Precise Molecular‐Level Modification of Nafion with Bismuth Oxide Clusters for High‐performance Proton‐Exchange Membranes

Alcohol-Processable All-Polymer n-Type Thermoelectrics

The general strategy for n-type organic thermoelectric is to blend n-type conjugated polymer hosts with small molecule dopants. In this work, all-polymer n-type thermoelectric is reported by dissolving a novel n-type conjugated polymer and a polymer dopant, poly(ethyleneimine) (PEI), in alcohol solution, followed by spin-coating to give polymer host/polymer dopant blend film. To this end, an alcohol-soluble n-type conjugated polymer is developed by attaching polar and branched oligo (ethylene glycol) (OEG) side chains to a cyano-substituted poly(thiophene-alt-co-thiazole) main chain. The main chain results in the n-type property and the OEG side chain leads to the solubility in hexafluorineisopropanol (HFIP). In the polymer host/polymer dopant blend film, the Coulombic interaction between the dopant counterions and the negatively charged polymer chains is reduced and the ordered stacking of the polymer host is preserved. As a result, the polymer host/polymer dopant blend exhibits the power factor of 36.9 µW m-1 K-1, which is one time higher than that of the control polymer host/small molecule dopant blend. Moreover, the polymer host/polymer dopant blend shows much better thermal stability than the control polymer host/small molecule dopant blend. This research demonstrates the high performance and excellent stability of all-polymer n-type thermoelectric.

Effects of temperature on microstructures of MSA-type electroplating solution: a coarse-grained molecular dynamics simulation

In this study, we employ coarse-grained molecular dynamics simulations to explore the microstructure of MSA (methanesulfonic acid)-type electroplating solution, containing Sn(MSA)2 as the primary salt, MSA as the stabilizer, amphiphilic alkylphenol ethoxylate (APEO) as surfactants and cinnamaldehyde (CA) as the brightener agents, as well as water as the solvent. Our simulation indicates that temperature variations can significantly affect the structural properties of the electroplating solution and the adsorption behavior of its key components onto the substrate. Specifically, at low temperatures, the primary salt ions aggregate into ionic clusters, and the amphiphilic APEO surfactants and CA molecules form micelles composed of hydrophobic cores and hydrophilic shells, which reduces the uniformity of the solution and hinders the adsorption of ions, CA and surfactants onto the substrate. Appropriately increasing the temperature can weaken the aggregation of these components in bulk solution due to the accelerated molecular movements and arouse their adsorption. However, on further increasing the temperature, the elevated kinetic energy of the components thoroughly overwhelms the adsorption interactions, and therefore, the ions, surfactants, and CA desorb from the substrate and redissolve into the solution. We systematically analyze the complex interactions between these components at different temperatures and clarify the mechanism of the non-monotonic dependence of adsorption strength on the temperature at the molecular level. Our simulations demonstrate that there is low-temperature scope for reprocessing/recycling and intermediate-temperature scope for substrate-adsorptions of the key components. This study confers insights into a fundamental understanding of the microscopic mechanism for electroplating and can provide guidance for the development of precise electroplatings.

Development of High-Performance Polymer Electrolyte Membranes through the Application of Quantum Dot Coatings to Nafion Membranes

Proton exchange membrane water electrolysis (PEMWE) generates oxygen and hydrogen at the anode and cathode, respectively, by conducting protons generated at the anode to the cathode through a proton exchange membrane (PEM). The performance of PEMWE can be improved with faster catalytic reactions at each electrode; thus, the development of a PEM with excellent ionic conductivity and physicochemical stability is essential. Nafion, a type of perfluoro-sulfonic acid polymer, is the most widely used PEM material. However, despite its excellent conductivity and chemical stability, it exhibits high hydrogen permeability due to its structural characteristics. Quantum dots (QDs) have a hydrophilic functional group that can act as an ion conductor and are extremely compatible with the hydrophilic cluster of Nafion due to their characteristic nanosized structure. In this study, various compositions of N-doped carbon quantum dots (CQDs) containing hydrophilic functional groups were coated on a Nafion-212 membrane. The resulting series of CQD-coated Nafion membranes exhibited improvements in morphology and ionic conductivity as well as reductions in hydrogen permeability. In particular, the Nafion membrane coated with 0.75 wt % of N-doped CQD (CQD-cNafion-0.75) exhibited improved mechanical properties and higher oxidation stability compared to Nafion-212. It also displayed higher ionic conductivity of 240.3 mS cm^-1 at 80 °C and reduced hydrogen permeability (about 10% reduction) compared to Nafion-212. In addition, the performance of single-cell PEMWE using the CQD-cNafion-0.75 membrane was found to be approximately 1.2 times higher than Nafion-212.

