these cases, branched isobutyric and 2-methylbutyric acids were the predominant products. From a green perspective, important features of the present alkane hydrocarboxylations include the exceptional metal-free, mild and acid-solvent-free reaction conditions, the operation in aqueous medium with a rare hydroxylating role of water, with high selectivities, and yields of carboxylic acids. Taken together, these conditions correspond to the mildest and the most efficient method so far reported for the oxidative functionalisation of gaseous alkanes.

Synthesis, X-Ray Structure, and Characterization of Catena-bis(benzoate)bis{N,N-bis(2-hydroxyethyl)glycinate}cadmium(II)

The reaction of N, N-bis(2-hydroxyethyl)glycine (bicine; bicH₃) with Cd(O₂CPh)₂ · 2H₂O in MeOH yielded the polymeric compound [Cd₂(O₂CPh)₂(bicH₂)₂]_n(1). The complex crystallizes in the tetragonal space group P4₁2₁2. The lattice constants are a = b = 12.737(5) and c = 18.288(7) Å. The compound contains chains of repeating {Cd₂(O₂CPh)₂(bicH₂)₂} units. One Cd^II atom is coordinated by two carboxylate oxygen, four hydroxyl oxygen, and two nitrogen atoms from two symmetry-related 2.21111 (Harris notation) bicH₂⁻ ligands. The other Cd^II atom is coordinated by six carboxylate oxygen atoms, four from two bicH₂⁻ ligands and two from the monodentate benzoate groups. Each bicinate(-1) ligand chelates the 8-coordinate, square antiprismatic Cd^II atom through one carboxylate oxygen, the nitrogen, and both hydroxyl oxygen atoms and bridges the second, six-coordinate trigonal prismatic Cd^II center through its carboxylate oxygen atoms. Compound 1 is the first structurally characterized cadmium(II) complex containing any anionic form of bicine as ligand. IR data of 1 are discussed in terms of the coordination modes of the ligands and the known structure.