Surface Structure Dependent Activation of Hydrogen over Metal Oxides during Syngas Conversion

Despite the extensive studies on the adsorption and activation of hydrogen over metal oxides, it remains a challenge to investigate the structure-dependent activation of hydrogen and its selectivity mechanism in hydrogenation reactions. Herein we take spinel and solid solution MnGaOx with a similar bulk chemical composition and study the hydrogen activation mechanism and reactivity in syngas conversion. The results show that MnGaOx-Solid Solution (MnGaOx-SS) is a typical Mn-doped hexagonal close-packed (HCP) Ga2O3 with a Ga-rich surface. Upon exposure to hydrogen, Ga-H and O-H species are simultaneously generated. Ga-H species are highly active but unselective in CO activation, forming CHxO, and ethylene hydrogenation, forming ethane. In contrast, MnGaOx-Spinel is a face-centered-cubic (FCC) spinel phase featuring a Mn-rich surface, thus effectively suppressing the formation of Ga-H species. Interestingly, only part of the O-H species are active for CO activation while the O-H species are inert for olefin hydrogenation over MnGaOx-Spinel. Therefore, MnGaOx-Spinel exhibits a higher activity and higher light-olefin selectivity than MnGaOx-SS in combination with SAPO-18 during syngas conversion. These fundamental understandings are essential to guide the design and further optimization of metal oxide catalysts for selectivity control in hydrogenations.

Disentangling Local Interfacial Confinement and Remote Spillover Effects in Oxide-Oxide Interactions

Supported oxides are widely used in many important catalytic reactions, in which the interaction between the oxide catalyst and oxide support is critical but still remains elusive. Here, we construct a chemically bonded oxide-oxide interface by chemical deposition of Co3O4 onto ZnO powder (Co3O4/ZnO), in which complete reduction of Co3O4 to Co0 has been strongly impeded. It was revealed that the local interfacial confinement effect between Co oxide and the ZnO support helps to maintain a metastable CoOx state in CO2 hydrogenation reaction, producing 93% CO. In contrast, a physically contacted oxide-oxide interface was formed by mechanically mixing Co3O4 and ZnO powders (Co3O4-ZnO), in which reduction of Co3O4 to Co0 was significantly promoted, demonstrating a quick increase of CO2 conversion to 45% and a high selectivity toward CH4 (92%) in the CO2 hydrogenation reaction. This interface effect is ascribed to unusual remote spillover of dissociated hydrogen species from ZnO nanoparticles to the neighboring Co oxide nanoparticles. This work clearly illustrates the equally important but opposite local and remote effects at the oxide-oxide interfaces. The distinct oxide-oxide interactions contribute to many diverse interface phenomena in oxide-oxide catalytic systems.

Heterogeneous Hydrogenation with Hydrogen Spillover Enabled by Nitrogen Vacancies on Boron Nitride-Supported Pd Nanoparticles

Heterogeneous hydrogenation with hydrogen spillover has been demonstrated as an effective route to achieve high selectivity towards target products. More effort should be paid to understand the complicated correlation between the nature of supports and hydrogenation involving hydrogen spillover. Herein, we report the development of the hydrogenation system of hexagonal boron nitride (h-BN)-supported Pd nanoparticles for the hydrogenation of aldehydes/ketones to alcohols with hydrogen spillover. Nitrogen vacancies in h-BN determine the feasibility of hydrogen spillover from Pd to h-BN. The hydrogenation of aldehydes/ketones with hydrogen spillover from Pd proceeds on nitrogen vacancies on h-BN. The weak adsorption of alcohols to h-BN inhibits the deep hydrogenation of aldehydes/ketones, thus leading to high catalytic selectivity to alcohols. Moreover, the hydrogen spillover-based hydrogenation mechanism makes the catalyst system exhibit a high tolerance to CO poisoning.

Hydrogen Spillover-Enhanced Heterogeneously Catalyzed Hydrodeoxygenation for Biomass Upgrading

Hydrodeoxygenation (HDO) is regarded as a promising technology for biomass upgrading to obtain sustainable and competitive chemicals and fuels. In fact, biomass HDO over heterogeneous solid catalysts is often accompanied by the phenomenon of hydrogen spillover, which further affects the catalytic performance. Thus, it is necessary to gain in-depth understand the promoting effect of hydrogen spillover in the biomass HDO process to obtain desired conversion and selectivity. This Review summarized the extensive research on hydrogen spillover in biomass refining and discussed in detail the regulation mechanism of hydrogen spillover in biomass HDO process, mainly by regulating different active center sites on catalyst supports, such as metal sites, acid sites, surface functional groups, and defective sites, which exhibit independent and synergistic characteristics promoting catalyst activity, selectivity, and stability. Finally, the prospective of hydrogen spillover in biomass HDO applications was critically evaluated, and the key technical challenges in developing "hydrogen-free" HDO and upgrading biofuels were highlighted. The presentation of hydrogen spillover-enhanced catalytic biomass HDO in this Review will hopefully provide insight and guidance for further development of efficient catalysts and preparation of high-value chemicals in the future.

Recent advances in plasmon-enhanced Raman spectroscopy for catalytic reactions on bifunctional metallic nanostructures

Metallic nanostructures exhibit superior catalytic performance for diverse chemical reactions and the in-depth understanding of reaction mechanisms requires versatile characterization methods. Plasmon-enhanced Raman spectroscopy (PERS), including surface-enhanced Raman spectroscopy (SERS), shell-isolated nanoparticle-enhanced Raman spectroscopy (SHINERS), and tip-enhanced Raman spectroscopy (TERS), appears as a powerful technique to characterize the Raman fingerprint information of surface species with high chemical sensitivity and spatial resolution. To expand the range of catalytic reactions studied by PERS, catalytically active metals are integrated with plasmonic metals to produce bifunctional metallic nanostructures. In this minireview, we discuss the recent advances in PERS techniques to probe the chemical reactions catalysed by bifunctional metallic nanostructures. First, we introduce different architectures of these dual-functionality nanostructures. We then highlight the recent works using PERS to investigate important catalytic reactions as well as the electronic and catalytic properties of these nanostructures. Finally, we provide some perspectives for future PERS studies in this field.

Probing Single-Atom Catalysts and Catalytic Reaction Processes by Shell-Isolated Nanoparticle-Enhanced Raman Spectroscopy

Developing advanced characterization techniques for single-atom catalysts (SACs) is of great significance to identify their structural and catalytic properties. Raman spectroscopy can provide molecular structure information, and thus, the technique is a promising tool for catalysis. However, its application in SACs remains a great challenge because of its low sensitivity. We develop a highly sensitive strategy that achieves the characterization of the structure of SACs and in situ monitoring of the catalytic reaction processes on them by shell-isolated nanoparticle-enhanced Raman spectroscopy (SHINERS) for the first time. Using the strategy, Pd SACs on different supports were identified by Raman spectroscopy and the nucleation process of Pd species from single atoms to nanoparticles was revealed. Moreover, the catalytic reaction processes of the hydrogenation of nitro compounds on Pd SACs were monitored in situ, and molecular insights were obtained to uncover the unique catalytic properties of SACs. This work provides a new spectroscopic tool for the in situ study of SACs, especially at solid-liquid interfaces.