Shape‐controlled synthesis of cerium oxide nanoparticles for efficient dye photodegradation and antibacterial activities

Facile stoichiometric interfacial surface bonded cerium oxide and graphene oxide heterostructure for efficient electrochemical non-enzymatic detection of dopamine

Emerging technology in the new era of sensors to detect and quantify neurological reaction-based research has demanded the development of sensors for the neurotransmitter dopamine (DA). In recent decades, electrochemical sensors have offered rapid and sensitive detection of DA, but the presence of interfering compounds, such as uric acid (UA) and ascorbic acid (AA), poses a great threat to the development of DA sensors. Additionally, reusing traditional methods leads to challenges like prolonged preparation and expensive instruments. This research work offers a nanohybrid two-dimensional (2D) paper-like graphene oxide (GO) and three-dimensional (3D) cerium oxide nanosphere (CeONS) heterostructure composite (G-CeONS) created via stoichiometric synthesis for the non-enzymatic detection of DA oxidation in the presence of other complex biological compounds. The constructed G-CeONS nanohybrid composite enables enhanced selectivity and sensitivity towards DA detection through its interfacial engineering. The heterostructure formation of a 2D nanosheet draped over 3D nanospheres exhibits a wide linear concentration range of 100-30 800 nM with a low detection limit of 20.98 nM. Further investigation of the real-time performance on human saliva and DA injections afforded prominent results. In addition, the synergetic effect of G-CeONS improves DA detection accuracy and reliability towards enabling transformational neurochemical and medicinal applications.

Antibacterial and sunlight-driven photocatalytic activity of graphene oxide conjugated CeO2 nanoparticles

This work focuses on the structural, morphological, optical, photocatalytic, antibacterial properties of pure CeO2 nanoparticles (NPs) and graphene oxide (GO) based CeO2 nanocomposites (GO-1/CeO2, GO-5/CeO2, GO-10/CeO2, GO-15/CeO2), synthesized using the sol-gel auto-combustion and subsequent sonication method, respectively. The single-phase cubic structure of CeO2 NPs was confirmed by Rietveld refined XRD, HRTEM, FTIR and Raman spectroscopy. The average crystallite size was calculated using Debye Scherrer formula and found to increase from 20 to 25 nm for CeO2 to GO-15/CeO2 samples, respectively. The related functional groups were observed from Fourier transform infrared (FTIR) spectroscopy, consistent with the outcomes of Raman spectroscopy. The optical band gap of each sample was calculated by using a Tauc plot, which was observed to decrease from 2.8 to 1.68 eV. The valence state of Ce (Ce3+ and Ce4+) was verified using X-ray photoelectron spectroscopy (XPS) for CeO2 and GO-10/CeO2. The poisonous methylene blue (MB) dye was used to evaluate the photocatalytic activity of each sample in direct sunlight. The GO-15/CeO2 nanocomposite showed the highest photocatalytic activity with rate constant (0.01633 min-1), and it degraded the MB dye molecules by 100% within 120 min. The high photocatalytic activity of this material for degrading MB dye establishes it as an outstanding candidate for wastewater treatment. Further, these nanocomposites also demonstrated excellent antimicrobial activity against Pseudomonas aeruginosa PAO1.

Ultrasmall cerium oxide nanoparticles as highly sensitive X-ray contrast agents and their antioxidant effect

