Theoretical study of wetting behavior of nanoparticles at fluid interfaces

The Impact of Nanofluids on Droplet/Spray Cooling of a Heated Surface: A Critical Review

Cooling by impinging droplets has been the subject of several studies for decades and still is, and, in the last few years, the potential heat transfer enhancement obtained thanks to nanofluids’ use has received increased interest. Indeed, the use of high thermal conductivity fluids, such as nanofluids’, is considered today as a possible way to strongly enhance this heat transfer process. This enhancement is related to several physical mechanisms. It is linked to the nanofluids’ rheology, their degree of stabilization, and how the presence of the nanoparticles impact the droplet/substrate dynamics. Although there are several articles on droplet impact dynamics and nanofluid heat transfer enhancement, there is a lack of review studies that couple these two topics. As such, this review aims to provide an analysis of the available literature dedicated to the dynamics between a single nanofluid droplet and a hot substrate, and the consequent enhancement or reduction of heat transfer. Finally, we also conduct a review of the available publications on nanofluids spray cooling. Although using nanofluids in spray cooling may seem a promising option, the few works present in the literature are not yet conclusive, and the mechanism of enhancement needs to be clarified.

Wetting behavior of spherical nanoparticles at a vapor-liquid interface: a density functional theory study

The wetting behavior of spherical nanoparticles at a vapor-liquid interface is investigated by using density functional theory, and the line tension calculation method is modified by analyzing the total energy of the vapor-liquid-particle equilibrium. Compared with the direct measurement data from simulation, the results reveal that the thermodynamically consistent Young's equation for planar interfaces is still applicable for high curvature surfaces in predicting a wide range of contact angles. The effect of the line tension on the contact angle is further explored, showing that the contact angles given by the original and modified Young's equations are nearly the same within the region of 60° < θ < 120°. Whereas the effect is considerable when the contact angle deviates from the region. The wetting property of nanoparticles in terms of the fluid-particle interaction strength, particle size, and temperature is also discussed. It is found that, for a certain particle, a moderate fluid-particle interaction strength would keep the particle stable at the interface in a wide temperature range.

Contact angle hysteresis of microbead suspensions

Microbead suspensions are often used in microfluidic devices for transporting biomolecules. An experimental investigation on the wettability of microbead suspension is presented in this study. The variation in the surface tension and the equilibrium contact angle with the change in the volume fraction of the microbead is presented here. The surface tension of the microbead suspension is measured with the pendant drop technique, whereas the dynamic contact angle measurements, i.e., advancing and receding contact angles, are measured with the sessile drop technique. An equilibrium contact angle of a suspension with particular volume fraction is determined by computing an average over the measured advancing and receding contact angles. It is observed that the surface tension and the equilibrium contact angle determined from advancing and receding contact angles vary with the magnitude of the microbeads volume fraction in the suspension. A decrease in the surface tension with an increase in the volume fraction of the microbead suspension is observed. The advancement and the recession in contact line for dynamic contact angle measurements are achieved with the motorized dosing mechanism. For microbead suspensions, the advancement of the contact line is faster as compared to the recession of the contact line for the same flow rate. The presence of microbeads assists in the advancement and the recession of the contact line of the suspension. A decrease in the equilibrium contact angles with an increase in the microbead suspension volume fraction is observed. Inclusion of microbeads in the suspension increases the wetting capability for the considered combination of the microbead suspension and substrate. Finally, empirical correlations for the surface tension and the contact angle of the suspension as a function of microbead volume fraction are proposed. Such correlations can readily be used to develop mechanistic models for the capillary transport of microbead suspensions related to LOC applications.