A Selective and General Cobalt-Catalyzed Hydroaminomethylation of Olefins to Amines

Catalytic Dehydrogenation of Formic Acid Promoted by Triphos-Co Complexes: Two Competing Pathways for H2 Production

In this study, we reported the synthesis and structural characterization of a triphos-CoII complex [(κ3-triphos)CoII(CH3CN)2]2+ (1) and a triphos-CoI-H complex [(κ2-triphos)HCoI(CO)2] (4). The facile synthetic pathways from 1 to [(κ3-triphos)CoII(κ2-O2CH)]+ (1') and [(κ3-triphos)CoI(CH3CN)]+ (2), respectively, as well as the interconversion between [(κ3-triphos)CoI(CO)2]+ (3) and 4 have been established. The activation energy barrier, associated with the dehydrogenation of a coordinated formate fragment in 1' yielding the corresponding 2 accompanied by the formation of H2 and CO2, was experimentally determined as 23.9 kcal/mol. With 0.01 mol % loading of 1, a maximum TON ∼ 1735 within 18 h and TOF ∼ 483 h-1 for the first 3 h could be achieved. Kinetic isotope effect (KIE) values of 2.25 (kHCOOH/kDCOOH) and 1.36 (kHCOOH/kHCOOD) for the dehydrogenation of formic acid and its deuterated derivatives, respectively, implicate that the H-COOH bond cleavage is likely the rate-determining step. The catalytic mechanism proposed by density functional theory (DFT) calculations coupled with experimental 1H NMR and gas chromatography-mass spectrometry (GC-MS) analysis unveils two competing pathways for H2 production; specifically, deprotonating a HCOO-H bond by a proposed Co-H intermediate C and homolytic cleavage of the CoII-H moiety of C, presumably via a dimeric Co intermediate D containing a [Co2(μ-H)2]2+ core, to yield the corresponding 2 and H2.

Cobalt-catalyzed synthesis of amides from alkenes and amines promoted by light

Catalytic methods to couple alkene and amine feedstocks are valuable in synthetic chemistry. The direct carbonylative coupling of alkenes and amines holds promise as a perfectly atom-economical approach to amide synthesis, but general methods remain underdeveloped. Herein, we report an alkene hydroaminocarbonylation catalyzed by unmodified, inexpensive cobalt carbonyl under mild conditions and low pressure promoted by light. Silane addition after the reaction enables sequential cobalt-catalyzed amide reduction, constituting a formal alkene hydroaminomethylation. These methods exhibit exceptional scope across both alkene and amine components with high chemo- and regioselectivity and proceed efficiently even in the absence of solvent. The formation of a hydridocobalt through photodissociation of a carbonyl ligand is proposed to enable catalytic activity under mild conditions, which addresses a long-standing challenge in catalysis.

Structures and Oxidation Properties of Phenylene-Bridged Diazacycloalkanes: Ring Size Effects on Structures and Properties

Phenylenediamine derivatives have been investigated as functional molecules because of their characteristic oxidation properties. In this study, phenylene-bridged diazacycloalkanes, that is, C10, C12, and C14, in which numbers indicate the lengths of a side chain, were synthesized, and the effects of the macroring size on their structures and oxidation properties were investigated. X-ray crystallography revealed that the structures around the nitrogen atoms were remarkably dependent on the chain lengths. The benzene plane of C10 is arranged almost perpendicular to the macroring to avoid steric contact. However, the benzene plane of C14 and alkyl frame were co-planar. Stabilization resulting from conjugation was comparable to destabilization caused by macroring strain according to DFT calculations. Structural differences between C10 and C14 caused changes in the NMR chemical shifts of the inner methylene protons and first oxidation potentials in solution. Notably, the properties of C12 can be analyzed as those of distributed structures, which is of interest with respect to exploiting the metastable structure of the molecules. The observed relationships between the steric structures and properties can facilitate the design of functional molecules containing phenylenediamine moieties.

An Intramolecular Hydroaminomethylation-Based Approach to Pyrrolizidine Alkaloids under Microwave-Assisted Heating

A general method for the synthesis of pyrrolizidine derivatives using an intramolecular hydroaminomethylation protocol (HAM) under microwave (MW) dielectric heating is reported. Starting from a 3,4-bis(benzyloxy)-2-[(benzyloxy)methyl]-5-vinylpyrrolidine, MW-assisted intramolecular HAM in the presence of gaseous H2 and CO gave the natural alkaloid hyacinthacine A2 protected as benzyl ether. The same approach gave a lentiginosine analogue starting from the corresponding vinyl N-hydroxypyrrolidine. The nature of the reaction products and the yields were strongly influenced by the relative stereochemistry of the starting pyrrolidines, as well as by the catalyst/ligand employed. The use of ethanol as a solvent provides environmentally friendly conditions, while the ligand/catalyst system can be recovered by separating the alkaloid product with an SCX column and recycling the ethanolic solution. HAM worked up to three times with the recycled catalyst solution without any significant impact on yield.

Leveraging Electron‐Deficient Iminium Intermediates in a General Synthesis of Valuable Amines

The development of reactions converting alkenes and alkynes into valuable building blocks remains one of the main goals of synthetic chemistry. Herein, we present the leveraging of highly electron‐deficient iminium ions, rare and fleeting intermediates, into a general amine synthesis. This enables the preparation of amines bearing e.g. valuable α‐trifluoromethyl moieties under mild conditions. This broad concept is highlighted by the late‐stage amination of quinine into a biologically interesting new analogue.

Nutzung von elektronenarmen Iminiumintermediaten zur Synthese von wertvollen Aminen

Die Entwicklung von Reaktionen zur Umwandlung von Alkenen und Alkinen in wertvolle Bausteine ist nach wie vor eines der Hauptziele in der synthetischen Chemie. In dieser Arbeit berichten wir von der Nutzbarmachung von stark elektronenarmen, seltenen und kurzlebigen Iminiumionen zur Synthese von Aminen. Dies ermöglicht die milde Herstellung von Aminen mit z. B. trifluormethylierten Einheiten. Dieses umfassende Konzept wird durch die Aminierung von Chinin zu einem biologisch interessanten neuen Analogon verdeutlicht.