Owing to their theranostic properties, cerium oxide (CeO2) nanoparticles have attracted considerable attention for their key applications in nanomedicine. In this study, ultrasmall CeO2 nanoparticles (particle diameter = 1-3 nm) as X-ray contrast agents with an antioxidant effect were investigated for the first time. The nanoparticles were coated with hydrophilic and biocompatible poly(acrylic acid) (PAA) and poly(acrylic acid-co-maleic acid) (PAAMA) to ensure satisfactory colloidal stability in aqueous media and low cellular toxicity. The synthesized nanoparticles were characterized using high-resolution transmission electron microscopy, X-ray diffraction, Fourier transform-infrared spectroscopy, thermogravimetric analysis, dynamic light scattering, cell viability assay, photoluminescence spectroscopy, and X-ray computed tomography (CT). Their potential as X-ray contrast agents was demonstrated by measuring phantom images and in vivo CT images in mice injected intravenously and intraperitoneally. The X-ray attenuation of these nanoparticles was greater than that of the commercial X-ray contrast agent Ultravist and those of larger CeO2 nanoparticles reported previously. In addition, they exhibited an antioxidant effect for the removal of hydrogen peroxide. The results confirmed that the PAA- and PAAMA-coated ultrasmall CeO2 nanoparticles demonstrate potential as highly sensitive radioprotective or theranostic X-ray contrast agents.

Efficient Photocatalytic Degradation of Methylene Blue Dye from Aqueous Solution with Cerium Oxide Nanoparticles and Graphene Oxide-Doped Polyacrylamide

A cerium oxide nanoparticles (CeO₂-NPs)/graphene oxide (GO)/polyacrylamide (PAM) ternary composite was synthesized through free-radical polymerization of acrylamide in the presence of CeO₂ nanoparticles and GO in an aqueous system. The synthesized composite material was characterized by X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, scanning electron microscopy (SEM), and energy-dispersive X-ray (EDX) spectroscopy techniques and applied for the photocatalytic degradation of methylene blue (MB) dye from an aqueous solution. Tauc's model for direct transition was used to model for the optical band gap. The key operating parameters such as the amounts of CeO₂-NPs and GO, pH, initial MB concentration, type of light irradiation, and contact time have been optimized to achieve the highest MB degradation percentage. The photocatalysis process was pH-dependent, and the optimum pH value was found to be 12.0. Under UV-A light, 90% dye degradation occurred in 90 min. The degradation of MB was also specified in terms of total organic carbon (TOC) and chemical oxygen demand (COD). Free-radical capture experiments were also performed to determine the role of radical species during the photocatalytic oxidation process. The photocatalytic process showed that the equilibrium data is in good agreement with the Langmuir-Hinshelwood kinetic model. A rate constant of 0.0259 min^-1 was obtained. The hydrogel was also tested to assess its reusability, which is an important key factor in practical wastewater treatment. The photocatalytic activity only decreased to 75% after nine uses.

Recent advances in biodecolorization and biodegradation of environmental threatening textile finishing dyes

Organic nature of dyes and their commercially made products are widely utilized in many industries including paper, cosmetics, pharmaceuticals, photography, petroleum as well as in textile manufacturing. The textile industry being the top most consumer of a large variety of dyes during various unit processes operation generates substantial amount of wastewater; hence, nominated as "Major Polluter of Potable Water". The direct discharge of such effluents into environment poses serious threats to the functioning of biotic communities of natural ecosystems. The detection of these synthetic dyes is considered as relatively easy, however, it is extremely difficult to completely eliminate them from wastewater and freshwater ecosystems. Aromatic chemical structure seems to be the main reason behind low biodegradability of these dyes. Currently, various physiochemical and biological methods are employed for their remediation. Among them, microbial degradation has attracted greater attention due to its sustainability, high efficiency, cost effectiveness, and eco-friendly nature. The current review presents recent advances in biodegradation of industrial dyes towards a sustainable and tangible technological innovative solutions as an alternative to existing conventional physicochemical treatment processes.

