Über Langperioden bei verstrecktem Polyäthylen

Modelling Post-molding Warping

The post-molding warping of injection molded parts is strongly influenced by thermal expansion history. We show that a thermal expansion hysteresis loop occurs, so that heating and cooling curves can sometimes be different, due to microstructural changes. Following an extensive investigation of thermal expansion for a polypropylene, we propose a model to predict the specific volume change during post thermal treatments. The model predictions are in good agreement with the experimental measurements.

Melting of polymer single crystals studied by dynamic Monte Carlo simulations

We report dynamic Monte Carlo simulations of lattice polymers melting from a metastable chain-folded lamellar single crystal. The single crystal was raised and then melted in an ultrathin film of polymers wetting on a solid substrate, mimicking the melting observations made by using Atomic Force Microscopy. We observed that the thickness distribution of the single crystal appears quite inhomogeneous and the thickness increases gradually from facetted edges to the center. Therefore, at low melting temperatures, melting stops at a certain crystal thickness, and melting-recrystallization occurs when allowing crystal thickening; at intermediate temperatures, melting maintains the crystal shape and exhibits different speeds in two stages; at high temperatures, fast melting makes a melting hole in the thinnest region, as well as a saw-tooth-like pattern at the crystal edges. In addition, the linear melting rates at low temperatures align on the curve extrapolated from the linear crystal growth rates. The temperature dependence of the melting rates exhibits a regime transition similar to crystal growth. Such kinetic symmetry persists in the melting rates with variable frictional barriers for c -slip diffusion in the crystal as well as with variable chain lengths. Visual inspections revealed highly frequent reversals upon melting of single chains at the wedge-shaped lateral front of the lamellar crystal. We concluded that the melting kinetics is dominated by the reverse process of intramolecular secondary crystal nucleation of polymers.

Structural changes and chain radius of gyration in cold-drawn polyethylene after annealing: small- and wide-angle X-ray scattering and small-angle neutron scattering studies

Samples made from linear polyethylene were drawn at room temperature and subsequently annealed at high temperatures below the melting point. The structural changes of the crystalline lamellae and lamellar superstructures as well as the single chain radius of gyration were studied by means of combined small- and wide-angle X-ray scattering and small-angle neutron scattering (SANS). After drawing, the polymeric chain segments in the crystalline phase are preferentially oriented along the drawing direction with a high degree of orientation whereas the lamellae in the samples are found to be slightly sheared exhibiting oblique surfaces as evidenced by X-ray scattering. SANS indicates that the chains are highly elongated along the drawing direction. Annealing the deformed samples at temperatures where the mechanical alpha-process of polyethylene is active leads to a thickening of both crystalline lamellae and amorphous layers. The chains in the crystalline phase retain their high degree of orientation after annealing while the lamellae are sheared to a larger extent. In addition, there is also lateral growth of the crystalline lamellae during high-temperature annealing. Despite the structural changes of the crystalline and amorphous regions, there is no evidence for global chain relaxation. The global anisotropic shape of the chains is preserved even after prolonged annealing at high temperatures. The results indicate that the mobility of polyethylene chains-as seen, e.g., by 13C NMR-is a local phenomenon. The results also yield new insight into mechanical properties of drawn PE, especially regarding stress relaxation and creep mechanisms.