Giant Water Uptake Enabled Ultrahigh Proton Conductivity of Graphdiyne Oxide

Proton conductors have attracted great attention in various fields, especially in energy production. Here, we find that graphdiyne oxide (GDYO), derived from graphdiyne (GDY), features the highest proton conductivity of 0.54 S cm^-1 (100 % RH, 348 K) among the oxidized carbon allotropes reported so far. The sp- and sp² -co-hybridized carbon skeleton of GDY enables GDYO with the giant water uptake, which is 2.4 times larger than that of graphene oxide (GO), resulting in ultrahigh proton conductivity by increasing the proton concentration and proton conduction pathways. This ultrahigh proton conductivity of GDYO is further proved in a methanol fuel cell by using GDYO membrane as proton exchange membrane. The GDYO membrane enables the cell with higher open circuit voltage, larger power density and lower methanol permeability, compared with commercial Nafion 117. Moreover, the GDYO membrane bears high ion exchange capacity, good acidic stability and low swelling ratio.

Design of Promising Green Cation-Exchange-Membranes-Based Sulfonated PVA and Doped with Nano Sulfated Zirconia for Direct Borohydride Fuel Cells

The direct borohydride fuel cell (DBFC) is a low-temperature fuel cell that requires the development of affordable price and efficient proton exchange membranes for commercial purposes. In this context, super-acidic sulfated zirconia (SO₄ZrO₂) was embedded into a cheap and environmentally friendly binary polymer blend, developed from poly(vinyl alcohol) (PVA) and iota carrageenan (IC). The percentage of SO₄ZrO₂ ranged between 1 and 7.5 wt.% in the polymeric matrix. The study findings revealed that the composite membranes’ physicochemical features improved by adding increasing amounts of SO₄ZrO₂. In addition, there was a decrease in the permeability and swelling ratio of the borohydride membranes as the SO₄ZrO₂ weight% increased. Interestingly, the power density increased to 76 mW cm⁻² at 150 mA cm⁻², with 7.5 wt.% SO₄ZrO_2, which is very close to that of Nafion117 (91 mW cm⁻²). This apparent selectivity, combined with the low cost of the eco-friendly fabricated membranes, points out that DBFC has promising future applications.

Integrating Highly Porous and Flexible Au Hydrogels with Soft-MEMS Technologies for High-Performance Wearable Biosensing

Wearable biosensors for real-time and non-invasive detection of biomarkers are of importance in early diagnosis and treatment of diseases. Herein, a high-performance wearable biosensing platform was proposed by combining a three-dimensional hierarchical porous Au hydrogel-enzyme electrode with high biocompatibility, activity, and flexibility and soft-MEMS technologies with high precision and capability of mass production. Using glucose oxidase as the model enzyme, the glucose sensor exhibits a sensitivity of 10.51 μA mM^-1 cm^-2, a long durability over 15 days, and a good selectivity. Under the mechanical deformation (0 to 90°), it is able to maintain an almost constant performance with a low deviation of <1.84%. With the assistance of a wireless or a Bluetooth module, this wearable sensing platform achieves real-time and non-invasive glucose monitoring on human skins. Similarly, continuous lactic acid monitoring was also realized with lactate oxidase immobilized on the same sensing platform, further verifying the universality of this sensing platform. Therefore, our work holds promise to provide a universal, high-performance wearable biosensing platform for various biomarkers in sweat and reliable diagnostic information for health management.

A supramolecular complex based on a Gd-containing polyoxometalate and food-borne peptide for MRI/CT imaging and NIR-triggered photothermal therapy

A multifunctional supramolecular complex is reported for the integrated multiple magnetic resonance imaging/computed X-ray tomography (MRI/CT) imaging and photothermal therapy, wherein a gadolinium-substituted paramagnetic polyoxometalate cluster and food-borne antioxidant peptides identified from the trepang protein hydrolysates are introduced. The as-prepared complex maintained an uniform particle size and much better biocompatibility, and is an ideal candidate for the in vivo applications. The complex allows for T1-weighted MR imaging and a high Hounsfield unit value for enhanced CT imaging. Interestingly, we demonstrate that the complex possesses outstanding photothermal cancer-killing effects due to its high photothermal conversion efficiency under the exposure of an NIR laser and enhanced antibacterial activity to avoid bacterial infection from the thermal therapeutic process. These results indicate that the supramolecular complex platform exhibit potential for accurate medical diagnosis at an early stage and effective eradication of the tumor cells.