Thermally induced oxygen related defects in eco-friendly ZnFe2O4 nanoparticles for enhanced wastewater treatment efficiencies

Herein, a simple but highly effective strategy of thermal annealing to modulate oxygen vacancies related defects in ZnFe₂O₄ (ZFO) nanoparticles for obtaining enhanced wastewater treatment efficiencies is reported. The as-prepared nanoparticles were thermally annealed at three different temperatures (500 °C, 600 °C and 700 °C) and their phase purity was confirmed by X-ray diffraction (XRD). All samples were found to exhibit pure phases of ZFO with different crystallite sizes ranging from 10 nm to 25 nm. The transmission electron microscope (TEM) images showed well dispersed nanoparticles and a strong correlation of grain size growth with annealing temperature was established. The optical absorption and emission characteristics were estimated through UV-visible and Photoluminescence (PL) spectroscopy. Raman spectroscopy and X-ray Photoelectron Spectroscopy (XPS) confirmed the variation of oxygen vacancies in the synthesized samples' lattice. The photocatalytic activities of all samples were investigated and the highest efficiencies were recorded for the ZFO samples annealed at 500 °C. Under high salinity condition, the organic dye degradation efficiency of the same sample remained the highest among all. The excellent dye degradation abilities in ZFO samples can be attributed to the abundance of oxygen vacancies in the crystal lattice that slow down the recombination rate during the photocatalysis process. Moreover, cytotoxicity tests revealed that all prepared ZFO samples showed insignificant cell structure effects on Picochlorum sp microalgae, as verified by Fourier-transform infrared (FTIR) spectroscopy. On the other hand, no significant changes were detected on the viable cell concentration and Chlorophyll a content. This work presents a systematic way to finely tune the crystal sizes and to modulate oxygen related defects in ZFO through a highly effective annealing approach to signify their potential in industrial wastewater and seawater treatment processes.

Investigation of operation parameters on the removal efficiency of methyl orange pollutant by cellulose/zinc oxide hybrid aerogel

In this study, Cellulose/Zinc Oxide-x (CA/ZnO-x) hybrid aerogel with various concentrations of Zn²⁺ ion is synthesized through the hydrothermal method and used for organic pollutant removal. The CA/ZnO-x hybrid aerogel was characterized by XRD, UV-Visible, DRS, FTIR, FESEM, EDS, BET, LC-MS-MS analyses. In the present study, CA/ZnO-x hybrid aerogel as photocatalyst was used to investigate the influence of the photocatalytic degradation of methyl orange (MO) from an aqueous solution under UV irradiation. The morphology of CA/ZnO-x hybrid aerogels exhibited that the ZnO rice grain-like shape were successfully synthesized on the cellulose aerogel matrix. Also, the influence of various factors such as photocatalyst dosage, pH, initial concentration of MO, and irradiation intensity was investigated on the photocatalytic degradation rate of MO. The results revealed that the highest degradation efficiency and mineralization rate of MO were about 99.02% and 51.68%, respectively, after 90 min under UV irradiation using CA/ZnO-0.4 photocatalyst when pH = 3, C₀ = 10 ppm, photocatalyst dose = 9 g L^-1 under the 300 W UV light irradiation. Furthermore, the synthesized photocatalyst exhibited a considerable firmness and easily separated from an aqueous solution for reuse.

An Insight into Geometries and Catalytic Applications of CeO2 from a DFT Outlook

Rare earth metal oxides (REMOs) have gained considerable attention in recent years owing to their distinctive properties and potential applications in electronic devices and catalysts. Particularly, cerium dioxide (CeO2), also known as ceria, has emerged as an interesting material in a wide variety of industrial, technological, and medical applications. Ceria can be synthesized with various morphologies, including rods, cubes, wires, tubes, and spheres. This comprehensive review offers valuable perceptions into the crystal structure, fundamental properties, and reaction mechanisms that govern the well-established surface-assisted reactions over ceria. The activity, selectivity, and stability of ceria, either as a stand-alone catalyst or as supports for other metals, are frequently ascribed to its strong interactions with the adsorbates and its facile redox cycle. Doping of ceria with transition metals is a common strategy to modify the characteristics and to fine-tune its reactive properties. DFT-derived chemical mechanisms are surveyed and presented in light of pertinent experimental findings. Finally, the effect of surface termination on catalysis by ceria is also highlighted.